An automated system for CE-MALDI and on-target digestion under a fluorocarbon lid applied on spermatophore proteins from Pieris napi.

A method for off-line CE-MALDI-TOF-MS and MS2, and on-target digestion under a fluorocarbon lid was developed and applied for the analysis of proteins in the spermatophore of the butterfly Pieris napi. Fractionation revealed many peptides otherwise not detected or resolved. Automated fractionation was performed with an in-lab developed robotic system, and automated on-target tryptic digestion under a fluorocarbon lid was demonstrated with the same system. Fractionation onto a pre-structured MALDI-concentration plate facilitated aligned deposition of trypsin and MALDI-matrix with the deposited sample, also under the fluorocarbon lid. Some indications of indigenous proteolysis of spermatophore proteins were seen, and searching MS2 spectra suggested three tentative sequence homologies to P. rapae. The study demonstrates the functionality of the lab-made robot. Detailed manufacturing instructions and code are provided. The feasibility of automated on-target digestion under a fluorocarbon lid, and the usefulness of a structured concentration plate in CE-MALDI fractionation was shown. Further, it constitutes a preliminary study of P. napi spermatophore proteins.

Simple and Environmentally Friendly Fabrication of Superhydrophobic Alkyl Ketene Dimer Coated MALDI Concentration Plates.

Here we present a method to manufacture peptide-concentrating MALDI-plates with alkyl ketene dimer (AKD) as a new superhydrophobic coating. The fabrication of the hydrophobic plates included application of AKD by airbrush, and negative contact printing to generate the concentration sites. Deposited sample droplets were contained within the prestructured sites, and self-adjusted onto the site if slightly misplaced. No AKD contamination was observed, and the plates could easily be cleaned and regenerated. The S/N values for four model peptides was about twice as high compared with a standard steel plate and a commercial concentration plate. Graphical Abstract ᅟ.

Microfluidic Isoelectric Focusing of Amyloid Beta Peptides Followed by Micropillar-Matrix-Assisted Laser Desorption Ionization-Mass Spectrometry.

A novel method for preconcentration and purification of the Alzheimer's disease related amyloid beta (Aß) peptides by isoelectric focusing (IEF) in 75 nL microchannels combined with their analysis by micropillar-matrix-assisted laser desorption ionization-time-of-flight-mass spectrometry (MALDI-TOF-MS) is presented. A semiopen chip-based setup, consisting of open microchannels covered by a lid of a liquid fluorocarbon, was used. IEF was performed in a mixture of four small and chemically well-defined amphoteric carriers, glutamic acid, aspartyl-histidine (Asp-His), cycloserine (cSer), and arginine, which provided a stepwise pH gradient tailored for focusing of the C-terminal Aß peptides with a pI of 5.3 in the boundary between cSer and Asp-His. Information about the focusing dynamics and location of the foci of Aß peptides and other compounds was obtained using computer simulation and by performing MALDI-MS analysis directly from the open microchannel. With the established configuration, detection was performed by direct sampling of a nanoliter volume containing the focused Aß peptides from the microchannel, followed by deposition of this volume onto a chip with micropillar MALDI targets. In addition to purification, IEF preconcentration provides at least a 10-fold increase of the MALDI-MS-signal. After immunoprecipitation and concentration of the eluate in the microchannel, IEF-micropillar-MALDI-MS is demonstrated to be a suitable platform for detection of Aß peptides in human cerebrospinal fluid as well as in blood plasma.

Mass spectrometric analysis of nanoscale sample volumes extracted from open microchannels after sample preconcentration applied on amyloid beta peptides.

A new instrumental concept for extraction of nanovolumes from open microchannels (dimensions 150 µm × 50 µm, length 10 mm) manufactured on silicon microchips has been used in combination with a previously developed method for preconcentrating proteins and peptides in the open channels through electromigration. The extracted nanovolumes were further analyzed using nanoelectrospray ionization (nESI) or matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS) directly or with subsequent enzymatic protein digestion in a nanodroplet prior to the MS analysis. Preconcentration of the samples resulted in a 15-fold sensitivity increase in nESI for a neurotensin solution, and using MALDI-MS, amyloid beta (Aß) peptides could be detected in concentrations down to 1 nM. The method was also successfully applied for detection of cell culture Aß.

Determination of fluoroquinolones in bovine milk samples using a pipette-tip SPE step based on multiwalled carbon nanotubes prior to CE separation.

A simple CE-UV method was developed for the simultaneous determination of ciprofloxacin, norfloxacin, and ofloxacin in milk samples. The optimum separation was obtained using a 20 mM ammonium dihydrogenphosphate solution with 2 mM cetyltrimethylammonium bromide at pH 3.0 as the BGE. Satisfactory resolution for structurally very similar analytes, like norfloxacin and ciprofloxacin, was achieved without including any organic solvent. Milk samples were prepared using a simple/extraction procedure based on acidic protein precipitation followed by an SPE step using only 5 mg of multiwalled carbon nanotubes as the sorbent material. The LODs for the three compounds were between 7.5 and 11.6 µg/L and the RSDs for the peak areas were between 2.6 and 4.9%. The complete method was applied to spiked real milk samples with satisfactory recoveries for all analytes (84-106%).

CE analysis of single wood cells performing hydrolysis and preconcentration in open microchannels.

In the present work, monosaccharides from pulp samples and single wood fibers were analyzed with CE, using indirect detection due to the lack of chromophores on the monosaccharides. The hydrolysis degradation of cellulose and hemicellulose into monosaccharides was performed using TFA, either in bulk scale or in microscale. In the microscale, one single wood fiber was hydrolyzed in an open microchannel manufactured on a silicon microchip with the dimensions 50 µm × 50 µm (length 1 or 3 cm). The low monosaccharide amounts derived from a single fiber implied that a preconcentration step was necessary to increase the detectability. Thus, an electromigration preconcentration of the hydrolyzed samples was performed within the microchannel, which resulted in a significantly enhanced signal intensity of the monosaccharides. In addition to the experimental study, computer simulations were performed regarding the preconcentration step of monosaccharides. The results from these simulations correlated well with the experimental results.

Sample preconcentration in open microchannels combined with MALDI-MS.

In this work, a method for preconcentrating samples in 1 cm long, 50-150 µm wide open microchannels is presented. Platinum electrodes were positioned at the channel ends, voltage was applied, and charged analyte was preconcentrated at the oppositely charged side during continuous supply of sample. The preconcentration was initially studied in a closed system, where an influence on the analyte position from a pH gradient, generated by water electrolysis, was observed. In the open channel, the analyte distribution after preconcentration was evaluated using MALDI-MS with the channel as MALDI target. MALDI matrix was applied with an airbrush or by electrospray matrix deposition and by using the latter technique higher degrees of crystallization in the channels were obtained. After preconcentrating a 1 nM cytochrome c solution for 5 min, corresponding to a supplied amount of 1.25 fmol, a signal on the cathodic channel end could be detected. When a solution of cytochrome c trypsin digest was supplied, the peptides were preconcentrated at different positions along the channel depending on their charge.

Evaluation of 2,6-dihydroxyacetophenone as matrix-assisted laser desorption/ionization matrix for analysis of hydrophobic proteins and peptides.

Matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS) is widely used for analysis of macromolecules like peptides and proteins. The analysis procedure is generally simple but must be adapted to the characteristics of the analytes. Therefore, specific matrices suitable for, e.g., hydrophobic proteins and peptides that are difficult to analyze would be preferable in order to optimize the outcome. In the present work, 2,6-dihydroxyacetophenone (DHAP) was shown to be beneficial in comparison to DHB for intact bacteriorhodopsin (BR) as well as for chemically digested BR.

Capillary electrophoresis separation and matrix-assisted laser desorption/ionization mass spectrometry characterization of bovine serum albumin-fluorescein isothiocyanate conjugates.

A protocol using enzymatic digestion, matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF-MS) and capillary electrophoresis with laser induced fluorescence detection (CE-LIF) for the investigation of the binding of the fluorescent contact allergen fluorescein isothiocyanate (FITC) to the 66 kDa large protein bovine serum albumin (BSA), as a model system for protein-hapten binding in the skin, is presented. Mass spectra of BSA-FITC digestions, using trypsin and chymotrypsin, respectively, provided sequence coverage of 97%. To investigate the number of FITC-bound peptides using CE-LIF separation, three different buffer salts at four different pH levels were evaluated. The use of 20 mM sodium citrate pH 6.5 as well as 20 mM sodium phosphate pH 6.5 or pH 7.5 as background electrolyte revealed high numbers of peptides with at least one bound FITC. The effect of the electrolyte counter ion on MALDI-MS was investigated and was found to have effect on the MALDI spectra signal-to-noise (S/N) at 50 mM but not at 10 mM. Of the 60 theoretical FITC-binding sites in BSA this MALDI-MS protocol presents 30 defined, 28 possible and 2 non-binding sites for FITC.

Electrospray ionization from an adjustable gap between two silicon chips.

In this paper, a silicon chip-based electrospray emitter with a variable orifice size is presented. The device consists of two chips, with a thin beam elevating from the center of each of the chips. The chips are individually mounted to form an open gap of a narrow, uniform width between the top areas of the beams. The electrospray is generated at the endpoint of the gap, where the spray point is formed by the very sharp intersection between the crystal planes of the <100> silicon chips. Sample solution is applied to the rear end of the gap from a capillary via a liquid bridge, and capillary forces ensure a spontaneous imbibition of the gap. The sample solution is confined to the gap by means of a hydrophobic treatment of the surfaces surrounding the gap, as well as the geometrical boundaries formed by the edges of the gap walls. The gap width could be adjusted between 1 and 25 microm during electrospray experiments without suffering from any interruption of the electrospray process. Using a peptide sample solution, a shift toward higher charge states and increased signal-to-noise ratios was observed when the gap width was decreased. The limit of detection for the peptide insulin (chain B, oxidized) was approximately 4 nM. We also show a successful interfacing of the electrospray setup with capillary electrophoresis.

Off-line integration of CE and MALDI-MS using a closed-open-closed microchannel system.

In this work, a new technique for off-line hyphenation between CE and MALDI-MS is presented. Two closed fused-silica capillaries were connected via a silicon chip comprising an open microcanal. The EOF in the system was evaluated using mesityloxide or leucine-enkephalin as a sample and with a running buffer that rendered the analyte neutrally charged. Comparison was made between the EOF in a closed system (first capillary solely included in the electrical circuit) and in a closed-open system (first capillary and microcanal included in the electrical circuit). It was concluded that the experimental values of the EOF agreed with the theory. The influence of the capillary outer diameter on the peak dispersion was investigated using a closed-open-closed system (first capillary, microcanal and second capillary included in the electrical circuit). It was clearly seen that a capillary with 375 microm od induced considerably higher peak dispersion than a 150 microm od capillary, due to a larger liquid dead volume in the connection between the first capillary outlet and the microcanal. Mass spectrometric analysis has also been performed following CE separation runs in a closed-open-closed system with cytochrome c and lysozyme as model proteins. It was demonstrated that a signal distribution profile of the separated analytes could be recorded over a 30 mm long microcanal.

Capillary electrophoretic separation and fractionation of hydrophobic peptides onto a pre-structured matrix assisted laser desorption/ ionization target for mass spectrometric analysis.

A CE separation of hydrophobic peptides followed by fractionation onto a prestructured MALDI target and off-line MS analysis was performed. An improved and partially automated manufacturing procedure of the previously described MALDI target is presented. This target is structurally coated with silicone and especially developed for hydrophobic peptides and proteins. Here, the target plate was designed specifically for the CE fraction collection. Different solvents were evaluated to meet the requirements of peptide solubility and compatibility to both the CE and MALDI methods and to the fractionation procedure. CE-MALDI-MS analysis of nine highly hydrophobic peptides from cyanogen bromide-digested bacteriorhodopsin is demonstrated.