Mask and plate: a scalable front metallization with low-cost potential for III-V-based tandem solar cells enabling 31.6 % conversion efficiency.

Low-cost approaches for mass production of III-V-based photovoltaics are highly desired today. For the first time, this work presents industrially relevant mask and plate for front metallization of III-V-based solar cells replacing expensive photolithography. Metal contacts are fabricated by nickel (Ni) electroplating directly onto the solar cell's front using a precisely structured mask. Inkjet printing offers low-cost and high-precision processing for application of an appropriate plating resist. It covers the solar cell's front side with narrow openings for subsequent electroplating. The width of the resulting Ni contacts is as low as (10.5 ± 0.8) µm with sharp edges and homogenous shape. The 4 cm2-sized champion III-V-on-silicon triple-junction solar cell with mask and plate front metallization reaches a certified conversion efficiency η of (31.6 ± 1.1) % (AM1.5 g spectrum). It performs just as well as the reference sample with photolithography-structured evaporated front contacts, which reaches η = (31.4 ± 1.1) %.

High-Frequency Rheological and Piezo-Voltage Waveform Characterization of Inkjet-Printed Polymer-Based Dopant-Source Inks.

This work focuses on developing an understanding of the rheological properties of polymer-based dopant-source inks at the timescales relevant to inkjet printing and their corresponding roles in determining the production of defect-free droplets. Ink-specific optimization of printing processes for phosphorus and boron dopant-source inks with different compositions is demonstrated. Rheological flow curves measured by a piezo axial vibrator (PAV) were used to study the changes in complex viscosity (η*) and in the elastic (G') and viscous (G″) components of the shear modulus (G*) with respect to changes in frequency (from fmin = 1 kHz to fmax = 10 kHz) to obtain an insight into the high-frequency behaviour of inks, as well as the effects of temperature (25 °C and 45 °C) and the natural aging time of the inks. Inks demonstrating complex viscosity η*min ≥ 2 mPas to η*max ≤ 20 mPas and an elastic modulus G' ≤ 20 Pa, produced droplets with negligible defects. Of the three rheological parameters (η*, G' and G″), the elastic component (G') of the shear modulus was observed to have the greatest significance in determining the stability and homogeneity of ink droplets, thus dictating the quality of the printed structures. The reliability and stability of droplet formation were further investigated through voltage waveform simulation using an oscilloscope.