Computer-assisted optimization and validation of LC analysis of trimetazidine dihydrochloride and its impurities.

Trimetazidine dihydrochloride is an anti-anginal drug, which possesses protective properties against ischemia inducing heart damage. In this paper, a new procedure for liquid chromatographic analysis was successfully developed, optimized, and applied in assessment of trimetazidine dihydrochloride content and its impurities, Y-145, Y-235, and Y-234 at most 1.0%, 0.2%, and 0.2%, respectively, in commercially available pharmaceutical preparation containing 35 mg of trimetazidine dihydrochloride. The retention behavior of trimetazidine dihydrochloride and its impurities is investigated by using several stationary and mobile phases to settle a simple, sensitive, and precise RP-HPLC method. The separation conditions are optimized by DryLab 2000 Plus Chromatography Optimization Software version 3.5.00. Separations are performed on PurospherSTAR RP18 endcapped (150 x 4.6 mm, 5 microm particle size) column at 20 degrees C with UV detection at 210 nm. The mobile phase composition is acetonitrile-aqueous phase (10 mmol/L disodium hydrogenphosphate and 2 mmol/L sodium dihydrogen phosphate, pH 7.6) (30:70 v/v). Afterwards, the method is validated; the important statistical parameters for selectivity/specificity, linearity, precision, limit of detection, and quantitation are defined. The recovery value of the trimetazidine dihydrochloride is 98.06%, and the content of impurities is 0.23% for Y-145, less than 0.02% for Y-235, and less than 0.01% for Y-234. In addition, this method is used for analyzing trimetazidine dihydrochloride and its impurities in pharmaceuticals and bulk drug.

Retention modelling in liquid chromatographic separation of simvastatin and six impurities using a microemulsion as eluent.

A novel and unique approach was used for retention modelling in the separation of simvastatin and six impurities by liquid chromatographic using a microemulsion as mobile phase. A microemulsion is a modification of a micellar system where a lipophilic organic solvent is dissolved in the micelles; for that reason, microemulsions are usually treated as solvent-modified micellar solutions. When microemulsions are used as eluents in HPLC separations, solutes partition between the charged oil droplets and the aqueous buffer phase. The complexity of the composition of the microemulsion permits extensive manipulations to be made during method development in order to achieve acceptable resolution of such a complex mixture of substances. In order to avoid a laborious "trial and error" procedure, a 2(3) full factorial design was applied for choosing an optimal microemulsion composition to obtain good separation in a reasonable run time. Organic solvent, sodium dodecyl sulphate, and n-butanol content were varied within defined experimental domain. Optimal conditions for the separation of simvastatin and its six impurities were obtained using an X Terra 50 x 4.6 mm, 3.5 microm particle size column at 30 degrees C. The mobile phase consisted of 0.9% w/w of diisopropyl ether, 2.2% w/w of sodium dodecylsulphate (SDS), 7.0% w/w of co-surfactant such as n-butanol, and 89.9% w/w of aqueous 25 mM disodium phosphate pH 7.0.