Through-and-through cystic lesion: spontaneous healing after needle aspiration and conventional root-canal therapy / Tunnelierende zystische Läsion: Spontanheilung nach Aspiration und Wurzelkanalbehandlung

Inflammation-related pathologies such as apical periodontitis or radicular cysts are frequent lesions of the jawbones. Typically, a radiolucency is present that is not always distinguishable from other pathologies. A surgical approach would allow for tissue harvesting with further histopathologic processing. However, in the present case report of a cystic and large tunnelling lesion in the anterior maxilla, a conservative treatment with diagnostic needle aspiration and subsequent root-canal therapy was chosen. The long-term follow-up (eight years) including cone-beam computed tomography demonstrates a complete healing of the former bone defect with reestablishment of the vestibular and palatal cortices as well as absence of pain and other clinical symptoms.

SADMFR Guidelines for the Use of Cone-Beam Computed Tomography/Digital Volume Tomography.

In 2011, the first consensus conference on guidelines for the use of cone-beam computed tomography (CBCT) was convened by the Swiss Society of Dentomaxillofacial Radiology (SGDMFR). This conference covered topics of oral and maxillofacial surgery, temporomandibular joint dysfunctions and disorders, and orthodontics. In 2014, a second consensus conference was convened on guidelines for the use of CBCT in endodontics, periodontology, reconstructive dentistry and pediatric dentistry. The guidelines are intended for all dentists in order to facilitate the decision as to when the use of CBCT is justified. As a rule, the use of CBCT is considered restrictive, since radiation protection reasons do not allow its routine use. CBCT should therefore be reserved for complex cases where its application can be expected to provide further information that is relevant to the choice of therapy. In periodontology, sufficient information is usually available from clinical examination and periapical radiographs; in endodontics alternative methods can often be used instead of CBCT; and for implant patients undergoing reconstructive dentistry, CT is of interest for the workflow from implant planning to the superstructure. For pediatric dentistry no application of CBCT is seen for caries diagnosis.

[Cone beam computed tomography in endodontics: a review for daily clinical practice]. / Die digitale Volumentomographie in der Endodontologie. Eine Übersicht für den Praxisalltag.

Since the introduction of cone beam computed tomography (CBCT), this 3-dimensional diagnostic imaging technique has been established in a growing number of fields in dental medicine. It has become an important tool for both diagnosis and treatment planning, and is also able to support endodontic treatments. However, the higher effective dose of ionizing radiation compared to conventional 2-dimensional radiographs is not justifiable in every case. CBCT allows for a more precise diagnosis of periapical lesions, root fractures as well as external and internal resorptions. Concerning the utility of CBCT in treatment planning decisions, the gain of information through 3-dimensional imaging for any of these pathologies has to be evaluated carefully on an individual basis. Moreover, radioopaque materials such as root canal filling and posts often create artefacts, which may compromise diagnosis. The aim of this review is to summarize the possibilities and limits of CBCT imaging in endodontology as well as introduce guidelines for daily clinical practice. Furthermore, the article presents possible therapeutic advantages of preexisting CBCT scans for root canal treatments.

Endodontic working length measurement with preexisting cone-beam computed tomography scanning: a prospective, controlled clinical study.

INTRODUCTION: The determination of root canal length is a significant outcome predictor for endodontic treatments. The aim of this prospective, controlled clinical study was to analyze endodontic working length measurements in preexisting cone-beam computed tomography (CBCT) scans and to compare them with clinical root canal length determination by using an electronic apex locator (EAL). METHODS: All included patients had received a CBCT scan independent of the present study and needed root canal treatment of at least 1 anterior tooth visible in the field of view. Clinically, the root canal length was measured with an EAL by an endodontist. This measurement was compared with the root canal length as measured on vestibulo-oral and mesiodistal CBCT sections by an examiner not involved in the endodontic treatment. The CBCT measurements were repeated once for analysis of intrarater reliability. RESULTS: Forty anterior teeth in 30 patients (13 women and 17 men; average age, 44 years; range, 18-80 years) were included in this investigation. The Pearson correlation coefficient (r) comparing the root canal length measurements by using CBCT and EAL was 0.97. In addition, high intrarater reliability for the CBCT measurements was found (r = 0.99). CONCLUSIONS: This prospective, controlled clinical study showed that limited CBCT scans can be used for endodontic working length measurements. Future studies are needed to evaluate whether preexisting CBCT scans could replace initial periapical radiographs and working length periapical radiographs.

Precision of endodontic working length measurements: a pilot investigation comparing cone-beam computed tomography scanning with standard measurement techniques.

INTRODUCTION: The objective of this pilot investigation was to evaluate the utility and precision of already existing limited cone-beam computed tomography (CBCT) scans in measuring the endodontic working length, and to compare it with standard clinical procedures. METHODS: Three patients referred to the department received limited CBCT scans for diagnostics and preoperative treatment planning of cystic jawbone pathologies. Part of the therapy consisted of root canal treatments before surgical enucleation of the lesion. For the determination of the working length, the root canal length was measured with an electronic apex locator (EAL) by the endodontist. This measurement was compared with the root canal length as measured on the respective CBCT scans by an examiner not involved in the endodontic treatment. The interrater agreement between the two examiners was analyzed to determine the feasibility of this technique. RESULTS: In the three included patients, 9 teeth with a total of 10 root canals were treated. For these canals, a strong correlation was found between the endodontic working length as measured in the CBCT images and the EAL measurements (Pearson correlation coefficient ranging from 0.904 to 0.968). CONCLUSIONS: Based on the present findings, an already existing CBCT scan of teeth to be endodontically treated can be useful to determine the endodontic working length in combination with clinical measurements such as the EAL. Future prospective studies should evaluate if and when intraoral radiography for measuring the length of root canals can be avoided when CBCT images are available.

Bleaching of nonvital teeth. A clinically relevant literature review.

Today, the bleaching of nonvital, discolored teeth is a low-risk routine treatment for improving esthetics. This review article focuses on the etiology of tooth discolorations, different treatment techniques, and risks of bleaching procedures. Some tooth discolorations in endodontically treated teeth are caused by dental treatments. The three most popular techniques for nonvital tooth bleaching are the walking bleach technique, inside/outside bleaching, and in-office bleaching. The walking bleach technique is a relatively reliable, fairly simple technique for dentists and patients. Inside/outside bleaching can be used additionally when internal and external bleaching must be combined. In-office bleaching seems to be a short-term solution, the effects of which can largely be attributed to dehydration of the teeth. There are still some open questions concerning the bleaching agents. Improved safety seems desirable with regard to adding thiourea as a scavenger of radicals or newer materials such as sodium percarbonate. The thermocatalytic technique, insufficient cervical sealing, and high concentrations of bleaching agents should be avoided, as this can increase the risk of cervical root resorptions. Patients should be informed about the low predictability of bleaching success and the risk of recurrent discoloration. The risk of cervical root resorption should be discussed with the patient. There is a strong correlation between root resorption and dental trauma.

Composite materials: composition, properties and clinical applications. A literature review.

Various composite materials are available today for direct restorative techniques. The most well-known materials are the hybrid composites. This technology, based on methacrylates and different types of filler coupled with silanes, has been continuously improved. Disadvantages such as polymerisation shrinkage, bacterial adhesion and side effects due to monomer release still remain. The aim of material development is to eliminate or at least reduce these negative factors by adapting the individual components of the material. With ormocers, the methacrylate has been partially replaced by an inorganic network. According to recent studies, the biocompatibility was not improved in all cases. The development of compomer was an attempt to combine the positive properties of glassionomers with composite technology. This has only partially succeeded, because the fluoride release is low. In an in-situ study, a caries protective effect could be shown at least in the first days following filling placement with concurrent extra-oral demineralisation. By replacing the chain-monomers in the composite matrix by ring-shaped molecules, a new approach to reduce polymerisation shrinkage was investigated. A new group of materials, the siloranes, has been developed. Siloranes are hydrophobic and need to be bonded to the dental hard tissue using a special adhesive system. Long-term clinical studies are still needed to prove the superiority of this new group of materials over modern hybrid composites.

[Oral jewelry: a review]. / Schmuck im Mundbereich: eine Ubersicht.

Oral jewelry is popular. One of the most widely spread types are so-called tooth diamonds made of composite materials which are applied to the teeth with an adhesive. Note that parents are required to sign a release form for under-aged patients in Switzerland. Tooth cap grills and gold teeth are considered status symbols within the Hip-Hop fashion scene. However, tooth ornaments favour the accumulation of plaque and can diminish the ability to articulate. With respect to jewelry in oral soft tissue especially tongue and lip piercings are of significance to dentists. Besides the systemic complications, which are mostly caused by a lack of hygiene or the failure of noting medical contraindications by the piercer, local complications occur frequently. After surgery, pain, swelling, infections as well as hemorrhages or hematomas can be observed. Long-term effects can be problematic: gingival recession can be discernes mainly in the case of lip piercings the loss of hard tooth substance in the case of tongue piercings. Because of that, conservation therapies can become indespensable. Patients wearing dental jewelry have to be aware of risks of tooth damage, and they regularly have to undergo dental check-ups. Information campaigns--for dentists as well as patients--are necessary.