RESUMO
Polycyclic aromatic compounds (PAHs) are formed during incomplete combustion and firefighters are inadvertently at risk of being exposed to these and other hazardous compounds. Exposure to PAHs is often estimated by measuring their hydroxylated metabolites (OH-PAH) in urine. Here, an online-SPE LC-MS-MS method was set up for eight OH-PAHs thus increasing sample throughput and minimizing manual handling. The method was validated over a 5-month period and showed good reproducibility with intra- and inter-day variation of 2.4-8.1% and 1.6-6.5%, respectively, of low-level samples and accuracy (91.6-104.8%) for a standard reference material. The method was applied to urine samples from conscripts training to become firefighters to determine the optimal sampling time for this training activity before a large intervention study. In total, six conscripts sampled urine 6-8 times over a 40-hr period during a 3-day training course. All eight metabolites were detected in ≥ 97% of the samples and showed peak excretion 4-6 hrs after the training corresponding to 8-10 hrs after first exposure. Samples taken the morning after the exercise contained low levels of most metabolites. Consequently, 4-6 hrs post exposure is recommended as the optimal sampling time for quantification of PAH exposure and monitoring of potential differences in exposure.
RESUMO
Cleaning work using spray products has been associated with adverse respiratory effects but little is known of the exposure concentrations. The purpose of this study was to characterize aerosol generation at spray scenarios in a controlled climate chamber. Spraying on vertically and horizontally oriented surfaces, as well as spraying on a cloth, was investigated. Furthermore, the effect of nozzle geometry was tested. The average mass generation rates of six pressurized spray cans and 13 trigger sprays were about 1.7 g/s and did not differ significantly, but the average values of the individual sprays had large variations (0.5-3.1 g/s). The time required to halve the air concentration of aerosol particles, the half-life time, was determined for all spray products. The average half-life time of the total particle mass concentration (TPMC) of the pressurized spray cans was 0.5 h versus 0.25 h for trigger sprays. Gravimetrically determined airborne fractions of pressurized spray cans tended to be higher than those of trigger sprays. However, airborne fractions based on the measured peak TPMC were up to three orders of magnitude smaller. A comparison of different trigger spray nozzles when spraying the same product showed that the TPMC can be up to 18 times higher for the largest emitting nozzle. The distance of the nozzle to a cloth should be 1 cm to significantly reduce the concentration of the generated aerosols. ConsExpo modeling predicted the measured peak TPMC well but less well the decay.
