Hepatic C9 cells switch their behaviour in short or long exposure to soft substrates.

BACKGROUND INFORMATION: There have been several studies to understand the influence of stiffness of the culture substrates for different types of adherent cells. It is generally accepted that cell proliferation, spreading and focal adhesions increase with higher matrix stiffness. However, what remains unclear is whether this kind of cell behaviour may be reverted by culturing on soft substrates those cell lines that were originally selected or primed on stiff surfaces. RESULTS: Here, we studied the influence of substrate softness on proliferation, adhesion and morphology of the highly proliferative hepatic C9 cell line. We cultured C9 cells on soft and stiff polydimethylsiloxane (PDMS) substrates prepared with two different elastic moduli in the range of 10 and 200 kPa, respectively. Lower cell proliferation was observed on substrates with lower stiffness without affecting cell viability. The proliferation rate of C9 cell line along with extracellular growth-regulated kinase (ERK) phosphorylation was decreased on soft PDMS. Despite this cell line has been described as a hepatic epithelial cell, our characterisation demonstrated that the origin of C9 cells is uncertain, although clearly epithelial, with the expression of markers of several hepatic cells. Surprisingly, consecutive passages of C9 cells on soft PDMS did not alter this mesenchymal phenotype, vimentin expression did not decrease when culturing cells in soft substrates, even though the ERK phosphorylation levels eventually were increased after several passages on soft PDMS, triggering again an increase of cell proliferation. CONCLUSIONS AND SIGNIFICANCE: This study shows that the exposure of C9 cells to soft substrates promoted a decrease of cell proliferation rate, as reported for other types of cells on PDMS, whereas a much longer term exposure caused cells to adapt to softness after trained for several passages, reactivating proliferation. During this phenomenon, the morphology and phenotype of trained cells was modified accompanying the increase of cell proliferation rate contrary to the effect observed in short periods of cell culture. In contrast to previous reports, cell death was not observed during these experiments, discarding a cell selection mechanism and suggesting soft cell adaptation may be limited in time in C9 cells.

Building a microfluidic cell culture platform with stiffness control using Loctite 3525 glue.

The study of mechanotransduction signals and cell response to mechanical properties requires designing culture substrates that possess some, or ideally all, of the following characteristics: (1) biological compatibility and adhesive properties, (2) stiffness control or tunability in a dynamic mode, (3) patternability on the microscale and (4) integrability in microfluidic chips. The most common materials used to address cell mechanotransduction are hydrogels, due to their softness. However, they may be impractical when complex scaffolds are sought and they lack viscous dissipative properties that are very important in mechanobiology. In this work, we show that an off-the-shelf, biocompatible photosensitive glue, Loctite 3525, may be used readily in mechanobiology assays without any special treatment prior to fabrication of cell culture platforms. Despite a high (MPa) stiffness easily tunable by UV exposure time at a fixed dose, 3T3 fibroblasts showed a response to the mechanics of the material similar to that obtained on much softer (kPa) hydrogels. Loctite's viscous dissipation properties indeed seemed to be responsible for such cell mechanical response, as suggested by recent works where more complex two-phase hydrogels were employed. More interestingly, it was possible to stiffen soft Loctite substrates by post-exposing them during cell culture, to observe changes in cell spreading caused by a dynamic stiffness modification. Thanks to Loctite 3525's patternability, micropillars were also fabricated to demonstrate the compatibility with traction force microscopy studies. Finally, the glue was used as an excellent adhesion layer for hydrogels on glass or PDMS, without the need for additional treatment, enabling the easy fabrication of microfluidic chips integrating hydrogels.