Investigating the impact of skull vibrations on motor responses to focused ultrasound neuromodulation in small rodents and methods to mitigate them.

Objective. Focused ultrasound (FUS) neuromodulation non-invasively alters brain activity, likely via acoustic radiation force with dynamics of the pulse repetition frequency (PRF). PRF impacts neuromodulation as well as indirect auditory activation, a confound linked to skull vibrations. This study aimed to minimize these vibrations, by adjusting and randomizing PRF, and determine their impact on FUS-induced motor activity. We hypothesized that: the skull would vibrate most at a specific PRF; randomizing PRF would reduce skull vibrations without affecting motor responses; and FUS would yield motor activity while actuator-induced skull vibrations would not.Approach. Three objectives were studied in parallel using C57Bl/6 mice (n= number of mice used per objective). First, skull vibration amplitude, measured as a percentage of maximum amplitude per treatment, was recorded via contact microphone over a range of PRFs to assess the PRF-dependency of skull vibrations (n= 19). Vibrations were then compared between random and fixed PRFs (n= 15). Lastly, motor responses were compared between fixed 1.5 kHz PRF FUS, random PRF FUS, air-puff stimulation, sham stimulation, and vibration induction via piezoelectric actuator (n= 30).Main Results.The study found amplitude peaked at 1.51 kHz (88.1 ± 11.5%), significantly higher than at 0.54 kHz (75.5 ± 15.1%;p= 0.0149). Random PRF reduced amplitude by 4.2% (p= 0.0181). Motor response rates to actuator-induced skull vibrations at the PRF (5.73 ± 6.96%) and its third harmonic (22.9 ± 22.7%) were not significantly different than sham (14.1 ± 11.6%), but lower than FUS (70.2 ± 16.3%;p< 0.0001).Significance. Based on these results, PRF near 0.5 kHz may best avoid skull vibrations, while random PRF could be utilized to slightly reduce vibration amplitude. The results also suggested that skull vibrations likely do not significantly impact motor responses to FUS neuromodulation.

Mechanistic insights into the C55-P targeting lipopeptide antibiotics revealed by structure-activity studies and high-resolution crystal structures.

The continued rise of antibiotic resistance is a global concern that threatens to undermine many aspects of modern medical practice. Key to addressing this threat is the discovery and development of new antibiotics that operate by unexploited modes of action. The so-called calcium-dependent lipopeptide antibiotics (CDAs) are an important emerging class of natural products that provides a source of new antibiotic agents rich in structural and mechanistic diversity. Notable in this regard is the subset of CDAs comprising the laspartomycins and amphomycins/friulimicins that specifically target the bacterial cell wall precursor undecaprenyl phosphate (C55-P). In this study we describe the design and synthesis of new C55-P-targeting CDAs with structural features drawn from both the laspartomycin and amphomycin/friulimicin classes. Assessment of these lipopeptides revealed previously unknown and surprisingly subtle structural features that are required for antibacterial activity. High-resolution crystal structures further indicate that the amphomycin/friulimicin-like lipopeptides adopt a unique crystal packing that governs their interaction with C55-P and provides an explanation for their antibacterial effect. In addition, live-cell microscopy studies provide further insights into the biological activity of the C55-P targeting CDAs highlighting their unique mechanism of action relative to the clinically used CDA daptomycin.

Effect of massing on larval growth rate.

Estimation of minimum postmortem interval commonly relies on predicting the age of blowfly larvae based on their size and an estimate of the temperatures to which they have been exposed throughout their development. The majority of larval growth rate data have been developed using small larval masses in order to avoid excess heat generation. The current study collected growth rate data for larvae at different mass volumes, and assessed the temperature production of these masses, for two forensically important blow fly species, Chrysomya rufifacies and Calliphora vicina. The growth rate of larvae in a small mass, exposed to the higher temperatures equivalent to those experienced by large masses, was also assessed to determine if observed differences were due to the known temperature effects of maggot masses. The results showed that temperature production increased with increasing mass volume, with temperature increases of 11 °C observed in the large Ch. rufifacies masses and increases of 5 °C in the large C. vicina masses. Similarly, the growth rate of the larvae was affected by mass size. The larvae from small masses grown at the higher temperatures experienced by large masses displayed an initial delay in growth, but then grew at a similar rate to those larvae at a constant 23 °C. Since these larvae from masses of equivalent sizes displayed similar patterns of growth rate, despite differing temperatures, and these growth rates differed from larger masses exposed to the same temperatures, it can be concluded that larval growth rate within a mass may be affected by additional factors other than temperature. Overall, this study highlights the importance of understanding the role of massing in larval development and provides initial developmental data for mass sizes of two forensically important blowfly species commonly encountered in Australian forensic casework.

Tracking movement and temperature selection of larvae of two forensically important blow fly species within a "maggot mass".

The current study responds to the lack of understanding about the temperatures experienced by individual blow fly larvae within "maggot masses." The temperature selection of both aggregating (in a mass) and nonaggregating larvae was compared and their pattern of movement assessed. Infrared imaging determined the temperatures within a mass and in the vicinity of the constituent individual larvae, whose movements were tracked by dyeing their tissues red. Individual Chrysomya rufifacies larvae selected temperatures above 27°C, significantly higher than the temperature selected by Calliphora vicina larvae (24.5°C). However, this same difference was not seen within a mass, with both species selecting temperatures around 28°C. Larval movement in a mass was nonrandom, indicating that larvae actively select their position in a mass. Furthermore, larvae have a strong tendency to select the hottest part of a mass; therefore, maximum mass temperatures might provide a reliable proxy for the actual temperatures experienced by larvae.

Thermogenesis in decomposing carcasses.

It is of fundamental importance in forensic entomology that the factors controlling carcass temperatures during decomposition are thoroughly understood. The thermal environment to which fly larvae are exposed is the primary influence on their growth rate, and hence affects any estimate of minimum time since death using such specimens in homicide investigations. To date, much of the entomological research on maggot masses has focused on their elevation of carcass temperatures, with very little focus on the bacteria associated with larval activity. The aim of this study was to investigate the heat associated with decay and the types of bacteria present during the decomposition of a carcass, both in the presence and in the absence of maggots. Three treatments were imposed: fresh, frozen and maggot-infested, each consisting of five replicate pig carcasses. Temperature measurements and bacterial swabs were taken from the gastro-intestinal region of each pig and temperatures and bacterial communities compared between treatments. All carcasses reached average maximum temperatures above 32 °C in a temperature controlled room set at 23 °C. Treatment had no statistically significant effect on the temperatures recorded in each carcass but did significantly affect the community structure of the bacteria. However, bacterial community structure varied across time. This study suggests that bacterial metabolism plays a significant role in carcass thermogenesis, and that maggot masses, while contributing to localised heating within the carcass, may have less of a role in elevating carcass temperatures than previously assumed.

Non-invasive visualisation and volume estimation of maggot masses using computed tomography scanning.

There is limited understanding of the actual temperatures that maggots experience during growth. The impact of maggot mass heating on their growth rates cannot be properly factored into maggot growth rate models, thus limiting the accuracy of forensic entomology estimates. One of the major factors contributing to mass heating is the mass size; however, measuring mass volume is problematic as masses quickly become disturbed when probing them to measure their depth and width. Furthermore, many masses are deep within the body cavity and are inaccessible. This study examined the development of a non-invasive means for measuring mass volume using computed tomography(CT) scanning. It was found that CT can be used to visualise and measure the volume of maggot masses, and a series of rules for doing so were established. The level of agreement between mass measurements made by four 'judges' using CT volumetric analysis tools produced excellent reliability (ICC > 0.95). This high level of reliability was maintained when applied to masses of different sizes in experimental cups of meat and natural masses of mixed species on human bodies. Entomological features of mortuary CT scans are now routinely reported in forensic entomology casework in Victoria, Australia, as a result of our work.

Examination of forensic entomology evidence using computed tomography scanning: case studies and refinement of techniques for estimating maggot mass volumes in bodies.

A new technique has recently been developed for estimating the volume of maggot masses on deceased persons using post-mortem CT scans. This allows volume to be measured non-invasively and factored into maggot mass temperature calculations for both casework and research. Examination of admission scans also allows exploration of entomological evidence in anatomical areas not usually exposed by autopsy (e.g. nasal cavities and facial sinuses), and before autopsy disrupts the maggot distribution on a body. This paper expands on work already completed by providing the x-ray attenuation coefficient by way of Hounsfield unit (HU) values for various maggot species, maggot masses and human tissue adjacent to masses. Specifically, this study looked at the HU values for four forensically important blowfly larvae: Lucilia cuprina, L. sericata, Calliphora stygia and C. vicina. The Calliphora species had significantly lower HU values than the Lucilia species. This might be explained by histological analysis, which revealed a non-significant trend, suggesting that Calliphora maggots have a higher fat content than the Lucilia maggots. It is apparent that the variation in the x-ray attenuation coefficient usually precludes its use as a tool for delineating the maggot mass from human tissue and that morphology is the dominant method for delineating a mass. This paper also includes three case studies, which reveal different applications for interpreting entomological evidence using post-mortem CT scans.

Experimental and casework validation of ambient temperature corrections in forensic entomology.

This paper expands on Archer (J Forensic Sci 49, 2004, 553), examining additional factors affecting ambient temperature correction of weather station data in forensic entomology. Sixteen hypothetical body discovery sites (BDSs) in Victoria and New South Wales (Australia), both in autumn and in summer, were compared to test whether the accuracy of correlation was affected by (i) length of correlation period; (ii) distance between BDS and weather station; and (iii) periodicity of ambient temperature measurements. The accuracy of correlations in data sets from real Victorian and NSW forensic entomology cases was also examined. Correlations increased weather data accuracy in all experiments, but significant differences in accuracy were found only between periodicity treatments. We found that a >5°C difference between average values of body in situ and correlation period weather station data was predictive of correlations that decreased the accuracy of ambient temperatures estimated using correlation. Practitioners should inspect their weather data sets for such differences.