RESUMO
There are forecasts for the exponential increase in the generation of carbon fibre-reinforced polymer (CFRP) and glass fibre-reinforced polymer (GFRP) composite wastes containing valuable carbon and glass fibres. The recent adoption of these composites in wind turbines and aeroplanes has increased the amount of end-of-life waste from these applications. By adequately closing the life cycle loop, these enormous volumes of waste can partly satisfy the global demand for their virgin counterparts. Therefore, there is a need to properly dispose these composite wastes, with material recovery being the final target, thanks to the strict EU regulations for promoting recycling and reusing as the highest priorities in waste disposal options. In addition, the hefty taxation has almost brought about an end to landfills. These government regulations towards properly recycling these composite wastes have changed the industries' attitudes toward sustainable disposal approaches, and life cycle assessment (LCA) plays a vital role in this transition phase. This LCA study uses climate change results and fossil fuel consumptions to study the environmental impacts of a thermal recycling route to recycle and remanufacture CFRP and GFRP wastes into recycled rCFRP and rGFRP composites. Additionally, a comprehensive analysis was performed comparing with the traditional waste management options such as landfill, incineration with energy recovery and feedstock for cement kiln. Overall, the LCA results were favourable for CFRP wastes to be recycled using the thermal recycling route with lower environmental impacts. However, this contradicts GFRP wastes in which using them as feedstock in cement kiln production displayed more reduced environmental impacts than those thermally recycled to substitute virgin composite production.
RESUMO
Recycled carbon fibre-reinforced epoxy (rCF/EP) composites and recycled glass fibre-reinforced epoxy (rGF/EP) composites were numerically investigated to examine their mechanical properties, such as uniaxial tensile and impact resistance, using finite element (FE) methods. The recycled composites possess unidirectional, long and continuous fibre arrangements. A commercially available Abaqus/CAE software was used to perform an explicit non-linear analysis with a macroscale modelling approach, assuming the recycled composites as both homogenous and isotropic hardening. Five composite types were subjected to a numerical study based on the recycled fibre's volume fraction (40 and 60%) of rCF/EP and rGF/EP, along with (100%) fibreless cured epoxy samples. The materials were defined as elastoplastic with a continuum ductile damage (DUCTCRT) model. The experimental tensile test results were processed and calibrated as primary input data for the developed FE models. The numerical tensile results, maximum principal stress and logarithmic strain were validated with their respective experimental results. The stress-strain curves of both results possess a high accuracy, supporting the developed FE model. The numerical impact tests examined the von Mises stress distribution and found an exponential decrease in the stiffness of the composite types as their strength decreased, with the 60% rCF/EP sample being the stiffest. The model was sensitive to the mesh size, hammer velocity and simulation time step. Additionally, the total internal energy and plastic dissipation energy were measured, but were higher than the experimentally measured energies, as the FE models eliminated the defects from the recycled process, such as a poor fibre wettability to resin, fibre bundle formation in rCFs and char formation in rGFs. Overall, the developed FE models predicted the results for a defect-free rCF/EP and rGF/EP composite. Hence, the adopted modelling techniques can validate the experimental results of recycled composites with complex mechanical properties and damage behaviours in tensile and impact loading conditions.
