Hybrid mode of hydrophobic interaction chromatography of monoclonal antibodies and related biomolecules: Influence of elution conditions on chromatographic performance using poly (alkyl aspartamide) silica columns.

A hybrid mode of hydrophobic interaction chromatography (HHIC) is an emerging analytical technique for the separation of biomolecules under non-denaturing conditions that combines elements of conventional hydrophobic interaction and reversed-phase chromatography. This article explores the impact of mobile phase composition such as salt concentration and organic modifier on the separation of therapeutic monoclonal antibodies and related large biomolecules using poly (alkyl aspartamide) silica HIC columns. The initial mobile phase salt concentration had a significant impact on the separation of a mixture of large biomolecules demonstrating that the relationship of elution and salt concentration was more complex than in conventional HIC. In general, the earlier eluting components exhibited greater retention at higher salt concentration as is typical of HIC separations. Conversely, the later eluting components showed greater retention at lower initial salt concentration. This differential is useful for improving the overall separation by widening the elution window for components of a mixture. In addition, no significant unfolding of the proteins was detected by intrinsic fluorescence or electrospray mass spectrometry. The impact of linear velocity and gradient steepness was also evaluated.

Synthesis of chiral mesoporous silicas with oligo(saccharide) surfaces and their use in separation of stereoisomers.

Novel chiral mesoporous silicas (SBA-15 motif) with chemically bonded oligo(saccharides) (1, 3, and 7 glucose units) were obtained through the cocondensation of organosilicon derivatives of the oligo(saccharides) and silica precursors in the presence of polymer surfactant template under mild acidic conditions. The pore order and structure of the materials prepared were characterized by transmission electron microscopy and nitrogen adsorption. The direct application of the oligo(saccharide)-grafted SBA-15 stationary phases in the HPLC separations of stereoisomers was demonstrated for the first time.

Surface area of reversed-phase HPLC columns.

Six reversed-phase columns from different manufacturers were characterized in terms of adsorbent geometry (e.g., pore volume, surface area, column void volume, and interparticle volume). Measurement of the surface area of chemically modified silica-based adsorbents is discussed together with the methods for the determination of the amount of adsorbent in the column. The behavior of nearly ideal chromatographic systems was studied. Retention factors of alkylbenzenes in acetonitrile/water and methanol/water systems were compared with surface-specific retention factors. The distribution of conventional retention factor values for the same analyte among the six columns using identical chromatographic conditions exceeded 35%, while the relative standard deviation of surface-specific retention factors was on the level of 3%.

Measurement of hold-up volumes in reverse-phase liquid chromatography Definition and comparison between static and dynamic methods.

The hold-up volumes, V(M) of two series of RPLC adsorbents were measured using three different approaches. The first method is based on the difference between the volumes of the empty column tube (150x4.6mm) and of the material packed inside the column. It is considered as giving the correct value of V(M). This method combines the results of the BET characterization of the adsorbent before packing (giving the specific pore volume), of carbon element analysis (giving the mass fraction of silica and alkyl bonded chains), of Helium pycnometry (providing silica density), and of inverse size exclusion chromatography (ISEC) performed on the packed column (yielding the interparticle volume). The second method is static pycnometry, which consists in weighing the masses of the chromatographic column filled with two distinct solvents of different densities. The last method is based on the thermodynamic definition of the hold-up volume and uses the dynamic minor disturbance method (MDM) with binary eluents. The experimental results of these three non-destructive methods are compared. They exhibit significant, systematic differences. Pycnometry underestimates V(M) by a few percent for adsorbents having a high carbon content. The results of the MDM method depend strongly on the choice of the binary solution used and may underestimate or overestimate V(M). The hold-up volume V(M) of the RPLC adsorbents tested is best measured by the MDM method using a mixture of ethanol and water.

Wetting in hydrophobic nanochannels: a challenge of classical capillarity.

We report an investigation of the water-hydrophobic interface in well-defined nanochannels (R approximately 2-4 nm). Wetting in these systems cannot be described by classical (macroscopic) capillary theory: (1) water occupies only a fraction ( approximately 60%) of the pore volume, and (2) the capillary pressures are approximately 60-90% greater than predicted by the Laplace equation. The results suggest the presence of approximately 0.6 nm layer of low-density fluid (vapor) separating water from the hydrophobic solid.

Influence of inorganic mobile phase additives on the retention, efficiency and peak symmetry of protonated basic compounds in reversed-phase liquid chromatography.

Inorganic eluent additives affect the retention of protonated basic analytes in reversed-phase HPLC. This influence is attributed to the disruption of the analyte solvation-desolvation equilibria in the mobile phase, also known as "chaotropic effect". With an increase of counteranion concentration analyte retention increases with concomitant decrease in the tailing factor. Different inorganic counteranions at equimolar concentrations affect protonated basic analyte retention and peak symmetry to varying degrees. The effect of the concentrations of four different inorganic mobile phase additives (KPF6, NaClO4, NaBF4, NaH2PO4) on the analyte retention, peak symmetry, and efficiency on a C8-bonded silica column has been studied. The analytes used in this study included phenols, toluene, benzyl amines, beta-blockers and ophthalmic drugs. The following trend in increase of basic analyte retention factor and decrease of tailing factor was found: PF6- > ClO4- approximately BF4- > H2PO4-. With the increase of the counteranion concentration greater analyte loading could be achieved and consequently an increase in the apparent efficiency was observed until the maximum plate number for the column was achieved. At the highest concentration of counteranions, the peak efficiency for most of the basic compounds studied was similar to that of the neutral markers. In contrast, the neutral markers, such as phenols, showed no significant changes in retention, efficiency or loading capacity as counteranion concentration was increased.

Effect of the counter-anion type and concentration on the liquid chromatography retention of beta-blockers.

Analysis of beta-blockers, basic pharmaceutical compounds with pKa values greater than 8.5, in reversed-phase HPLC can sometimes be challenging in terms of selection of the mobile phase pH, buffer concentration, and acidic modifier. The effect of the type and concentration of various mobile phase additives on the reversed-phase HPLC retention of these compounds was studied. HPLC analysis was performed at a mobile phase pH of 3 ensuring the protonation of the beta-blockers. It was found that at increasing perchlorate anion concentration at a constant mobile phase pH the retention factor for all beta-blocker compounds studied increased to varying degrees. The relative increase in the retention was attributed to ion interaction with the anionic mobile phase additive. Similar trends were observed when other types of inorganic salts such as NaH2PO4, NaPF6, NaBF4, and CF3CO2Na were employed. Differences in selectivity of the beta-blockers were obtained at a constant pH and an equimolar concentration of the different additives throughout the whole concentration range studied.