A simple-architecture fibered transmission system for dissemination of high stability 100 MHz signals.

We report on the development of a simple-architecture fiber-based frequency distribution system used to transfer high frequency stability 100 MHz signals. This work is focused on the emitter and the receiver performances that allow the transmission of the radio-frequency signal over an optical fiber. The system exhibits a residual fractional frequency stability of 1 × 10-14 at 1 s integration time and in the low 10-16 range after 100 s. These performances are suitable to transfer the signal of frequency references such as those of a state-of-the-art hydrogen maser without any phase noise compensation scheme. As an application, we demonstrate the dissemination of such a signal through a 100 m long optical fiber without any degradation. The proposed setup could be easily extended for operating frequencies in the 10 MHz-1 GHz range.

ELISA: a cryocooled 10 GHz oscillator with 10(-15) frequency stability.

This article reports the design, the breadboarding, and the validation of an ultrastable cryogenic sapphire oscillator operated in an autonomous cryocooler. The objective of this project was to demonstrate the feasibility of a frequency stability of 3x10(-15) between 1 and 1000 s for the European Space Agency deep space stations. This represents the lowest fractional frequency instability ever achieved with cryocoolers. The preliminary results presented in this paper validate the design we adopted for the sapphire resonator, the cold source, and the oscillator loop.

Ultra-low-noise microwave extraction from fiber-based optical frequency comb.

In this Letter we report on an all-optical-fiber approach to the generation of ultra-low-noise microwave signals. We make use of two erbium fiber mode-locked lasers phase locked to a common ultrastable laser source to generate an 11.55 GHz signal with an unprecedented relative phase noise of -111 dBc/Hz at 1 Hz from the carrier. The residual frequency instability of the microwave signals derived from the two optical frequency combs is below 2.3x10(-16) at 1 s and about 4x10(-19) at 6.5x10(4) s (in 5 Hz bandwidth, three days of continuous operation).

The use of thermosensitive quartz sensor for thermal regulation at cryogenic temperatures: application to microwave sapphire resonator references.

We demonstrated the use of thermosensitive quartz resonator oscillator as a thermal sensor for temperature control at the liquid nitrogen temperature. The high sensitivity of the quartz enables an efficient thermal regulation at ambient temperature as well as liquid nitrogen temperature. LC-cut quartz oscillator phase noise measurements show that the temperature measurement resolution is not limited by the intrinsic noise of the sensor and that a resolution of 10 muK can be achieved. This thermal regulation is applied to control a microwave temperature-compensated sapphire resonator oscillator at a temperature above 77 K, enabling the achievement of a flicker floor of 9.10(-13 ) at 9 GHz.