Pd-loaded hierarchical titanosilicalite-1 catalysts on CO2 cycloaddition with epoxides: Experimental and DFT investigations.

This work presents the synthesis of Pd-loaded microporous titanosilicalite-1 (Pd/TS-1) and Pd-loaded hierarchical titanosilicalite-1 (Pd/HTS-1) with abundant mesopores (2-30 nm) inside the framework via hydrothermal method using polydiallydimethyl ammonium chloride as the non-surfactant mesopore template. XRD, N2 sorption, FT-IR, FESEM-EDX, TEM, XPS, and DR-UV techniques were used to characterize the morphological and physicochemical properties of the synthesized materials. These materials were tested as heterogeneous catalysts, along with tetrapropylammonium bromide as co-catalyst, for cycloaddition reactions of CO2 with epoxides to produce cyclic carbonates. It was found that the epoxide conversions were influenced by acidity and pore accessibility of the catalysts. Using Pd/HTS-1 facilitated bulky substrates to access active sites, resulting in higher conversions than Pd/TS-1. Over 85 % conversions were achieved for at least five consecutive cycles without significant loss in catalytic activity. The interaction between the Pd active surfaces and epichlorohydrin (ECH) was further studied by DFT calculations. The existence of Pd(200) was more influential on adsorbing epichlorohydrin (ECH) and subsequent formation of dissociated ECH (DECH) intermediate than Pd(111) surface. However, Pd(111) was dominant in enhancing the activity of DECH species for capturing CO2. Therefore, the co-existence of Pd(200) and Pd(111) surfaces was needed for cycloaddition of CO2 with ECH.

The Underlying Catalytic Role of Oxygen Vacancies in Fatty Acid Methyl Esters Ketonization over TiOx Catalysts.

Recently, interest in converting bio-derived fatty acid methyl esters (FAMEs) into added-value products has significantly increased. The selectivity of ketonization reaction in the conversion of the FAMEs has significantly hampered the efficiency of this process. Herein, this work reports the preparation of catalysts with different levels of oxygen vacancies while the crystal phase remained unchanged. The catalyst with the highest level of oxygen vacancy exhibited the maximum selectivity. The density functional theory (DFT) simulation showed an increase in interatomic distances leading to the formation of frustrated Lewis pairs (FLPs) upon the creation of oxygen vacancies. The surface measurements, type and density of acid sites of the catalysts, showed that the Lewis acid sites enhanced the selectivity for ketone production; while Bronsted acid sites increased the formation of by-products. Moreover, the ketone formation rate was directly proportional to acid density. The findings of this research provide a different approach for catalyst design, based on defects engineering and their effect on the surface activity, which could be used for enhancing the catalytic performance of novel metal oxides.

A density functional theory study on how γ-Al2O3 - Boehmite transformation affects carbon evolution during aqueous-phase reaction.

Gamma-alumina (γ-Al2O3), one of the most common materials, is commercially used in many catalytic applications, including the active catalyst and support. However, the problem of fast deactivation makes the utilization of the γ-Al2O3 challenging. This work elucidates the mechanism of coke formation consisting of coke deposition and evolution on γ-Al2O3(110) surfaces in differential conditions, including; clean and hydroxylation γ-Al2O3(110) in terms of partial and fully hydroxylation of OH/γ-Al2O3(110) and AlOOH(010), respectively. We demonstrated that the γ-Al2O3(110) surface is proper for atomic coke deposition and dimerization in the initial state, where the presence of OH species promotes the coke evolution to higher coke, Cn (where n ≥ 3). Also, the higher coke formation thermodynamically preferred the cyclic form to the aliphatic one. The electron transfer from substrates to adsorbed coke illustrates the role of the electron donor of catalyst surfaces corresponding to the electron acceptor of adsorbed cokes.

First-principles-driven catalyst design protocol of 2D/2D heterostructures for electro- and photocatalytic nitrogen reduction reaction.

Ammonia synthesis from nitrogen is a vital process and a necessity in a variety of applications including energy, pharmaceutical, agricultural, and chemical applications. The electro- and photocatalytic nitrogen reduction reactions (NRRs) are promising sustainable processes operated under milder conditions than the conventional Haber-Bosch process. However, the main pain points of these catalytic processes are their low selectivity and low efficiency. This perspective presents the recent status and the design protocols for developing promising 2D/2D heterojunction catalysts for the NRR, using the first-principles approach. The current theoretical studies are briefly discussed, and available methods are suggested for the development and design of new potential 2D/2D heterojunctions as efficient electro- and photo-NRR catalysts.

Design, synthesis, and evaluation of the anticancer activity of 2-amino-aryl-7-aryl-benzoxazole compounds.

A series of 2-amino-aryl-7-aryl-benzoxazole derivatives have been designed, synthesized, and evaluated as anticancer agents. Fourteen of the compounds exhibited cytotoxic effects toward human A549 lung cancer cells. We found 12l was the most potent with an EC50 of 0.4 µm, equivalent to the anticancer drug doxorubicin, but had low selectivity following cross screening in monkey kidney Vero cells. Eight of the most potent or most selective compounds were further profiled in additional cell lines (MCF7, NCI-H187, and KB) to better understand their cytotoxic activity. Only compound 12l had a measurable EC50 in a single cell line (3.3 µm in the KB cell line). Taken together, this data suggest the series as a whole display specific cytotoxicity toward A549 cells. Cheminformatics searches pointed to JAK2 as a possible target. A subset of compounds assayed at this target showed IC50 s ranging from 10 to 0.08 µm; however, no clear correlation between JAK2 potency and A549 cytotoxicity was observed.