RESUMO
INTRODUCTION: The aim of the present study was to comparatively evaluate the physical surface changes and incidence of separation in rotary nickel-titanium (NiTi) instruments using scanning electron microscope (SEM). METHODS AND MATERIALS: A total number of 210 freshly extracted human maxillary and mandibular first molars were selected and distributed between three groups. Three different systems of rotary NiTi instruments, namely ProFile (PF), RaCe (RC) and Twisted File (TF), were used to prepare the canals using crown-down technique. All instruments were evaluated by means of SEM with 500× and 1500× magnifications, at four different stages; before use, after preparation of 7 and 14 canals and after instrument separation. Photomicrographs were also taken. The data was analyzed using the Kruskal-Wallis test and the level of significance was set at 0.001. It was found that H (HAT matrix) was 15.316 with 2 degrees of freedom. Moreover the various groups were compared using the Student-Newman-Keuls test with P<0.05 and it was found that all groups were significantly different. RESULTS: RC showed the maximum wear of the surface followed by TF (P<0.05). PF showed the minimum wear except for its tip. There was no correlation between electropolishing and file fracture. Insignificant difference was observed in the mean number of canals shaped by PF and TF before their separation. CONCLUSION: Clinically, TF performance was superior, followed by PF then RC. RC fracture rate was the greatest after preparing the least number of canals.
RESUMO
AIMS: The aim of the following study is to evaluate the change in laser fluorescence (LF) values for extracted teeth stored in different solutions over 1 year period, to give cut-off values for different storage media at different time intervals to get them at par with the in vivo conditions and to see which medium gives best results with the least change in LF values and while enhancing the validity of DIAGNOdent in research. MATERIALS AND METHODS: Ninety extracted teeth selected, from a pool of frozen teeth, were divided into nine groups of 10 each. Specimens in Groups 1-8 were stored in 1% chloramine, 10% formalin, 10% buffered formalin, 0.02% thymol, 0.12% chlorhexidine, 3% sodium hypochlorite, a commercially available saliva substitute-Wet Mouth (ICPA Pharmaceuticals) and normal saline respectively at 4°C. The last group was stored under frozen condition at -20°C without contact with any storage solution. DIAGNOdent was used to measure the change the LF values at day 30, 45, 60, 160 and 365. STATISTICAL ANALYSIS USED: The mean change in LF values in different storage mediums at different time intervals were compared using two-way ANOVA. RESULTS: At the end of 1 year, significant decrease in fluorescence (P < 0.05) was observed in Groups 1-8. Maximum drop in LF values occurred between day 1 and 30. Group 9 (frozen specimens) did not significantly change their fluorescence response. CONCLUSIONS: An inevitable change in LF takes place due to various storage media commonly used in dental research at different time intervals. The values obtained from our study can remove the bias caused by the storage media and the values of LF thus obtained can hence be conveniently extrapolated to the in vivo condition.
