Noninvasive and Continuous Monitoring of the Core Body Temperature through the Quantitative Measurement of Blood Perfusion Rate.

Core body temperature (CBT) is one of the four vital signs that must be monitored continuously. The continuous recording of CBT is possible through invasive methods by inserting a temperature probe into specific body sites. We report a novel method to monitor CBT through the quantitative measurement of skin blood perfusion rate (ωb,skin). By monitoring the skin temperature, heat flux, and ωb,skin, the arterial blood temperature, equivalent to CBT, can be extracted. ωb,skin is quantitatively evaluated thermally via sinusoidal heating with regulated thermal penetration depth so that the blood perfusion rate is acquired only in the skin. Its quantification is significant because it indicates various physiological events including hyper- or hypothermia, tissue death, and delineation of tumors. A subject showed promising results with steady values of ωb,skin and CBT of 5.2 ± 1.05 × 10-4 s-1 and 36.51 ± 0.23 °C, respectively. For periods where the subject's actual CBT (axillary temperature) did not fall within the estimated range, the average deviation from the actual CBT was only 0.07 °C. This study aims to develop a competent methodology capable of continuously monitoring the CBT and blood perfusion rate at a distant location from the core body region for the diagnosis of a patient's health condition with wearable devices.

Effect of Heat Treatment on Microstructure and Thermal Conductivity of Thermal Barrier Coating.

Thermal barrier coatings (TBCs) are essential for increasing the inlet temperature of gas turbines to improve their thermal efficiency. Continuous exposure to flames is known to affect the thermal properties of TBCs, degrading the performance of gas turbines as a consequence. In this study, we quantified the changes in the thermal conductivity of yttria-stabilized zirconia coatings with respect to various heat treatment temperatures and times. The coating exhibited an increase in thermal conductivity after heat treatment, with higher heat treatment temperatures resulting in greater thermal conductivity. The coatings were analyzed by X-ray diffraction and scanning electron microscopy before and after heat treatment. Results showed that there was little change in thermal conductivity due to phase changes and grain size. We conclude that pore structures, i.e., circular and lamellar pores, affected the change in thermal conductivity. Specifically, we confirmed that the change in thermal conductivity depends on the size of the lamellar pores.