In vitro sun protection factor: still a challenge with no final answer.

In the past, several attempts have been made to develop in vitro methods for determining protection against UV radiation. To date however, there is no broadly accepted method. Various known and unknown parameters influence the transmission measurements of scattering films, such as the multifaceted compositions of sunscreens, the technical limitations of measurement devices as well as the difficulty to apply very thin films of sunscreen in a reproducible manner throughout different laboratories. In vitro data were measured in this multicenter study to compare possible methodologies and strategies for an in vitro approach to the sun protection factor (SPF). This publication will not present a final in vitro SPF test method, but it will point out which technical side effects may influence such a method. Influential factors such as the quality of spectrophotometer used, the amount of product applied, pretreatment of samples, time and temperature of equilibration, size of the measured surface, the application process or the calculation on the basis of standardized data are presented and discussed. Finally, a reduction of the standard deviations within single laboratories could be realized for in vitro SPF testing, but no improvement of the interlaboratory comparison was obtained. The development of a valid and reliable SPF in vitro test still remains a challenge, and further work is necessary to develop a satisfactory method.

Influence of applied quantity of sunscreen products on the sun protection factor--a multicenter study organized by the DGK Task Force Sun Protection.

It is often debated that the protection against solar-induced erythema under real conditions is dependent upon the amount of sunscreen applied. It is believed that when too little is applied a lower sun protection than indicated on the label will result. The aim of this study was to quantify this effect. In this multicenter study, the influence of three different amounts (0.5, 1.0, 2.0 mg/cm(2)) of three commercial sunscreen products in three reliable test centers was investigated according to the test protocol of The International Sun Protection Factor Test Method. The main result was a linear dependence of the SPF on the quantity applied. Taking into consideration the volunteer-specific variations, an exponential dependence of confidence interval of the in vivo SPF and amount applied was found. The highest amount applied (2.0 mg/cm(2)) was linked to the lowest confidence intervals. Thus, from the point of view of producing reliable and reproducible in vivo results under laboratory conditions, the recommendation of this multicenter study is an application quantity of 2.0 mg/cm(2).