Short-term Resistance and Plyometric Training Improves Eccentric Phase Kinetics in Jumping.

The purpose of this investigation was to examine the effect of an abbreviated resistance and plyometric training program on force- and power-time curve variables during jumping. Nineteen male subjects were assigned to either a training (n = 9) or control group (n = 10). Training consisted of performing 3 sets of 3 repetition squats (90% of 1 repetition maximum [RM]) and 5 sets of 6 repetition drop jumps from 40 cm twice per week for 4 weeks. A 1RM in the squat and countermovement (CMJ) and static jump (SJ) performance was assessed before and after training. Several variables were analyzed for individual subject force- and power-time curves for the jumps. Average force- and power-time curves for all subjects combined were also analyzed. Absolute and relative squat strength significantly increased in training group (p ≤ 0.05). Calculation of variables from individual subject force-time curves during the CMJ indicated a significant decrease in eccentric time, minimum force, and eccentric impulse and significant increase in eccentric rate of force development in training group. Analysis of individual power-time curves in the CMJ also revealed a significant decrease in minimum power and eccentric work and a significant increase in eccentric rate of power development. No significant changes occurred in the variables measured for the SJ. The results of this study indicate that short-term strength and plyometric training may preferentially influence eccentric performance variables during jumping in comparison with longer term training enhancements to the concentric phase performance.

Index of mechanical efficiency in competitive and recreational long distance runners.

The purpose of this investigation was to compare external work and net energy expenditure during a bout of repetitive stretch-shortening cycles between competitive and recreational long-distance runners. Participants were divided into either competitive or recreational runners based on their maximal oxygen consumption and self-reported 1600 m times. The stretch-shortening cycle involved a repetitive hopping protocol on a force plate while measuring oxygen consumption and lactate accumulation for a total of 10 min. External work and net energy expenditure were calculated for 3 min after steady state was achieved and the ratio between these variables was utilised as an index of mechanical efficiency. Lower extremity stiffness was calculated during this interval as well. Net energy expenditure was significantly lower in competitive runners (152.6 ± 33.3 kJ) in comparison to recreational runners (200.6 ± 41.4 kJ) (P = 0.02) given similar amounts of external work performed in both groups (competitive runners = 65.6 ± 20.1 kJ, recreational runners = 68.8 ± 12.1 kJ) (P = 0.67). Index of mechanical efficiency was significantly different between competitive runners (43.2 ± 9.0%) and recreational runners (34.8 ± 5.3%) (P = 0.03). No significant differences were found in lower extremity stiffness (P = 0.64). Competitive distance runners can perform similar levels of external work with lower net energy expenditure and thus a higher index of mechanical efficiency during repetitive stretch-shortening cycles in comparison to recreational runners with similar values of lower extremity stiffness. This ability could possibly be due differences in muscle-tendon length changes, muscle pre-activation, cross-bridge potentiation and short-latency reflex responses as a result of training which should be considered for future investigation.