Accurate modeling of radiation-induced absorption in Er-Al-doped silica fibers exposed to high-energy ionizing radiations.

We offer here an accurate quantitative model of the RIA (radiation-induced absorption) at low dose-rate (below 1 kGy) that experience the most common erbium-doped fibers (Ge-Al-Er-doped silica) under radiations. It addresses the degradation mechanisms of the glass fiber, especially the influence of its doping elements versus its sensitivity to radiations. Moreover, it depends mainly on macroscopic quantities coming from literature or experiments. For these two reasons, it is a reliable and efficient tool for the engineering of erbium-doped fibers (erbium-free fibers too) exposed to ionizing radiations and is validated in this paper by comparing the modelisation results to RIA experiments on 14 Er-doped optical fiber samples, in which composition changes a lot from one sample to another (in the range 0-25%wt for Ge, 0-10%wt for Al and 0-1500ppm for Er).

Coupling Waveguide-Based Micro-Sensors and Spectral Multivariate Analysis to Improve Spray Deposit Characterization in Agriculture.

The leaf coverage surface is a key measurement of the spraying process to maximize spray efficiency. To determine leaf coverage surface, the development of optical micro-sensors that, coupled with a multivariate spectral analysis, will be able to measure the volume of the droplets deposited on their surface is proposed. Rib optical waveguides based on Ge-Se-Te chalcogenide films were manufactured and their light transmission was studied as a response to the deposition of demineralized water droplets on their surface. The measurements were performed using a dedicated spectrophotometric bench to record the transmission spectra at the output of the waveguides, before (reference) and after drop deposition, in the wavelength range between 1200 and 2000 nm. The presence of a hollow at 1450 nm in the relative transmission spectra has been recorded. This corresponds to the first overtone of the O-H stretching vibration in water. This result tends to show that the optical intensity decrease observed after droplet deposition is partly due to absorption by water of the light energy carried by the guided mode evanescent field. The probe based on Ge-Se-Te rib optical waveguides is thus sensitive throughout the whole range of volumes studied, i.e., from 0.1 to 2.5 µL. Principal Component Analysis and Partial Least Square as multivariate techniques then allowed the analysis of the statistics of the measurements and the predictive character of the transmission spectra. It confirmed the sensitivity of the measurement system to the water absorption, and the predictive model allowed the prediction of droplet volumes on an independent set of measurements, with a correlation of 66.5% and a precision of 0.39 µL.