RESUMO
The challenges in treating oral cancer include the limited effectiveness and systemic side effects of conventional chemotherapy and radiation therapy. Hyaluronic acid (HA) based Glycyrrhizin (GL) and Methotrexate (MT) loaded localized delivery systems, specifically nanofiber (NF) based platforms, were developed to address these challenges. The electrospinning method was used for the successful fabrication of a homogenous NF membrane and characterized for morphology, drug entrapment efficiency, tensile strength, and ex-vivo mucoadhesive study. Also, it was evaluated for in-vitro drug release profile, ex-vivo drug permeability, in-vitro anti-inflammatory, apoptosis assay by MTT and flow, and against specific cell lines in order to determine their potential for therapeutic use. Superior tensile breaking force (50 g), mucoadhesive strength of 153 gm/cm2, drug permeability, and releasing properties of designed NF, making them perfect requirements for oral cavity delivery. The anticancer potential of MT in the MTT assay and flow cytometry analysis was significantly increased in oral epidermal carcinoma cell (KB cell) for drug-loaded NF with 63.97 ± 1.99 % apoptosis, at 24 h. With these incorporated, GL with MT in NF had an anti-inflammatory potential, also demonstrated in-vitro and in-vivo. In the Ehrlich Ascites Carcinoma (EAC) induced mice model, the optimal formulation's shows better potential for tumor regression when comparing the developed NF formulation to the drugs. Experimental results show that by lowering mucositis-related inflammation and enhancing the effectiveness of oral cancer treatment, a developed nanofiber-based local drug delivery system offers a feasible strategy for managing oral cancer.
RESUMO
Optical temperature sensing in Er3+-Tm3+-Yb3+codoped CaMoO4 phosphor prepared by chemical co-precipitation route based on the near infrared (NIR) to green upconversion emission from Er3+ ion is reported. The variation with respect to external temperature in emission intensity ratio of the green emissions around 530 nm and 552 nm, corresponding to the 2H11/2 â 4I15/2 and 4S3/2 â 4I15/2 transitions respectively, under 980 nm excitation has been studied in detail, to report the sensing property of the prepared material; the maximum sensor sensitivity â¼0.0182 K-1 was attained at 413 K. The laser induced optical heating within the prepared phosphor has been explored and the heat generation caused by the laser effect has been verified by comparison of experimental and calculated data.
RESUMO
Ferroelectric BaTiO3 became a multifunctional material via doping of lanthanide ions (0.3 mol% Er(3+)/3.0 mol% Yb(3+)) and subsequently upconversion luminescence was enhanced by incorporation of Zn(2+) ions. Upconversion luminescence of BaTiO3:Er(3+)/Yb(3+) perovskite nanophosphor has been studied using 800 and 980 nm laser excitations. The emission dynamics is studied with respect to its dependence on input power and external temperature including lifetime. Based on time-resolved spectroscopy, it is inferred that two types of Er(3+) sites are present in the barium titanate lattice. The first one is a short lived component (minor species) present at 6-coordinated Ti-sites of low symmetry while the second one is a long lived component (major species), present at 12-coordinated Ba-sites with high symmetry. The influence of the introduction of Zn(2+) ions on the lifetime of (4)S3/2 and (4)F9/2 levels of Er(3+) ions is also investigated. Enhanced temperature sensing performance (120 K to 505 K) of the material is observed using the fluorescence intensity ratio technique, employing the emission from the thermally coupled, (2)H11/2 and (4)S3/2 energy levels of Er(3+) ions. The defect luminescence of the material is also found to increase upon Zn-doping.
