Profile measurements of the electron temperature on the ASDEX Upgrade, COMPASS, and ISTTOK tokamak using Thomson scattering, triple, and ball-pen probes.

The ball-pen probe (BPP) technique is used successfully to make profile measurements of the electron temperature on the ASDEX Upgrade (Axially Symmetric Divertor Experiment), COMPASS (COMPact ASSembly), and ISTTOK (Instituto Superior Tecnico TOKamak) tokamak. The electron temperature is provided by a combination of the BPP potential (ΦBPP) and the floating potential (Vfl) of the Langmuir probe (LP), which is compared with the Thomson scattering diagnostic on ASDEX Upgrade and COMPASS. Excellent agreement between the two diagnostics is obtained for circular and diverted plasmas and different heating mechanisms (Ohmic, NBI, ECRH) in deuterium discharges with the same formula Te = (ΦBPP - Vfl)/2.2. The comparative measurements of the electron temperature using BPP/LP and triple probe (TP) techniques on the ISTTOK tokamak show good agreement of averaged values only inside the separatrix. It was also found that the TP provides the electron temperature with significantly higher standard deviation than BPP/LP. However, the resulting values of both techniques are well in the phase with the maximum of cross-correlation function being 0.8.

Edge and core Thomson scattering systems and their calibration on the ASDEX Upgrade tokamak.

A new 10 channel Thomson scattering (TS) system was installed on the ASDEX Upgrade tokamak to measure radial profiles of electron density and temperature at the plasma edge with high radial resolution. Together with the already existing TS system, which is now used for the core plasma, electron density and temperature profiles extending from the edge to the core are now obtained in a single discharge. The TS systems are relatively calibrated by an optical parametric oscillator.

Fine structure of type-I edge-localized modes in the steep gradient region.

Fast, high resolution multichannel Thomson scattering is used to quantitatively determine plasma perturbations induced by type-I edge-localized modes (ELMs) in the low-field side edge of ASDEX Upgrade H-mode plasmas. 2D snapshots of temperature and density, deduced from the laser light scattered in a vertically elongated, poloidal array of 5 x 10 scattering volumes, are obtained in the hot, steep edge gradient zone, which is difficult to access by other diagnostics. Local maxima and minima with large amplitude are identified during ELMs and even in the precursor phase, both in density and temperature. Interpreting these structures as footprints of approximately field aligned helical modes in accordance with previous experimental and theoretical work, toroidal mode numbers between 8 and 20 are obtained, roughly consistent with corresponding scrape-off layer and divertor measurements.

Reaching high poloidal beta at Greenwald density with internal transport barrier close to full noninductive current drive.

In the ASDEX Upgrade tokamak, high poloidal beta up to beta(pol) = 3 at the Greenwald density with H-mode confinement has been reached. Because of the high beta, the plasma current is driven almost fully noninductively, consisting of 51% bootstrap and 43% neutral beam driven current. To reach these conditions the discharge is operated at low plasma current ( I(P) = 400 kA) and high neutral beam heating power ( P(NBI) = 10 MW). The discharge combines an edge (H mode) and internal transport barrier at high densities without confinement-limiting MHD activities. The extrapolation to higher plasma currents may offer a promising way for an advanced scenario based fusion reactor.