Efficient micro-cavity top emission OLED with optimized Mg:Ag ratio cathode.

Micro-cavity top-emitting organic light emitting diodes (TEOLEDs) are now receiving prominence as a technology for the active matrix display applications. The semi-transparent metal cathode plays the crucial role in realizing TEOLEDs structure. Here, we report the optimization results on Mg:Ag ratio as the semitransparent cathode deposited by vacuum thermal evaporation. The optimized Mg:Ag cathode with 1:10 ratio (wt %) shows a sheet resistance value as low as 5.2 Ω/□, an average transmittance of 49.7%, reflectance of 41.4%, and absorbance of 8.9% over the visible spectral region (400~700 nm). The fabricated red TEOLEDs device implemented using LiF (1nm)/Mg:Ag (1:10) cathode shows the voltage value of 4.17 V at a current density of 10.00 mA/cm2, and current efficiencies variation from 55.3 to 50.1 cd/A over the brightness range 2,000 - 12,000 cd/m2. The electroluminescence (EL) spectrum displays the light emission at 608 nm wavelength with a half width of 29.5 nm. The narrow half-width of red light emission is attributed to the micro-cavity effects due to the semitransparent cathode.

Successful Thoracic Duct Ligation for Plastic Bronchitis in an Adult.

Plastic bronchitis is a rare and potentially life-threatening disease characterized by the development of obstructive fibrinous tracheobronchial casts and hypoxic respiratory failure. With its poorly understood cause and rare occurrence in the adult population, few treatment strategies have been described in adults with this condition. In this report, we present a case of successful treatment of an adult with plastic bronchitis, using thoracic duct ligation and resulting in full resolution of airway cast development.

Macroscopic alignment of chromonic liquid crystals using patterned substrates.

We demonstrate an efficient technique to align lyotropic chromonic liquid crystals (LCLCs) using secondary sputtering lithography (SSL). Monodomains of LCLCs prepared using SSL maintained their stable alignment for days. A generalization of Berreman's theory was employed to determine the anchoring strength of LCLCs on tessellated surface patterns. The anchoring energy initially increases with the amplitude (A) of the grooves and excellent alignment of LCLCs was observed when the amplitude of the grooves is equal to half its wavelength (λ). We also note that the anchoring energy levels off above qA∼ 3 (where q = 2π/λ), which suggests that increasing qA beyond a certain value does not provide any further advantage for the alignment of LCLCs. This finding provides a useful optimization criterion for the fabrication of the patterned cells to achieve stable monodomain alignment of LCLCs. Our analysis also explains why good alignment of LCLCs has been a difficult task.

Fabrication of sub-20 nm nano-gap structures through the elastomeric nano-stamp assisted secondary sputtering phenomenon.

We describe a highly efficient method for fabricating controllable and reliable sub-20 nm scale nano-gap structures through an elastomeric nano-stamp with an embedded ultra-thin pattern. The stamp consists of ultrahigh resolution (approximately 10 nm) and high aspect ratio (ca. 15) metal nano-structures, which are obtained by secondary sputtering lithography (SSL). The nano-gap structures fabricated in this fashion achieve a high resolution and meet the requirements of minimal cost, high reliability, controllability, reproducibility, and applicability to different materials. Further, we demonstrate that this method enables the fabrication of SERS substrates for detection at the single-molecule level.

Fabrication of complex 3-dimensional patterned structures on a ∼10 nm scale from a single master pattern by secondary sputtering lithography.

We describe a highly efficient method for fabricating a variety of complex 3D nano-patterns from a single master pattern using secondary sputtering lithography, which is a 10 nm scale patterning method that we have developed. A rapid etching rate in the bottom part of the PS pillar during the RIE process can produce various nanostructure shapes and the PS residual layer thickness can influence various feature dimensions, due to the controlled RIE time leading to different PS layer thicknesses. This technique provides a highly effective method for producing various complex 3D patterns from a single master pattern. Thus, this method can serve as a new procedure for the cost-effective mass production of complex nanoscale patterns with high resolution.

A new population of cells lacking expression of CD27 represents a notable component of the B cell memory compartment in systemic lupus erythematosus.

Human memory B cells comprise isotype-switched and nonswitched cells with both subsets displaying somatic hypermutation. In addition to somatic hypermutation, CD27 expression has also been considered a universal memory B cell marker. We describe a new population of memory B cells containing isotype-switched (IgG and IgA) and IgM-only cells and lacking expression of CD27 and IgD. These cells are present in peripheral blood and tonsils of healthy subjects and display a degree of hypermutation comparable to CD27+ nonswitched memory cells. As conventional memory cells, they proliferate in response to CpG DNA and fail to extrude rhodamine. In contrast to other recently described CD27-negative (CD27neg) memory B cells, they lack expression of FcRH4 and recirculate in the peripheral blood. Although CD27neg memory cells are relatively scarce in healthy subjects, they are substantially increased in systemic lupus erythematosus (SLE) patients in whom they frequently represent a large fraction of all memory B cells. Yet, their frequency is normal in patients with rheumatoid arthritis or chronic hepatitis C. In SLE, an increased frequency of CD27neg memory cells is significantly associated with higher disease activity index, a history of nephritis, and disease-specific autoantibodies (anti-dsDNA, anti-Smith (Sm), anti-ribonucleoprotein (RNP), and 9G4). These findings enhance our understanding of the B cell diversification pathways and provide mechanistic insight into the immunopathogenesis of SLE.