Interparticle forces in spherical monodispersed silica dispersions: effects of branched polyethylenimine and molecular weight.

The effect of branched polyethylenimine (PEI) of molecular weight (Mw) 600, 1800 and 70,000 on the surface forces interacting between 'uniform size' spherical silica particles in water was investigated via the yield stress and zeta potential techniques. This silica has a point of zero charge at pH approximately 2.0. All PEIs caused the zeta potential-pH curve and the high pH zero zeta potential to shift to a higher pH and the extent of the shift increases with increasing PEI concentration and is not affected by PEI Mw. PEI adsorption on silica is low or negligible at pH less than 3.5 and this is due to a very low negative charge density. Adsorption of PEI beyond 3.5 caused a maximum zeta potential to occur at pH between 4 and 6. The maximum yield stress located at the point zero zeta potential is many times larger than that with no added PEI. It ranged from 20 to 42 times for low Mw PEI and as high as 68 times for Mw 70,000. At low surface coverages, the force responsible for the high yield stress is charged patch-bridging attraction. At complete surface coverage, particle bridging via hydrogen bond and unlike charged attraction between monomeric, dimeric and tetrameric silicate ions with the adsorbed PEI layers of the interacting particles was responsible.

Yield stress and zeta potential of nanoparticulate silica dispersions under the influence of adsorbed hydrolysis products of metal ions--Cu(II), Al(III) and Th(IV).

The effects of hydrolysable Cu2+, Al3+ and Th4+ ions on the zeta potential and yield stress behaviour of silica dispersions were evaluated as a function of pH and metal ions concentration. Silica dispersion remained dispersed at its point of zero charge (pzc) of pH approximately 2.0 (CR1). Adsorbed hydrolysis products of Cu2+ and Al3+ caused the dispersion to display two further points of charge reversal (CR2 and CR3) at moderate ions concentration. CR2 occurred near the pH for the formation of the first hydrolysis product. This pH is about 2.8 for Al3+ and 5.0 for Cu2+. For all three metal ions, CR3 approached the pzc of the metal hydroxides at complete surface coverage. At CR3, the dispersions displayed a maximum yield stress. As many as three type of attractive forces; bridging, charged patch and van der Waals, may account for the maximum yield stress at low surface coverage. At complete coverage, only the van der Waals force is in play--the adsorbed hydrolysis products must have increased significantly the effective Hamaker constant of silica. With Al3+ the yield stress was absent at CR2 because particle bridging and charged patch attraction are unimportant as the silica surface charge is near zero. Adsorption of strongly hydrolysed Th4+ ions at pH<2.0 caused the dispersion to display only one pzc (CR3).

A general computational method for converting normal spectra into derivative spectra.

The mathematical problem of converting a normal spectrum into the corresponding first- and second-derivative spectra is formulated as an integral equation of the first kind. Tikhonov regularization is then applied to solve the spectral conversion problem. The end result is a set of linear algebraic equations that takes in as input the original spectrum and produces as output the second-derivative spectrum, which is then integrated to yield the first-derivative spectrum. Noise amplification is kept under control by adjusting the regularization parameter (guided by generalized cross-validation) in the algebraic equations. The performance of this procedure is demonstrated by applying it to different types of spectral data taken from the literature.

Allele distribution at nine STR loci--D3S1358, vWA, FGA, TH01, TPOX, CSF1PO, D5S818, D13S317 and D7S820--in the Japanese population by multiplex PCR and capillary electrophoresis.

Nine tetranucleotide short tandem repeat (STR) loci, D3S1358, vWA, FGA TH01, TPOX, CSF1PO, D5S818, D13S317 and D7S820, were analyzed in the Japanese population with a newly released kit for personal identification using multiplex PCR with fluorescent-labeled primers following capillary electrophoresis. The observed heterozygosities were 0.67, 0.77, 0.82, 0.61, 0.62, 0.73, 0.78, 0.81 and 0.74, respectively, and the combined discrimination power of the nineplex was 0.9999999991. None of the nine loci deviated from Hardy-Weinberg equilibrium expectations using the chi-square test, homozygosity test, likelihood ratio test and exact test after the grouping of the alleles. The nine STR loci allele frequencies were significantly different from those of other ethnic populations.

Evaluation of the paternity probability on an application of minisatellite variant repeat mapping using polymerase chain reaction (MVR-PCR) to paternity testing.

Minisatellite variant repeat (MVR) mapping using polymerase chain reaction (PCR) was applied to a practical case of paternity testing to evaluate the paternity probability. In order to obtain single allele mapping by allele-specific MVR-PCR, three flanking polymorphic sites for each of the MS31A and MS32 loci were investigated and all three individuals were typed as heterozygous for at least one flanking polymorphic site at each locus. Allele-specific MVR-PCR was then performed using genomic DNA. It was confirmed that one allele in the child was identical to that from the mother and the other one in the child was identical to that from the alleged father. Mapped allele codes were also compared with those in the database by dot-matrix analysis, and no identical allele was found although some motifs were shared with Japanese alleles. The paternity index and the probability of paternity exclusion in the case at these two MVR loci were calculated using the presumed values of the allele frequencies. These studies seem to illustrate the practical value of MVR mapping of MS31A and MS32 loci in paternity testing.

Experimental group A rotaviral infection in cynomolgus monkeys raised on formula diet.

Rotaviral infections in cynomolgus monkeys (Macaca fasicularis) were studied to ascertain its suitability as a model of infection and diarrhea caused by group A human rotaviruses. Formula-fed monkeys were used as they could be observed closely. Experimental rotaviral infection of cynomolgus monkeys was age-dependent; only young monkeys were readily infected. Formula-fed newborns were readily infected with cell-culture-adapted human (WA) and simian (SA11) viruses and with a rotavirus from a human fecal specimen. However, diarrhea was detected only in very young animals. A number of rotaviral shedding patterns as a function of time were observed. Although there was no typical viral shedding pattern which represented exclusive association of viral infection with diarrhea, the initial level of viral excretion and the maximum level of viral shedding attained were much higher in animals with diarrhea. Seroconversion occurred in less than half of the inoculated animals. The presence of maternal rotaviral antibodies did not prevent infection or diarrhea.

Lyt phenotype and H-2 compatibility requirements of effector cells in the delayed-type hypersensitivity response to dengue virus infection.

The nature of effector cells which mediate delayed-type hypersensitivity (DTH) to dengue type 2 virus and the influence of the H-2 complex on the cellular transfer of DTH was investigated. The DTH effector cells appeared to consist of two types of T cells, one Lyt-1.1+, the other Lyt-2.1+ or, alternatively, an interaction between these two T cell subsets may be required for maximal expression of DTH. Cellular transfer of DTH reactivity also required compatibility at the K and D or I region of the H-2 complex. Compatibility at the D region alone was not sufficient for transfer of DTH. The significance and implications of these findings are discussed.