Effects of Creative Thinking and Its Personality Determinants on Negative Emotion Regulation.

This study investigated the relationship between creativity and negative emotion, and the effects of integrating creative insight into the reappraisal process on negative emotions. In Study 1, participants' creativity and baseline anxiety levels were measured; then anxiety was induced, and anxiety levels were reassessed. In Study 2, participants wrote about past negative events and then completed the positive and negative affect schedule. They were split into three groups (insight reappraisal, simple reappraisal, or control groups); each of them received a separate intervention, and then they completed positive and negative affect schedule again. In Study 3, participants were randomly assigned to insight reappraisal or control groups; apart from measuring cognitive changes, the procedures were identical to Study 2. All participants were undergraduate students. Results showed that flexibility, originality, risk-taking, and complexity are negatively correlated with anxiety, and that insight reappraisal can induce insight experience and enhance cognitive changes, and reduce negative emotional responses. Therefore, integrating creative insight into the reappraisal process can enhance its effectiveness in reducing negative emotions.

Long-reach 60-GHz MMWoF link with free-running laser diodes beating.

With the remote beating of two mutually incoherent laser carriers, the local-oscillator-free long-reach millimeter-wave over fiber (MMWoF) link at 60-GHz band is demonstrated. The unique schemes of the proposed MMWoF are the wavelength-locked colorless laser diode (CLD) modulator, the mutually incoherent optical carrier for heterodyne MMW generation, and the square-law power envelope detection at receiving end. By directly encoding the single-mode with the CLD modulator, the single-carrier modulated QAM-OFDM data is achieved to release the RF power fading after fiber transmission. The mutually incoherent laser beating enables the optical heterodyne MMW generation with two independent optical carriers, which provides the advantages of local-oscillator-free operation and rules out the requirement of dual-mode optical carrier delivery from central office. At the wireless receiving end, the received QAM-OFDM data is self-down-converted to the baseband by employing the square-law power envelope detection. This eliminates the requirement of local oscillator and rules out the influence of the MMW carrier frequency fluctuation between two mutually incoherent lasers (used at central office and remote node), which effectively provides the MMW carrier immunity against the down-conversion instability caused by clock jitter or carrier incoherence. This architecture ensures the transmission of 16.5-Gbit/s 32-QAM OFDM data over 50 km in SMF and 3 m in free-space with the FEC certificated error vector magnitude of 12%, signal-to-noise ratio (SNR) of 18.4 dB, and bit error rate of 3.8 × 10-3. For multi-channel DWDM-PON applications, the proposed local-oscillator-free MMWoF link can successfully perform 11 DWDM channels of 32-QAM OFDM data access at 16.5 Gbit/s per channel via the wavelength controlling of the CLD modulation stage and the detuning of the beating carrier at remote node.

On channel estimation schemes for APD-based DDM-OFDM-PONs under sub-Nyquist sampling.

Implementing preprocessing in a delay-division multiplexing (DDM) orthogonal frequency-division multiplexing (OFDM) passive optical network (PON) requires a priori knowledge of channel responses, which need to be estimated under the constraint of sub-Nyquist analog-to-digital sampling. The localized approach allocates subcarriers in different frequency zones to training symbols in different time slots for channel estimation without spectral overlap. Unfortunately, the localized scheme is susceptible to inaccurate estimation when using an avalanche photodiode (APD), due to variations in APD saturation associated with different training symbols. Instead of localizing all subcarriers of a training symbol in a single frequency zone, we propose distributing training subcarriers through various frequency zones. This distributed scheme would prevent spectral overlap and also reduce the degree of variation in APD saturation, thereby improving the accuracy of channel estimation. Alternatively, we propose an orthogonal scheme in which each training symbol uses all of the subcarriers simultaneously. The orthogonality specified among consecutive training symbols should make it possible to estimate the channel response with low computational complexity. We conducted experiments to compare various schemes used for channel estimation in a 25-Gbps APD-based OFDM-PON. Our results revealed that the orthogonal scheme achieved the best results, and the localized scheme provided the worst channel estimates. We demonstrate the application of the orthogonal scheme in a penalty-free DDM system at 1/32 of the Nyquist rate, which provided a loss budget of 28 dB after fiber transmission over a distance of 25 km.

DFT/IDFT-free receiving scheme for spread-OFDM signals employing low-sampling-rate ADCs.

This paper presents a DFT/IDFT-free receiving scheme for spread-OFDM signals. Leveraging sub-Nyquist sampling and proper sampling delay, the proposed scheme enables each user to receive the requested data without the need for DFT and IDFT; thus, the complexity at receiver can be greatly reduced. Nonetheless, DC component is altered in an AC coupling system, such that severe waveform distortion is caused when the process of DFT/IDFT is omitted. Thus, a DC-zeroing algorithm is proposed to guarantee constant DC after sub-Nyquist sampling, thereby eliminating such distortion. To experimentally verify the concept of proposed scheme, a 27.15-Gbit/s optical spread-OFDM signal was transmitted over fiber and received by the DFT/IDFT-free scheme with sub-Nyquist sampling. More users will reduce the required sampling rate at receiver; for the case of 16 users, the required sampling rate for the 27.15-Gbit/s signal is as low as 1 GSample/s. The experimental results show that error-free transmission was achievable, and the penalty due to lowering sampling rate (i.e., increasing the number of users) is insignificant.

V-band gapless OFDM RoF system with power detector down-conversion and novel Volterra nonlinear filtering.

This Letter presents a V-band gapless orthogonal frequency division multiplexing (OFDM) RoF system at 60 GHz employing a power detector to support vector signal down-conversion. Additional RF tone is generated and transmitted from a central station to replace the local oscillator at a wireless receiver for power detector down-conversion. To enhance the spectrum efficiency, the gap between the OFDM signal and the RF tone is not needed. However, the down-converted signal will suffer signal-to-signal interference (SSBI). In this Letter, we propose and successfully employ a novel Volterra nonlinear compensation to mitigate SSBI, resulting in a 22% data rate improvement with a bit-loading algorithm.

60-GHz Millimeter-wave Over Fiber with Directly Modulated Dual-mode Laser Diode.

A directly modulated dual-mode laser diode (DMLD) with third-order intermodulation distortion (IMD3) suppression is proposed for a 60-GHz millimeter-wave over fiber (MMWoF) architecture, enabling new fiber-wireless communication access to cover 4-km single-mode-fiber (SMF) and 3-m wireless 16-QAM OFDM transmissions. By dual-mode injection-locking, the throughput degradation of the DMLD is mitigated with saturation effect to reduce its threshold, IMD3 power and relative intensity noise to 7.7 mA, -85 dBm and -110.4 dBc/Hz, respectively, providing huge spurious-free dynamic range of 85.8 dB/Hz(2/3). This operation suppresses the noise floor of the DMLD carried QPSK-OFDM spectrum by 5 dB. The optical receiving power is optimized to restrict the power fading effect for improving the bit error rate to 1.9 × 10(-3 )and the receiving power penalty to 1.1 dB. Such DMLD based hybrid architecture for 60-GHz MMW fiber-wireless access can directly cover the current optical and wireless networks for next-generation indoor and short-reach mobile communications.

W-band OFDM Radio-over-Fiber system with power detector for vector signal down-conversion.

This Letter proposes a W-band OFDM RoF system at 103.5 GHz employing power detector to support vector signal down-conversion. Additional RF tone is generated and transmitted from central office to replace the local oscillator at a wireless receiver. With a proper frequency gap and power ratio between the RF tone and the OFDM-modulated signal, the impact from signal-to-signal beating interference can be minimized. The data rate can achieve a 40 Gbps 16 QAM OFDM signal over 25 km fiber and 2 m wireless transmission.

60-GHz optical/wireless MIMO system integrated with optical subcarrier multiplexing and 2x2 wireless communication.

This paper proposes a 2x2 MIMO OFDM Radio-over-Fiber scheme based on optical subcarrier multiplexing and 60-GHz MIMO wireless transmission. We also schematically investigated the principle of optical subcarrier multiplexing, which is based on a dual-parallel Mach-Zehnder modulator (DP-MZM). In our simulation result, combining two MIMO OFDM signals to drive DP-MZM gives rise to the PAPR augmentation of less than 0.4 dB, which mitigates nonlinear distortion. Moreover, we applied a Levin-Campello bit-loading algorithm to compensate for the uneven frequency responses in the V-band. The resulting system achieves OFDM signal rates of 61.5-Gbits/s with BER of 10(-3) over 25-km SMF transmission followed by 3-m wireless transmission.

Photodecomposition of volatile organic compounds using TiO2 nanoparticles.

This study examined the photodecomposition of volatile organic compounds (VOCs) using TiO2 catalyst fabricated by the Submerged Arc Nanoparticle Synthesis System (SANSS). TiO2 catalyst was employed to decompose volatile organic compounds and compare with Degussa-P25 TiO2 in terms of decomposition efficiency. In the electric discharge manufacturing process, a Ti bar, applied as the electrode, was melted and vaporized under high temperature. The vaporized Ti powders were then rapidly quenched under low-temperature and low-pressure conditions in deionized water, thus nucleating and forming nanocrystalline powders uniformly dispersed in the base solvent. The average diameter of the TiO2 nanoparticles was 20 nm. X-ray diffraction analysis confirmed that the nanoparticles in the deionized water were Anatase type TiO2. It was found that gaseous toluene exposed to UV irradiation produced intermediates that were even harder to decompose. After 60-min photocomposition, Degussa-P25 TiO2 reduced the concentration of gaseous toluene to 8.18% while the concentration after decomposition by SANSS TiO2 catalyst dropped to 0.35%. Under UV irradiation at 253.7 +/- 184.9 nm, TiO2 prepared by SANSS can produce strong chemical debonding energy, thus showing great efficiency, superior to that of Degussa-P25 TiO2, in decomposing gaseous toluene and its intermediates.