RESUMO
Visible and near-infrared spectrum photonic integrated circuits are quickly becoming a key technology to address the scaling challenges in quantum information and biosensing. Thus far, integrated photonic platforms in this spectral range have lacked integrated photodetectors. Here, we report silicon nitride-on-silicon waveguide photodetectors that are monolithically integrated in a visible light photonic platform on silicon. Owing to a leaky-wave silicon nitride-on-silicon design, the devices achieved a high external quantum efficiency of >60% across a record wavelength span from λ ~ 400 nm to ~640 nm, an opto-electronic bandwidth up to 9 GHz, and an avalanche gain-bandwidth product up to 173 ± 30 GHz. As an example, a photodetector was integrated with a wavelength-tunable microring in a single chip for on-chip power monitoring.
RESUMO
Low-loss broadband fiber-to-chip coupling is currently challenging for visible-light photonic-integrated circuits (PICs) that need both high confinement waveguides for high-density integration and a minimum feature size above foundry lithographical limit. Here, we demonstrate bi-layer silicon nitride (SiN) edge couplers that have ≤ 4 dB/facet coupling loss with the Nufern S405-XP fiber over a broad optical wavelength range from 445 to 640 nm. The design uses a thin layer of SiN to expand the mode at the facet and adiabatically transfers the input light into a high-confinement single-mode waveguide (150-nm thick) for routing, while keeping the minimum nominal lithographic feature size at 150 nm. The achieved fiber-to-chip coupling loss is about 3 to 5 dB lower than that of single-layer designs with the same waveguide confinement and minimum feature size limitation.
RESUMO
Gourd-shaped hole array germanium (Ge) vertical p-i-n photodiodes were designed and demonstrated on a germanium-on-insulator (GOI) substrate with the excellent responsivity of 0.74 A/W and specific detectivity of 3.1 × 1010 cm·Hz1/2/W. It is calculated that the gourd-shaped hole design provides a higher optical absorption compared to a cylinder-shaped hole design. As a result, the external quantum efficiency for the gourd-shaped hole array photodetector was enhanced by â¼2.5× at 1,550 nm, comparing with hole-free array photodetectors. In addition, the extracted specific detectivity is superior to that of commercial bulk Ge photodiodes. The 3-dB bandwidth for the hole array photodetectors is improved by â¼10% due to a lower device capacitance. This work paves the way for low-cost and high-performance CMOS compatible photodetectors for Si-based photonic-integrated circuits.
RESUMO
Germanium (Ge)-based photodetectors have become one of the mainstream components in photonic-integrated circuits (PICs). Many emerging PIC applications require the photodetectors to have high detectivity and low power consumption. Herein, we demonstrate high-detectivity Ge vertical p-i-n photodiodes on an in-situ heavily arsenic (As)-doped Ge-on-Si platform. The As doping was incorporated during the initial Ge-on-Si seed layer growth. The grown film exhibits an insignificant up-diffusion of the As dopants. The design results in a â¼45× reduction on the dark current and consequently a â¼5× enhancement on the specific detectivity (D*) at low reverse bias. The improvements are mainly attributed to the improved epi-Ge crystal quality and the narrowing of the device junction depletion width. Furthermore, a significant deviation on the AsH3 flow finds a negligible effect on the D* enhancement. This unconventional but low-cost approach provides an alternative solution for future high-detectivity and low-power photodiodes in PICs. This method can be extended to the use of other n-type dopants (e.g., phosphorus (P) and antimony (Sb)) as well as to the design of other types of photodiodes (e.g., waveguide-integrated).
RESUMO
Germanium (Ge) vertical p-i-n photodetectors were demonstrated with an ultra-low dark current of 0.57 mA/cm2 at -1 V. A germanium-on-insulator (GOI) platform with a 200-mm wafer scale was realized for photodetector fabrication via direct wafer bonding and layer transfer techniques, followed by oxygen annealing in finance. A thin germanium-oxide (GeOx) layer was formed on the sidewall of photodetectors by ozone oxidation to suppress surface leakage current. The responsivity of the vertical p-i-n annealed GOI photodetectors was revealed to be 0.42 and 0.28 A/W at 1,500 and 1,550 nm at -1 V, respectively. The photodetector characteristics are investigated in comparison with photodetectors with SiO2 surface passivation. The surface leakage current is reduced by a factor of 10 for photodetectors via ozone oxidation. The 3dB bandwidth of 1.72 GHz at -1 V for GeOx surface-passivated photodetectors is enhanced by approximately 2 times compared to the one for SiO2 surface-passivated photodetectors. The 3dB bandwidth is theoretically expected to further enhance to â¼70 GHz with a 5 µm mesa diameter.
RESUMO
We introduced photon-trapping microstructures into GeSn-based photodetectors for the first time, and achieved high-efficiency photo detection at 2 µm with a responsivity of 0.11 A/W. The demonstration was realized by a GeSn/Ge multiple-quantum-well (MQW) p-i-n photodiode on a GeOI architecture. Compared with the non-photon-trapping counterparts, the patterning and etching of photon-trapping microstructure can be processed in the same step with mesa structure at no additional cost. A four-fold enhancement of photo response was achieved at 2 µm. Although the incorporation of photo-trapping microstructure degrades the dark current density which increases from 31.5 to 45.2 mA/cm2 at -1 V, it benefits an improved 3-dB bandwidth of 2.7 GHz at bias voltage at -5 V. The optical performance of GeSn/Ge MQW photon-trapping photodetector manifests its great potential as a candidate for efficient 2 µm communication. Additionally, the underlying GeOI platform enables its feasibility of monolithic integration with other photonic components such as waveguide, modulator and (de)multiplexer for optoelectronic integrated circuits (OEICs) operating at 2 µm.