New Technology of Mechanical Cavitation in a Coal Seam to Promote Gas Extraction.

Realizing efficient gas drainage in low permeability coal seams has always been a difficult problem for coal miners. Based on this, this paper proposes a new technology of large-diameter mechanical cave-making to promote gas extraction in a coal seam. This technology mainly uses the pressure of a water injection pump to control the automatic opening and closing of a mechanical reaming device to realize mechanical cavitation, and the hole diameter can reach up to 500 mm. The gas drainage effect of mechanical cavitation drilling is analyzed by a numerical simulation, which shows that under the condition of the same drainage time, the larger the cavitation radius is, the larger the effective influence radius of gas drainage is. According to the field test results, the time of single cave-making is about 5 min, and the speed of cave-making is fast. The coal output of a single cave is 0.42 t/m, and the pressure relief effect is obvious. Compared with ordinary drilling, the gas drainage concentration of mechanical cavitation drilling is increased by 2 times and the net amount of drainage is increased by 1.8 times. Large-diameter mechanical cavitation technology can better improve the gas drainage effect of outburst coal seams with low permeability and has a good application prospect.

Numerical Simulation of Integrated Mechanics of Drilling and Mechanical Cavitation in Coal Seam.

For coal and gas outburst and difficult extraction in soft, low-permeability, and high-gas seam, the integration technology of drilling and mechanical cavitation is put forward to relieve pressure and improve permeability of coal seam. Through the test of mechanical parameters of the coal body, the physical model of drilling and cave-making in coal seam is established, and the mechanical characteristics of drilling and mechanical cavitation are simulated numerically. The results show that the peak strength of coal increases linearly with confining pressure. When the drill bit just touches the coal, the maximum stress occurs at the center of the coal sample. With the increase in the drilling depth of the drill bit, the maximum stress point shifts to the depth. When the coal at the center of the sample is broken, the position of the maximum stress shifts to the surrounding. With the increase of drilling depth, the maximum contact number between the drill bit and coal body increases sharply. When the bit body basically enters the coal body, the maximum contact number between the drill bit and coal body remains unchanged. When the drill pipe rotates, the reaming tool collides with the hole wall at the reaming position on the axis. In general, the contact area increases with the opening of the reaming tool, but the contact between the reaming tool and the hole wall is random. As time increases, the contact force begins to increase and then basically stabilizes; at this time the reaming tool has been fully opened.