Modeling the buffer capacity of ingredients in salad dressing products.

The pH of most acid food products depends on undefined and complex buffering of ingredients but is critically important for regulatory purposes and food safety. Our objective was to define the buffer capacity (BC) of ingredients in salad dressing products. Ingredients of salad dressings were titrated individually and in combination using concentrations typical of dressing products. Titration curves from pH 2 to 12 were generated with sodium hydroxide and hydrochloric acid, which were then used to generate BC curves. A matrix of concentration and pK values for a series of monoprotic buffers approximated the pH of each ingredient. Some buffer series required anion or cation corrections for accurate pH prediction, possibly due to the presence of salts of acid or bases. Most buffers had BC values less than 10-fold the BC of acetic acid (0.25 ß) typically in dressing formulations and had little influence on the final product pH of the dressings tested. Unexpectedly, we found that sugars in dressing formulations, including sucrose or corn syrup, exhibited buffering at pH values greater than 11 (0.035 ß and 0.059 ß, respectively), which was likely due to weakly acidic hydroxyl groups on the sugar molecules. However, the concentration and pK for buffers above pH 11 or below pH 2 were difficult to quantify due to the BC of water. The BC data may help to quantify the effects of salad dressing ingredients on the final product pH and benefit regulatory agencies and manufacturers in assessing product pH and safety. PRACTICAL APPLICATION: Buffer capacity data for salad dressing ingredients may help determine the influence ingredient addition will have on the final pH of a salad dressing product. The addition of low acid ingredients with little or no buffering may not significantly alter pH. The modeling method may be useful for regulatory purposes to estimate the effects of low acid ingredients on pH changes for food safety and may also be useful for product development of acid and acidified foods.

Modeling buffer capacity and pH in acid and acidified foods.

Standard ionic equilibria equations may be used for calculating pH of weak acid and base solutions. These calculations are difficult or impossible to solve analytically for foods that include many unknown buffering components, making pH prediction in these systems impractical. We combined buffer capacity (BC) models with a pH prediction algorithm to allow pH prediction in complex food matrices from BC data. Numerical models were developed using Matlab software to estimate the pH and buffering components for mixtures of weak acid and base solutions. The pH model was validated with laboratory solutions of acetic or citric acids with ammonia, in combinations with varying salts using Latin hypercube designs. Linear regressions of observed versus predicted pH values based on the concentration and pK values of the solution components resulted in estimated slopes between 0.96 and 1.01 with and without added salts. BC models were generated from titration curves for 0.6 M acetic acid or 12.4 mM citric acid resulting in acid concentration and pK estimates. Predicted pH values from these estimates were within 0.11 pH units of the measured pH. Acetic acid concentration measurements based on the model were within 6% accuracy compared to high-performance liquid chromatography measurements for concentrations less than 400 mM, although they were underestimated above that. The models may have application for use in determining the BC of food ingredients with unknown buffering components. Predicting pH changes for food ingredients using these models may be useful for regulatory purposes with acid or acidified foods and for product development. PRACTICAL APPLICATION: Buffer capacity models may benefit regulatory agencies and manufacturers of acid and acidified foods to determine pH stability (below pH 4.6) and how low-acid food ingredients may affect the safety of these foods. Predicting pH for solutions with known or unknown buffering components was based on titration data and models that use only monoprotic weak acids and bases. These models may be useful for product development and food safety by estimating pH and buffering capacity.