A systematic investigation of external lubrication of mini-tablets on a rotary tablet press with focus on the tensile strength.

External lubrication is an alternative to internal lubrication and its related detrimental effects on properties of tablets like tensile strength (TS). However, to date there are hardly any systematic investigations on external lubrication of mini-tablets on rotary tablet presses. Aim of this study was the systematic investigation of the impact of parameters tableting pressure, tableting speed, dosing rate and air pressure on the TS of mini-tablets. Both studies, the Central Composite Design (CCD) with SMCC 90 and the subsequently executed D-optimal design with SMCC 50, exhibited that tableting pressure had the highest positive effect on TS. Tableting speed and dosing rate in the CCD presumably did not seem to influence the TS, air pressure represented a positive coefficient. An additional temporal factor seemed to impact the results, deduced from the negative effect of the experimental order on TS in the CCD and from the negative correlation along the execution order in the residual plots. Additional long runs support findings of a non-linear decrease of TS over time. An interplay between dosing rate level and performance of the dust extraction collector is assumed, making more magnesium stearate available in the tablet press and potentially causing gradual contamination of the powder over time.

Challenges in the transfer and scale-up of mini-tableting: Case study with losartan potassium.

Mini-tablets (MTs) with losartan potassium were developed to treat the rare disease Epidermolysis Bullosa. The focus was placed on transfer and scale-up of a direct compressible formulation from the compaction simulator STYL'One Evo (CS) to the rotary tablet press Korsch XM 12 (RP). Transfer of tabletability and compactibility profiles from CS to RP did not show good agreement, e.g. at a tableting pressure of 125 MPa mean tensile strengths (TS) of 4 MPa on CS and 1-1.5 MPa on RP were reached. These results highlight the impact of the feed frame on final product qualities depending on process and material factors. In the scale-up studies the critical quality attributes (CQAs) mass variation, content uniformity, TS and disintegration time were investigated. After an appropriate run-up time, most CQAs reached a plateau, after reaching a balance between influx, efflux and distribution of lubricant in the feed frame. TS values of 1-2 MPa, disintegration times of max. 50 s, mass variation of 0.9-2.2 % (CV) and acceptance values below 15.0 were reached depending on chosen process parameters.