RESUMO
Improvement of electrochemical technologies is one of the most popular topics in the field of renewable energy. However, this process requires a deep understanding of the electrode-electrolyte interface behavior under operando conditions. X-ray absorption spectroscopy (XAS) is widely employed to characterize electrode materials, providing element-selective oxidation state and local structure. Several existing cells allow studies as close as possible to realistic operating conditions, but most of them rely on the deposition of the electrodes on conductive and X-ray transparent materials, from where the radiation impinges the sample. In this work, we present a new electrochemical flow-cell for operando XAS that can be used with X-ray opaque substrates, since the signal is effectively detected from the electrode surface, as the radiation passes through a thin layer of electrolyte (â¼17 µm). The electrolyte can flow over the electrode, reducing bubble formation and avoiding strong reactant concentration gradients. We show that high-quality data can be obtained under operando conditions, thanks to the high efficiency of the cell from the hard X-ray regime down to â¼4 keV. We report as a case study the operando XAS investigation at the Fe and Ni K-edges on Ni-doped γ-Fe2O3 films, epitaxially grown on Pt substrates. The effect of the Ni content on the catalytic performances for the oxygen evolution reaction is discussed.
RESUMO
Water adsorption and dissociation on undoped and Ti-doped hematite thin films were investigated using near-ambient pressure photoemission and DFT calculations. A fine understanding of doping effects is of prime importance in the framework of photoanode efficiency in aqueous conditions. By comparison to pure Fe2O3 surface, the Ti(2%)-Fe2O3 surface shows a lower hydroxylation level. We demonstrate that titanium induces wide structural modifications of the surface, preventing it from reaching full hydroxylation.
RESUMO
Multiferroic biphase systems with robust ferromagnetic and ferroelectric response at room temperature would be ideally suitable for voltage-controlled nonvolatile memories. Understanding the role of strain and charges at interfaces is central for an accurate control of the ferroelectricity as well as of the ferromagnetism. In this paper, we probe the relationship between the strain and the ferromagnetic/ferroelectric properties in the layered CoFe2O4/BaTiO3 (CFO/BTO) model system. For this purpose, ultrathin epitaxial bilayers, ranging from highly strained to fully relaxed, were grown by molecular beam epitaxy on Nb:SrTiO3(001). The lattice characteristics, determined by X-ray diffraction, evidence a non-intuitive cross-correlation: the strain in the bottom BTO layer depends on the thickness of the top CFO layer and vice versa. Plastic deformation participates in the relaxation process through dislocations at both interfaces, revealed by electron microscopy. Importantly, the switching of the BTO ferroelectric polarization, probed by piezoresponse force microscopy, is found dependent on the CFO thickness: the larger is the latter, the easiest is the BTO switching. In the thinnest thickness regime, the tetragonality of BTO and CFO has a strong impact on the 3d electronic levels of the different cations, which were probed by X-ray linear dichroism. The quantitative determination of the nature and repartition of the magnetic ions in CFO, as well as of their magnetic moments, has been carried out by X-ray magnetic circular dichroism, with the support of multiplet calculations. While bulklike ferrimagnetism is found for 5-15 nm thick CFO layers with a magnetization resulting as expected from the Co2+ ions alone, important changes occur at the interface with BTO over a thickness of 2-3 nm because of the formation of Fe2+ and Co3+ ions. This oxidoreduction process at the interface has strong implications concerning the mechanisms of polarity compensation and coupling in multiferroic heterostructures.
