Analysis of DDT and its metabolites in soil and water samples obtained in the vicinity of a closed-down factory in Bangladesh using various extraction methods.

This study was conducted to monitor the spread of dichlorodiphenyltrichloroethane (DDT) and its metabolites (dichlorodiphenyldichloroethylene (DDE), dichlorodiphenyldichloroethane (DDD)) in soil and water to regions surrounding a closed DDT factory in Bangladesh. This fulfillment was accomplished using inter-method and inter-laboratory validation studies. DDTs (DDT and its metabolites) from soil samples were extracted using microwave-assisted extraction (MAE), supercritical fluid extraction (SFE), and solvent extraction (SE). Inter-laboratory calibration was assessed by SE, and all methods were validated by intra- and inter-day accuracy (expressed as recovery %) and precision (expressed as relative standard deviation (RSD)) in the same laboratory, at three fortified concentrations (n = 4). DDTs extracted from water samples by liquid-liquid partitioning and all samples were analyzed by gas chromatography (GC)-electron capture detector (ECD) and confirmed by GC/mass spectrometry (GC/MS). Linearities expressed as determination coefficients (R (2)) were ≥0.995 for matrix-matched calibrations. The recovery rate was in the range of 72-120 and 83-110%, with <15% RSD in soil and water, respectively. The limit of quantification (LOQ) was 0.0165 mg kg(-1) in soil and 0.132 µg L(-1) in water. Greater quantities of DDTs were extracted from soil using the MAE and SE techniques than with the SFE method. Higher amounts of DDTs were discovered in the southern (2.2-936 × 10(2) mg kg(-1)) or southwestern (86.3-2067 × 10(2) mg kg(-1)) direction from the factory than in the eastern direction (1.0-48.6 × 10(2) mg kg(-1)). An exception was the soil sample collected 50 ft (15.24 m) east (2904 × 10(2) mg kg(-1)) of the factory. The spread of DDTs in the water bodies (0.59-3.01 µg L(-1)) was approximately equal in all directions. We concluded that DDTs might have been dumped randomly around the warehouse after the closing of the factory.

Identification of volatile organic compounds generated from healthy and infected powdered chili using solvent-free solid injection coupled with GC/MS: application to adulteration.

To investigate adulteration in commercial chili powder, the volatile organic compounds of healthy and infected powdered chili pepper were characterized using a solvent-free solid injector (SFSI) coupled with gas chromatography/mass spectrometry (GC/MS). Except for one compound (capillary compound for blank), 43 compounds were identified in healthy and infected chili powder. Specifically, 31, 36, and 41 compounds were identified in healthy, medium-infected, and severely infected chili powder. Among these compounds, acetic acid (13.77%), propanal (2.477%), N-methylpyrrole (1.986%), and 2-methyl-propanal (1.768%) were leading volatiles in the healthy chili powder. In contrast, infected chili powder contained 9,12-octadecadienoic acid, ethyl ester (15.984%), acetic acid (11.249%), hexadecanoic acid, methyl ester (3.3%), N-methylpyrrole (3.221%), and 2-furanmethanol (2.629%) as major compounds. Trimethylamine and isosorbide were detected in both medium and severely infected chili, but not in healthy chili. This means that these compounds could be used as biomarkers to distinguish between healthy and infected chili. The proposed technique was applied to 12 commercial chili powders, and trimethylamine and isosorbide were detected in six samples. These results suggest that a contaminated chili that was added to a healthy one could be successfully identified by a combination of the SFSI and GC/MS.

Inert matrix and Na 4 EDTA improve the supercritical fluid extraction efficiency of fluoroquinolones for HPLC determination in pig tissues.

A supercritical fluid extraction method combined with high-performance liquid chromatography-fluorescence detection was developed for the determination of enrofloxacin, danofloxacin, and ciprofloxacin in pig muscle, lung, and kidney samples. The optimal SFE conditions were 80 degrees C, 300 kg/cm(2), 30% methanol for 40 min as a dynamic extraction time, in addition to 0.2g Na(4)EDTA and 7.0 g sea sand in the extraction vessel. The use of Na(4)EDTA and sea sand on SFE extraction resulted in improvement of the recoveries of ciprofloxacin, a polar and hydrophilic compound, as well as enrofloxacin and danofloxacin. Overall, the recoveries ranged from 86.7 to 113.1% using the Na(4)EDTA/sea sand-assisted SFE extraction method. The Na(4)EDTA/sea sand-assisted SFE-HPLC-FLD validated method was successfully carried out in pig tissues, and proved to be specific, sensitive, reliable, and accurate. The method was also applied satisfactorily for accurate quantitative residue analysis in incurred pig tissues.

Persistent organohalogen contaminants in plasma from groups of humans with different occupations in Bangladesh.

The present study is aimed to assess persistent organic halogenated pollutants in humans living in Bangladesh. The results are compared to other similar studies in the region and globally. Human blood plasma were collected from groups of men and women with different occupations, i.e. being students, garment industry workers, employees at the Power Development Board (PDB), all groups in Dhaka, fishermen and fishermen wife's from Dhaka and another group from Barisal district. The plasma was analysed for hexachlorobenzene (HCB), the hexachlorocyclohexane isomers, alpha-HCH, beta-HCH, gamma-HCH and delta-HCH, the DDT group of chemicals, chlordane compounds, trans-chlordane, cis-chlordane, oxychlordane, trans-nonachlor, trans-heptachlorepoxide, methoxychlor and mirex. The most abundant contaminant, in all groups studied, p,p'-DDE is dominating, with p,p'-DDT/Sigma DDT ratios indicating recent and ongoing DDT exposure. Among the other pesticides analysed beta-HCH is the most abundant indicating the use of technical HCH products instead of Lindane (gamma-HCH). While the Sigma DDT is present in the low ppm range the beta-HCH is detected in up to approx. 400 ppb, lipid basis. The beta-HCH is most abundant in the groups of students. In contrast to the pesticides analysed very low concentrations of polychlorinated biphenyls (PCB) are present in all study groups, with e.g. CB-153 in the range of 5-30 ng g(-1) fat. The concentrations of the DDT group of chemical differ significantly between fishermen and fishermen's wives living and working in the Dhaka area versus those living and working in Barisal. Also, fishermen and their wives had significantly different concentrations of DDT compared to garment industry workers.

Analytical procedure to simultaneously measure trace amounts of trenbolone acetate and beta-trenbolone residues in porcine muscle using HPLC-UVD and MS.

The current study was undertaken to validate the performance for the determination of both TBA and beta-trenbolone (beta-TB) residues in porcine muscle at concentrations required to monitor compliance with the maximum residue limit (MRL). The method involves a one phase liquid-liquid extraction, cleanup with low-temperature fat precipitation, separation of the respective compounds by HPLC on a Capcell pak C(18) column, use of a methanol-water isocratic system as an eluent, and measurement by UV absorbance detection at 340 nm. Both compounds were confirmed using LC-MS/MS with electrospray interface (ESI) and a triple quadrupole (QqQ) analyzer. The method was found to be precise and accurate, with a linearity range of 1-10 microg/kg (r(2) >0.973). The intra- and interday precision showed good reproducibility with RSDs < or =13.25%. The LODs were 0.12 and 0.22 microg/kg, and the LOQs were 0.37 and 0.66 microg/kg, for TBA and beta-TB, respectively. The applicability of the method was demonstrated by analyzing real samples collected from major cities in the Republic of Korea. No residues of the selected compounds were detected in any of the samples. The advantages of our method are that it is: selective, sensitive, requires a short time for analysis (13 min), and performs simple sample extraction and clean-up procedure with low-temperature fat precipitation as compared to the previously published methods.

Dissipation behavior of lufenuron, benzoylphenylurea insecticide, in/on Chinese cabbage applied by foliar spraying under greenhouse conditions.

Chinese cabbage has long been consumed as a staple food by the Koreans in various forms of fresh, salted, or fermented as kimchi. To fulfill the off-season demand for this crop, it has become a common practice to be cultivated under greenhouse conditions. Since pesticide residues in/on leafy vegetables have strongly concerned with food safety in the Korean society, the changes of lufenuron residues, in/on Chinese cabbage applied by foliar spraying under greenhouse conditions was investigated. Lufenuron 5% emulsifiable concentrate (EC) was sprayed with diluted solution of recommended and double doses to the crop. The shoots of the cabbage were harvested immediately after spraying, and sequentially the harvests were conveyed to analyze the residual amounts. The deposited level of the analyte in/on Chinese cabbage under greenhouse conditions seemed to be difficult to produce the crop with 0.2 ppm of maximum residue limit (MRL) of the Korea Food and Drug Administration (KFDA).

Development of extraction procedures for the determination of imidacloprid: application to residue analysis and dynamics of two formulations in Chinese cabbage.

This study was undertaken to investigate whether an additional column clean-up procedure can affect the accuracy of an analytical method developed for the determination of imidacloprid residues in Chinese cabbage. Thereafter, the residue levels and the degradation rates of imidacloprid were investigated in experimental Chinese cabbage plots after treatment with two different commercial formulations: emulsifiable concentrate (EC) and wettable powder (WP). The analyte was determined using high-performance liquid chromatography-ultraviolet detection (HPLC-UVD) and confirmed by high-performance liquid chromatography-mass spectrometry (HPLC-MS) in the select ion-monitoring mode. The mean recoveries ranged from 75.34 to 98.00% and 96.95 to 100.97%, with relative standard deviations of 0.86-4.14 and 1.22-3.52%, in samples treated with and without additional column clean-up procedures, respectively. The minimum detectable amount of imidacloprid was 4 ng, while the limits of detection and quantitation were 0.2 and 0.5 ppm, respectively. The degradation of pesticide was monitored throughout a period of 13 days under greenhouse conditions. Although the behaviors of the EC and WP formulations appear to be similar, the absolute residue levels obtained with EC and WP treatments differed slightly. When imidacloprid formulations were applied (as foliar treatments) according to the recommended rate, the final residues (13 days post-treatment) in Chinese cabbage were much lower than the maximum residue limit (MRL = 3.5 ppm) established by the Korean Food and Drug Administration. Taken together, our study suggests that the analysis of imidacloprid can be performed without an additional column clean-up procedure, and the decline curve and the residue levels in Chinese cabbage could change if the same active ingredient is used in different formulations.

Determination of Methoxyfenozide Residues in Water and Soil by Liquid Chromatography: Evaluation of its Environmental Fate Under Laboratory Conditions.

Pesticide residues play several key roles as environmental and food pollutants and it is crucial to develop a method for the rapid determination of pesticide residues in environments. In this study, a simple, effective, and sensitive method has been developed for the quantitative analysis of methoxyfenozide in water and soil when kept under laboratory conditions. The content of methoxyfenozide in water and soil was analyzed by first purifying the compound through liquid-liquid extraction and partitioning followed by florisil gel filtration. Upon the completion of the purification step the residual levels were monitored through high performance liquid chromatography (HPLC) using a UV absorbance detector. The average recoveries of methoxyfenozide from three replicates spiked at two different concentrations and were ranged from 83.5% to 110.3% and from 98.1% to 102.8% in water and soil, respectively. The limits of detection (LODs) and limits of quantitation (LOQs) were 0.004 vs. 0.012 ppm and 0.008 vs. 0.024 ppm, respectively. The method was successfully applied to evaluate the behavioral fate of a 21% wettable powder (WP) methoxyfenozide throughout the course of 14 days. A first-order model was found to accurately fit the dissipation of methoxyfenozide in water with and a DT50 value of 3.03 days was calculated from the fit. This result indicates that methoxyfenozide dissipates rapidly and does not accumulate in water.

Development and validation of a method for the analysis of cafenstrole and its metabolite in brown rice grains and rice straw using high-performance liquid chromatography.

The present work reports the extraction and clean-up procedures, as well as the chromatographic conditions developed, for the determination of cafenstrole and its metabolite (CHM-03) residues in brown rice grains and rice straw using HPLC-UV detection. The method makes use of an Apollo C(18) column and acetonitrile : water : acetic acid as a mobile phase for both cafenstrole and its metabolite in rice and rice straw. Using these conditions cafenstrole and its metabolite were resolved with a retention time (R(t)) of less than 14 min. The analytes were confirmed using positive atmospheric pressure ionization LC-MS with selected ion monitoring. The average recoveries of cafenstrole were found to be 87.0-92.5 and 87.6-88.3%. However, they ranged from 81.5 to 81.6% and from 76.1 to 78.5% for cafenstrole metabolite (CHM-03), in rice grains and rice straw, respectively, with relative standard deviations ranging from 1.4 to 6.6%. The limits of detection (LODs) of both cafenstrole and its metabolite were 0.002 and 0.02 ppm and 0.025 and 0.04 ppm, respectively. Field trials with recommended or double the recommended dose revealed that the herbicide could safely be recommended for application in rice and rice straw as no residues were detected in the harvest samples.