In vitro effect of low-fluoride toothpastes containing sodium trimetaphosphate on enamel erosion.

OBJECTIVE: To evaluate the effect of a low-fluoride dentifrice (LFD) containing sodium trimetaphosphate (TMP) on enamel erosion in vitro. DESIGN: Bovine enamel blocks (n=144) were selected by surface hardness (SH) and subjected to erosive challenges, in two sets of experiments for 2 and 5 days. Blocks were randomly assigned to groups treated with slurries (5mL/block, for 15s) of following dentifrices: Placebo (no fluoride or TMP); LFD (250ppm F); LFD plus 0.25, 0.5, or 1.0% TMP; and a commercial positive control (1,425ppm F). The erosive challenge was produced by immersion in a soft drink (pH 2.8) for 5min, four times/day, interspersed by immersion in artificial saliva for 1h. SH and surface wear were analyzed as response variables. Data were submitted to 2-way ANOVA, followed by Student-Newman-Keuls test (p<0.05). RESULTS: All groups treated with LFDs containing TMP had significantly lower enamel wear when compared with the other groups tested (p<0.001). Also, the LFDs containing TPM at lower concentrations promoted SH similar to the commercial positive control, both being significantly higher than the LFD without TMP and Placebo (p<0.001). CONCLUSION: The supplementation of LFDs with TMP is able to significantly increase the anti-erosive potential of these formulations in vitro.

In situ remineralizing effect of fluoride varnishes containing sodium trimetaphosphate.

OBJECTIVE: This study analyzed the effects of a fluoride (F) varnish supplemented with sodium trimetaphosphate (TMP) on the remineralization of caries-like lesions in situ. MATERIALS AND METHODS: Twelve subjects used palatal devices with demineralized enamel discs for 3 days, following a double-blind, crossover protocol. Test groups included placebo (no F or TMP), 5% NaF and 5% NaF/5% TMP varnishes. The percentage of surface hardness recovery (%SHR) and cross-sectional hardness (ΔKHN) were determined. RESULTS: Significant differences were observed among all varnishes regarding %SHR and ΔKHN. The highest %SHR and the lowest ΔKHN were seen for the 5% NaF/5% TMP varnish, followed by 5% NaF and placebo. CONCLUSION: The remineralizing effect of a 5% NaF varnish is significantly enhanced when associated with TMP. CLINICAL RELEVANCE: The reduction in the subsurface lesion area of enamel treated with the TMP-containing varnish implies that cavities would take longer to develop or might not develop at all depending on individual factors, resulting in lower net caries increments at individual and population levels.

Effect of fluoride gels supplemented with sodium trimetaphosphate on enamel erosion and abrasion: in vitro study.

OBJECTIVE: This in vitro study aims to evaluate the effect of low fluoride (F) gel associate sodium trimetaphosphate (TMP) on erosion with or without abrasion. DESIGN: Enamel blocks (4 mm × 4 mm) selected through surface hardness (SH) is divided into five groups (n=12): gel without F and TMP (placebo), gel containing 4500 ppm F (4500), gel containing 4500 ppm F plus TMP5% (4500 TMP5%), gel containing 9000 ppm F (9000), and gel containing 12,300 ppm F (acid gel). Those groups were additionally subdivided into conditions of erosion (Ero) and of erosion plus abrasion (Ero/Abra). The blocks have undergone a single application of gel on the first day of the study. The erosion challenge was produced by Sprite Zero for five minutes four times a day and abrasion was carried out by machine brushing for 15s. After the challenges, the surface hardness (%SH), wear and cross-sectional hardness (ΔKHN) were analyzed. The data were analyzed using a 2-way ANOVA test followed by a Student-Newman-Keuls (p<0.05). RESULTS: Lower values of %SH, wear and ΔKHN were observed for erosion challenge (p<0.001). The %SH was lower in groups treated with fluoride gels, differing in the placebo (p<0.05). With addition of TMP to the gel 4500, enamel wear was lower when compared with another groups (p<0.05). CONCLUSION: In vitro conditions, the 4500 5%TMP gel showed greatest effect against erosion and erosion/abrasion.

In vitro remineralizing effect of fluoride varnishes containing sodium trimetaphosphate.

This study analyzed the effects of fluoride varnishes supplemented with sodium trimetaphosphate (TMP) on the remineralization of caries-like lesions in vitro. Bovine enamel discs were selected through surface hardness (SH) and caries-like lesions were induced. SH was again determined and the blocks were divided into 7 experimental groups (n = 24/group): placebo (no fluoride or TMP), 5% TMP, 2.5% NaF, 2.5% NaF/5% TMP, 5% NaF, 5% NaF/5% TMP and commercial formulation (Duraphat™, 5% NaF), following a blind protocol. Discs were treated with the varnishes and kept in a remineralizing solution for 4 h and a demineralizing solution for 2 h. Varnishes were then removed and half of the discs were used for analysis of loosely (CaF2) and firmly bound fluoride. The remaining discs were submitted to a pH-cycling regimen for 6 days. The percentage of surface hardness recovery (%SHR), cross-sectional hardness (ΔKHN) and enamel CaF2 and fluoride were determined. Data were analyzed by ANOVA and by Student-Newman-Keuls' test (p < 0.05). A dose-response relationship was observed between fluoride concentrations in the varnishes and %SHR. The 5% TMP varnish led to %SHR similar to that obtained for the placebo. When TMP was used in association with fluoride, however, significantly higher %SHR were observed in comparison with their counterparts without TMP. Moreover, ΔKHN obtained for the 5% NaF/5% TMP was significantly lower among all groups tested. Higher concentrations of CaF2 and fluoride were observed for Duraphat and 5% NaF, followed by 5% NaF/5% TMP, 2.5% NaF and 2.5% NaF/5% TMP (p < 0.05). It was concluded that the supplementation of fluoride varnishes with TMP leads to enhanced remineralizing effect of artificial caries lesions in vitro.

Effect of fluoride varnish supplemented with sodium trimetaphosphate on enamel erosion and abrasion: an in situ/ex vivo study.

OBJECTIVE: To evaluate the effect of fluoride (F) varnishes supplemented or not with sodium trimetaphosphate (TMP) on enamel erosive wear followed or not by abrasion in situ. METHODS: Ten volunteers were selected and randomly divided into four groups, according to the varnishes tested: placebo (no F or TMP), 5% NaF (positive control), 2.5% NaF and 2.5% NaF/5% TMP. Enamel blocks (n=4) were mounted in palatal devices and received an application of each test varnish, following a double-blind, crossover protocol. After 6h, varnishes were completely removed and the blocks were subjected to erosive challenges by ex vivo immersion in citric acid (5 min, 4×/dia, 5 days). Following, half of the blocks were subjected to abrasion by brushing with a placebo dentifrice slurry for 15s. Enamel wear (µm), surface hardness (SHf) and cross-sectional hardness (ΔKHN) were assessed after each experimental period. Results were analyzed by ANOVA, Student-Newman-Keuls's test and Pearson correlation coefficient (p<0.05). RESULTS: The fluoride varnish supplemented with TMP promoted significantly lower wear and ΔKHN when compared to the other groups after erosive challenges, followed or not by abrasion (p<0.05). As for (SHf) the fluoride varnish supplemented with TMP promoted similar results to the 5% NaF product, being significantly higher than the remaining groups after erosive and erosive+abrasive challenges (p<0.05). CONCLUSION: TMP significantly enhanced the effects of F on enamel wear after erosive challenges, followed or not by abrasion.

Effect of mouth rinses with fluoride and trimetaphosphate on enamel erosion: an in vitro study.

The effect of mouth rinses containing fluoride (100 µg/ml) and sodium trimetaphosphate (TMP) on enamel erosion was evaluated in vitro. Bovine enamel blocks were subjected to erosive challenges 4 times per day for 5 min, followed by treatment with placebo, 225 µg F/ml, 100 µg F/ml, 100 µg F/ml and TMP (0.2, 0.4 and 0.6%) solutions (30 s) and storage in artificial saliva, over a duration of 5 days. TMP groups showed lower enamel wear than fluoride-only and placebo groups (p < 0.05). Addition of TMP at a TMP:NaF molar proportion between 1.24:1 and 3.72:1 to a solution containing 100 µg F/ml presented a greater protective effect under erosive conditions than a solution containing 225 µg F/ml, in the absence of TMP.