Development of an electroactive aerobic biocathode for microbial fuel cell applications.

Microbial biocathodes are gaining interest due to their low cost, environmental friendliness and sustainable nature. In this study, a microbial consortium was enriched from activated sludge obtained from a common textile effluent treatment plant in the absence of organic carbon source to produce an electroactive biofilm. Chronoamperometry method of enrichment was carried out for over 70 days to select for electroactive bacteria that could be used as a cathode catalyst in microbial fuel cells (MFC). The resultant biofilm produced an average peak current of -0.7 mA during the enrichment and produced a maximum power density of 64.6 ± 3.5 mW m-2 compared to platinum (72.7 ± 1.2 mW m-2 ) in a Shewanella-based MFC. Microbial community analysis of the initial sludge sample and enriched samples, based on 16S rRNA gene sequencing, revealed the selection of chemolithotrophs with the most dominant phylum being Bacteroidetes, Proteobacteria, Firmicutes, Actinobacteria and Acidobacteria in the enriched samples. A variety of CO2 fixing and nitrate-reducing bacteria was present in the resultant biofilm on the cathode. This study suggests that microbial consortia are capable of replacing expensive platinum as a cathode catalyst in MFCs.

Laccase Immobilization Strategies for Application as a Cathode Catalyst in Microbial Fuel Cells for Azo Dye Decolourization.

Enzymatic biocathodes have the potential to replace platinum as an expensive catalyst for the oxygen reduction reaction in microbial fuel cells (MFCs). However, enzymes are fragile and prone to loss of activity with time. This could be circumvented by using suitable immobilization techniques to maintain the activity and increase longevity of the enzyme. In the present study, laccase from Trametes versicolor was immobilized using three different approaches, i.e., crosslinking with electropolymerized polyaniline (PANI), entrapment in copper alginate beads (Cu-Alg), and encapsulation in Nafion micelles (Nafion), in the absence of redox mediators. These laccase systems were employed in cathode chambers of MFCs for decolourization of Acid orange 7 (AO7) dye. The biocatalyst in the anode chamber was Shewanella oneidensis MR-1 in each case. The enzyme in the immobilized states was compared with freely suspended enzyme with respect to dye decolourization at the cathode, enzyme activity retention, power production, and reusability. PANI laccase showed the highest stability and activity, producing a power density of 38 ± 1.7 mW m-2 compared to 25.6 ± 2.1 mW m-2 for Nafion laccase, 14.7 ± 1.04 mW m-2 for Cu-Alg laccase, and 28 ± 0.98 mW m-2 for the freely suspended enzyme. There was 81% enzyme activity retained after 1 cycle (5 days) for PANI laccase compared to 69% for Nafion and 61.5% activity for Cu-alginate laccase and 23.8% activity retention for the freely suspended laccase compared to initial activity. The dye decolourization was highest for freely suspended enzyme with over 85% decolourization whereas for PANI it was 75.6%, Nafion 73%, and 81% Cu-alginate systems, respectively. All the immobilized laccase systems were reusable for two more cycles. The current study explores the potential of laccase immobilized biocathode for dye decolourization in a microbial fuel cell.

Decolourisation of Acid orange 7 in a microbial fuel cell with a laccase-based biocathode: Influence of mitigating pH changes in the cathode chamber.

Biocathodes may be a suitable replacement of platinum in microbial fuel cells (MFCs) if the cost of MFCs is to be reduced. However, the use of enzymes as bio-cathodes is fraught with loss of activity as time progresses. A possible cause of this loss in activity might be pH increase in the cathode as pH gradients in MFCs are well known. This pH increase is however, accompanied by simultaneous increase in salinity; therefore salinity may be a confounding variable. This study investigated various ways of mitigating pH changes in the cathode of MFCs and their effect on laccase activity and decolourisation of a model azo dye Acid orange 7 in the anode chamber. Experiments were run with catholyte pH automatically controlled via feedback control or by using acetate buffers (pH 4.5) of various strength (100mM and 200mM), with CMI7000 as the cation exchange membrane. A comparison was also made between use of CMI7000 and Nafion 117 as the transport properties of cations for both membranes (hence their potential effects on pH changes in the cathode) are different. Results show that using Nafion 117 membrane limits salinity and pH changes in the cathode (100mM acetate buffer as catholyte) leading to prolonged laccase activity and faster AO7 decolourisation compared to using CMI7000 as a membrane; similarly automatic pH control in the cathode chamber was found to be better than using 200mM acetate buffer. It is suggested that while pH control in the cathode chamber is important, it does not guarantee sustained laccase activity; as salinity increases affect the activity and it could be mitigated using a cation selective membrane.