RESUMO
The use of humidification-dehumidification water desalination technology has been shown to be a practical means of meeting the demand for freshwater. The aim of this review is to investigate the impact of salinity on HDH techniques that have various benefits in terms of both economics and the environment, including the capacity to operate at low temperatures, utilize sustainable energy sources, the need for low maintenance, and straightforward construction requirements. Also, in this review, it is observed that the HDH system's components are strong and capable of treating severely salinized water. It can treat water in an appropriate way than other desalination technologies. This technology has recently been commercialized to treat highly salinized generated water. However, more research is needed to determine how salinity affects HDH productivity. According to several research investigations, while the specific thermal energy consumption increased considerably and the productivity of water per unit of time decreased significantly as the salt mass percentage grew, the purity of clean water did not suffer. The rejected brine must be reduced by increasing the total water recovery ratio in the HDH system. Through this review, it was found that brine control is becoming increasingly important in the water processing industry. ZLD systems, which aim to recover both freshwater and solid salts, can be a viable replacement for disposal methods. Finally, through this reviewer, it was concluded that HDH desalination systems may operate with extremely saline water while increasing salinity has a significant influence on system performance.
Assuntos
Salinidade , Purificação da Água , Purificação da Água/métodos , Sais , Cloreto de SódioRESUMO
Solar stills are used in distant and arid areas to convert brackish or salty water into potable water fit for human use in a simple, affordable, and effective manner. Even when PCM materials are used, typical solar systems still have minimal production per day. In this study, experimental tests were carried out in order to increase the performance of a single-slope solar still combined with PCM material (paraffin wax) and a solar-powered electric heater. Two identical single-slope solar stills were designed, fabricated, and tested under the same climatic conditions during the summer and spring seasons of 2021 in Al-Arish, Egypt. The first is a conventional solar still (CVSS), and the other is also a conventional still but with PCM and an electric heater (CVSSWPCM). Several parameters were measured during the experiments, including sun intensity, meteorological aspects, cumulative freshwater production, average glass, and water temperatures and PCM temperature. The improved solar still was evaluated at different operating temperatures and was compared to the conventional traditional one. There were four cases studied: one case without a heater (paraffin wax only) and three other cases with a heater operating at 58 °C, 60 °C, and 65 °C, respectively. The experimental results revealed that activating the heater inside the paraffin wax increased daily production (i) in the spring by 2.38, 2.66, and 3.1 times and (ii) and in the summer by 2.2, 2.39, and 2.67 times at the three above-mentioned temperatures respectively (when compared to the traditional still). In addition, the maximum rate of daily freshwater production was achieved at paraffin wax temperature of 65 °C in both spring and summer (Case 5). Finally, the economic evaluation of the modified solar still was carried out according to cost per litre. The modified solar still with a heater operating at 65 °C has a higher exergoeconomic value than the traditional one. The maximum CO2 mitigation in cases 1 and 5 was approximately 28 tons and 160 tons, respectively.
