Assessment of the potential human health risks from exposure to complex substances in accordance with REACH requirements. "White spirit" as a case study.

The European chemical control regulation (REACH) requires that data on physical/chemical, toxicological and environmental hazards be compiled. Additionally, REACH requires formal assessments to ensure that substances can be safely used for their intended purposes. For health hazard assessments, reference values (Derived No Effect levels, DNELs) are calculated from toxicology data and compared to estimated exposure levels. If the ratio of the predicted exposure level to the DNEL, i.e. the Risk Characterization Ratio (RCR), is less than 1, the risk is considered controlled; otherwise, additional Risk Management Measures (RMM) must be applied. These requirements pose particular challenges for complex substances. Herein, "white spirit", a complex hydrocarbon solvent, is used as an example to illustrate how these procedures were applied. Hydrocarbon solvents were divided into categories of similar substances. Representative substances were identified for DNEL determinations. Adjustment factors were applied to the no effect levels to calculate the DNELs. Exposure assessments utilized a standardized set of generic exposure scenarios (GES) which incorporated exposure predictions for solvent handling activities. Computer-based tools were developed to automate RCR calculations and identify appropriate RMMs, allowing consistent communications to users via safety data sheets.

Solvent Transfer-Efficiency of Risk Management Measures.

A series of laboratory simulations were conducted in order to determine the airborne protection that might be afforded by different combinations of workplace exposure controls typically encountered when handling volatile solvents (e.g. solvent transfer). These conditions, referred to as risk management measures (RMMs) under the Registration, Evaluation and Authorisation of Chemicals Regulation (REACH), are typically described using standard phrases in safety data sheets [and specifically those of the European Phrase Catalogue (EUPhraC)]. Ethanol was used as a model compound and its emissions were monitored continuously with a portable IR spectrometer at 3000 cm-1. The average emission reduction performance of the investigated RMMs (e.g. containment, extract ventilation, drum pump) exceeded 90%. They present suitable ways to reduce airborne solvent exposure in a workplace and confirmed the initial expectations derived at by the European Solvents Industry Group (ESIG) and the European Centre For Ecotoxicology and toxicology of Chemicals (ECETOC) Targeted Risk Assessment (TRA) model.

Generic exposure scenarios: their development, application, and interpretation under REACH.

The European Union Registration, Evaluation, Authorization, and Restriction of Chemicals (REACH) Regulation (EC 1907/2006) places significant new obligations on the manufacturers or importers (M/Is) of chemicals in Europe. It also places new responsibilities on downstream users (DUs) of these chemicals i.e. those that purchase and use chemical products. In particular, for registered classified substances, the M/I is expected to communicate how any substance can be safely used without risk to man or the environment. This communication is in the form of an exposure scenario (ES), which is included in an Annex to the REACH extended safety data sheet. DUs then have certain obligations relating to adopting the control conditions described in the ES. The REACH Technical Guidance Documents lay down the expectations for the process of risk assessment that M/Is should adopt when developing ESs. But with many thousands of chemicals in daily commerce, it is also necessary to ensure that what is communicated to DUs not only meets the requirements of REACH but is also understandable to these groups, as well as being consistent across different chemical suppliers and supply chains. In cooperation with relevant DU groups, the European solvents industry has developed generic approaches for describing how solvents are commonly used, in order that these can subsequently be used as the basis for REACH registrations and related safety data sheet communications on health risk control. The utility of these approaches (termed 'generic exposure scenarios') is acknowledged under REACH and they are now publicly available for use both by M/Is and DUs.