Effects of Assisting Solvents on Purification Efficiency in the Layer Melt Crystallization of Glycerol.

The efficiency of layer melt crystallization for the selective separation of glycerol from a glycerol-diethylene glycol mixture containing 4 wt % of diethylene glycol was evaluated using solvent-free and solvent-aided approaches. The effect of 1-butanol and the binary solvent of 1-butanol and acetone with a total molar composition of 25 mol % on the crystal growth kinetics and the purity of the final product was studied at different undercooling degrees and crystallization yields. The melting point temperature of the mixtures was predicted by using the modified UNIFAC Dortmund model. The addition of both a single and binary solvents significantly increased the crystal growth rate and purity of the final product compared to crystallization from the solvent-free mixture. Additionally, higher crystal growth rates and product purity were observed in the binary solvent system compared to those in the single solvent system at the same degree of undercooling. The second stage of solvent-aided crystallization resulted in glycerol with a purity above 99.5 wt %, depending on the type of solvent used and the rate of crystal growth.

Degradation of cellulose polymorphs into glucose by HCl gas with simultaneous suppression of oxidative discoloration.

As cellulose is the main polysaccharide in biomass, its degradation into glucose is a major undertaking in research concerning biofuels and bio-based platform chemicals. Here, we show that pressurized HCl gas is able to efficiently hydrolyze fibers of different crystalline forms (polymorphs) of cellulose when the water content of the fibers is increased to 30-50 wt%. Simultaneously, the harmful formation of strongly chromophoric humins can be suppressed by a simple addition of chlorite into the reaction system. 50-70 % glucose yields were obtained from cellulose I and II polymorphs while >90 % monosaccharide conversion was acquired from cellulose IIIII after a mild post-hydrolysis step. Purification of the products is relatively unproblematic from a gas-solid mixture, and a gaseous catalyst is easier to recycle than the aqueous counterpart. The results lay down a basis for future practical solutions in cellulose hydrolysis where side reactions are controlled, conversion rates are efficient, and the recovery of products and reagents is effortless.

Immunoassays Based on Hot Electron-Induced Electrochemiluminescence at Disposable Cell Chips with Printed Electrodes.

Novel hot electron-emitting working electrodes and conventional counter electrodes were created by screen printing. Thus, low-cost disposable electrode chips for bioaffinity assays were produced to replace our older expensive electrode chips manufactured by manufacturing techniques of electronics from silicon or on glass chips. The present chips were created by printing as follows: (i) silver lines provided the electronic contacts, counter electrode and the bottom of the working electrode and counter electrode, (ii) the composite layer was printed on appropriate parts of the silver layer, and (iii) finally a hydrophobic ring was added to produce the electrochemical cell boundaries. The applicability of these electrode chips in bioaffinity assays was demonstrated by an immunoassay of human C-reactive protein (i) using Tb(III) chelate label displaying long-lived hot electron-induced electrochemiluminescence (HECL) and (ii) now for the first time fluorescein isothiocyanate (FITC) was utilized as an a low-cost organic label displaying a short-lived HECL in a real-world bioaffinity assay.