Tibouchina granulosa Leaves Present Anti-Inflammatory Effect.

The ethanol extract (EE) prepared from the leaves of Tibouchina granulosa, and its fraction in ethyl acetate (fEA) were evaluated concerning their capacity to reduce inflammation in different experimental models. fEA was also studied concerning its chemical constituents. EE and fEA were assayed for their anti-inflammatory potential, using formalin-induced licking behavior and carrageenan-induced inflammation into the subcutaneous air pouch (SAP) models. Reduction in polymorphonuclear cells (PMN) activation was performed in freshly isolated PMN. Chromatographic analysis of fEA was performed by HPLC-DAD. Hispiduloside was isolated as the main constituent in fEA, and its quantity was estimated to be 39.3% in fEA. EE (30 mg/kg) significantly reduced the second phase of formalin-induced licking. fEA demonstrated a reduction in leukocyte migration into the SAP. EE and fEA drastically reduced cytokines (TNF-α, IL-1ß, and IFN-γ), nitric oxide (NO) production, in vitro PMN migration induced by C5a and IL-8, and TNF-α and IL-1ß gene expression. Taken together, our data indicate that either ethanol extract or its fEA fraction from leaves of T. granulosa present an anti-inflammatory effect, contributing to the pharmacological and chemical knowledge of this species and confirming the rationale behind its traditional use.

PM2.5-bound polycyclic aromatic hydrocarbons in an area of Rio de Janeiro, Brazil impacted by emissions of light-duty vehicles fueled by ethanol-blended gasoline.

The aim of this study was to characterize the PM2.5-bound polycyclic aromatic hydrocarbon (PAH) concentrations and their diagnostic ratios in an area impacted by light-duty vehicles fueled by neat ethanol and ethanol-blended gasoline. Samples were collected using a high-volume sampler, extracted, and analyzed for all 16 EPA-priority PAHs using gas chromatography/mass spectrometry (GC/MS) following the EPA 3550B Method. The most abundant PAHs were benzo[g,h,i]perylene, benzo[b]fluoranthene, benzo[a]pyrene and indeno[1,2,3-c,d]pyrene. The total mean concentration was 3.80 ± 2.88 ng m(-3), and the contribution of carcinogenic species was 58 ± 16 % of the total PAHs. The cumulative health hazard from the PAH mixture was determined, and the carcinogenic equivalents and mutagenic equivalents were 0.80 ± 0.82 and 1.17 ± 1.04 ng m(-3), respectively. Diagnostic ratios and normalized ratios were calculated for the individual samples.

Trace metals in PM10 and PM 2.5 samples collected in a highly industrialized chemical/petrochemical area and its urbanized surroundings.

The aim of this study was to determine the potential impact of a highly industrialized area on its urbanized surroundings. The area studied is home to a refinery, a thermoelectric plant and several petrochemical facilities industries. The concentrations of twelve elements were determined in PM10 and PM2.5 samples collected along a busy highway and near the petrochemical complex. Significantly higher concentrations of Ca, Mg, Mn, Fe, Cu and Al were observed in the petrochemical zone, but principal component analysis revealed similar patterns for both the highway site and a site approximately 1.5 km from the petrochemical complex, suggesting that the main pollution source in the area is vehicular flux. Higher concentrations in the industrial area may be attributed to intense diesel-powered truck and bus traffic movement, mainly due to the transport of supplies, fuel and gas. The observed concentrations of the elements Cr, Co, Ni, Cd and Pb were always lower than the detection limits of the technique used.