Investigation the effect of different ionic liquids based-aryl imidazole on the onset precipitation of asphaltene.

Precipitation and deposition of asphaltene are considered as catastrophic issues facing the petroleum industry. Asphaltene deposition mainly occurs at variety places such as formation pore spaces, pumps, pipelines, wellbore, wellhead, tubing, surface facilities and safety valves causing operational problems, production deficiencies and enormous economic losses. This work aims to study the effect of series of synthesized aryl ionic liquids (ILs) containing different alkyl chains, named as R8-IL, R10-IL, R12-IL, and R14-IL, on the onset precipitation point of asphaltene in crude oil. R8-IL, R10-IL, R12-IL, and R14-IL were synthesized with high yields (the yield varied between 82 and 88%) and characterized via different tools of analysis (FTIR, 1H NMR, and Elemental Analysis). Their Thermal Gravimetric Analysis (TGA) was investigated and showed a reasonable degree of stability. It was found that R8-IL (short alkyl chain) has the highest stability, while R14-IL (long alkyl chain) is the lowest one. Quantum chemical calculations were conducted to study the reactivity and geometry of their electronic structures. Moreover, surface and interfacial tension of them were studied. It was found that the efficiency of the surface active parameters increased by increasing the length of the alkyl chain. The ILs were evaluated to delay the onset precipitation point of asphaltene using to different methods; the kinematic viscosity and the refractive index. Results from the two methods showed delaying of onset precipitation after the addition of the prepared ILs. The asphaltene aggregates was dispersed due to the π-π* interactions and hydrogen bonds formation with the ILs.

Green synthesis of chitosan/erythritol/graphene oxide composites for simultaneous removal of some toxic species from simulated solution.

In this study, chitosan (Ch) is adapted via green methodology including sonication induced crosslinking with different weight ratios of erythritol (Er) from (Ch-Er)1 to (Ch-Er)4. The products were casted in the form of thin films. The chemical modification was proved via FTIR spectroscopy. Then, the modified products were verified via an atomic force microscopy (AFM) investigation for their topography and surface properties. The data revealed that the optimized sample was (Ch-Er)3. This sample was further modified by different weight ratios of graphene oxide 0.1, 0.2, 0.4, and 0.8 wt./wt. (symbolized as (Ch-Er)3GO1, (Ch-Er)3GO2, (Ch-Er)3GO4, and (Ch-Er)3GO8 respectively). The prepared samples were investigated by different analytical tools. Then, the adjusted sample (Ch-Er)3GO2 was irradiated by electron beam (e-beam) at 10 and 20 kGy of irradiation doses to give samples (Ch-Er)3GO2R10 and (Ch-Er)3GO2R20, respectively. The AFM data of the irradiated samples showed that the pore size decreases, and surface roughness increases at higher energy e-beam due to the formation of more crosslinking points. The optimum samples of the prepared formulations were tested as sorbent materials for simultaneous elimination of methylene blue (MB) dye and mercury cation (Hg2+) from simulated solutions. The maximum removal of both MB dye and Hg2+ cation was achieved by (Ch-Er)3GO2R10 (186.23 mg g-1 and 205 mg g-1) respectively.