RESUMO
We propose a reliable method for stabilizing narrow linewidth Brillouin fiber lasers with non-resonant pumping. Mode-hopping is suppressed by means of a phase-locked loop that locks the pump-Stokes detuning to a local radio-frequency (RF) oscillator. Stable single-mode operation of a 110-m-long Brillouin fiber laser oscillating at 1.55 µm is demonstrated for several hours. The beat note between two independent Stokes waves presents a phase noise level of -60 dBc/Hz at 100 Hz with a -20 dB/decade slope, and a FWHM linewidth lower than 50 Hz.
RESUMO
The remarkable properties of graphene, such as broadband optical absorption, high carrier mobility, and short photogenerated carrier lifetime, are particularly attractive for high-frequency optoelectronic devices operating at 1.55 µm telecom wavelength. Moreover, the possibility to transfer graphene on a silicon substrate using a complementary metal-oxide-semiconductor-compatible process opens the ability to integrate electronics and optics on a single cost-effective chip. Here, we report an optoelectronic mixer based on chemical vapor-deposited graphene transferred on an oxidized silicon substrate. Our device consists in a coplanar waveguide that integrates a graphene channel, passivated with an atomic layer-deposited Al2O3 film. With this new structure, 30 GHz optoelectronic mixing in commercially available graphene is demonstrated for the first time. In particular, using a 30 GHz intensity-modulated optical signal and a 29.9 GHz electrical signal, we show frequency downconversion to 100 MHz. These results open promising perspectives in the domain of optoelectronics for radar and radio-communication systems.
RESUMO
We report the realization of an adaptive holographic interferometer based on two-beam coupling in an optically addressed liquid crystal spatial light modulator operating at 1.55-µm. The system allows efficient phase demodulation in noisy environment and behaves as an optical high-pass filter, with a cut-off frequency of approximately 10 Hz, thus filtering slow phase disturbances (due to, for example, temperature variations or low frequency fluctuations) and keeping the detection linear without the need of heterodyne or active stabilization.
RESUMO
A self-adaptive interferometer based on digital holography is here reported for applications involving measurements of very small amplitude vibrations. The two-beam coupling gain is optimized through an electronic feedback, while the dynamic character of the hologram allows reaching a high sensitivity of the interferometric measurements even in unstable environments and with strongly distorted wave-fronts. The frequency bandwidth of the adaptive interferometer and its spatial resolution are determined, respectively, by the maximum frame rate and the pixel size of the camera and of the spatial light modulator used to build the digital holographic setup.
RESUMO
Relative intensity noise and frequency noise have been measured for the first time for a single-frequency Brillouin chalcogenide As38Se62 fiber laser. This is also the first demonstration of a compact suspended-core fiber Brillouin laser, which exhibits a low threshold power of 22 mW and a slope efficiency of 26% for nonresonant pumping.
RESUMO
Intensity noise characteristics of a single-mode Brillouin fiber ring laser are experimentally analyzed from 100 kHz up to 18 GHz. The Stokes wave is shown to be shot-noise limited to -155 dB/Hz for a 1 mA detected photocurrent over the whole spectral range 100 MHz-18 GHz. The pump-to-Stokes noise filtering efficiency is evaluated by artificially increasing the pump intensity noise. It evidences that a shot-noise-limited Brillouin laser could be realized by using a narrow-linewidth semiconductor laser pump, for stringent microwave photonics applications.
