Monitoring trabecular bone microdamage using a dynamic acousto-elastic testing method.

Dynamic acousto-elastic testing (DAET) is based on the coupling of a low-frequency (LF) acoustic wave and high-frequency ultrasound (US) pulses (probing wave). It was developed to measure US viscoelastic and dissipative non-linearity in trabecular bone. It is well known that this complex biphasic medium contains microdamage, even when tissues are healthy. The purpose of the present study was to assess the sensitivity of DAET to monitor microdamage in human calcanei. Three protocols were therefore performed to investigate the regional heterogeneity of the calcaneus, the correlation between DAET measurements and microdamage revealed by histology, and DAET sensitivity to mechanically induced fatigue microdamage. The non-linear elastic parameter beta was computed for all these protocols. The study demonstrated the presence of high viscoelastic and dissipative non-linearity only in the region of the calcaneus close to the anterior talocalcaneal articulation (region of high bone density). Protocols 1 and 2 also showed that most unsorted calcanei did not naturally exhibit high non-linearity, which is correlated with a low level of microcracks. Nevertheless, when microdamage was actually present, high levels of US non-linearity were always found, with characteristic non-linear signatures such as hysteresis and tension/compression asymmetry. Finally, protocol 3 demonstrated the high sensitivity of DAET measurement to fatigue-induced microdamage.

Young's modulus repeatability assessment using cycling compression loading on cancellous bone.

For various applications, precision of the Young's modulus of cancellous bone specimens is needed. However, measurement variability is rarely given. The aim of this study was to assess the Young's modulus repeatability using a uniaxial cyclic compression protocol on embedded specimens of human cancellous bone. Twelve specimens from 12 human calcanei were considered. The specimens were first defatted and then 1 or 2 mm at the ends were embedded in an epoxy resin. The compression experiment consists in applying 20 compressive cycles between 0.2 per cent and 0.6 per cent strain with a 2 Hz loading frequency. The coefficient of variation of the current protocol was found to be 1.2 percent. This protocol showed variability similar to the end-cap technique (considered as a reference). It can be applied on porous specimen (especially human bone) and requires minimal bone length to limit end-artifact variability. The current method could be applied in association with noninvasive measurements (such as ultrasound) with full compatibility. This possibility opens the way for bone damage follow-up based on Young's modulus monitoring.