Biotechnologically produced chitosans with nonrandom acetylation patterns differ from conventional chitosans in properties and activities.

Chitosans are versatile biopolymers with multiple biological activities and potential applications. They are linear copolymers of glucosamine and N-acetylglucosamine defined by their degree of polymerisation (DP), fraction of acetylation (FA), and pattern of acetylation (PA). Technical chitosans produced chemically from chitin possess defined DP and FA but random PA, while enzymatically produced natural chitosans probably have non-random PA. This natural process has not been replicated using biotechnology because chitin de-N-acetylases do not efficiently deacetylate crystalline chitin. Here, we show that such enzymes can partially N-acetylate fully deacetylated chitosan in the presence of excess acetate, yielding chitosans with FA up to 0.7 and an enzyme-dependent non-random PA. The biotech chitosans differ from technical chitosans both in terms of physicochemical and nanoscale solution properties and biological activities. As with synthetic block co-polymers, controlling the distribution of building blocks within the biopolymer chain will open a new dimension of chitosan research and exploitation.

Effect of molecular weight on the ability of guar gum to enhance "weak gel" rheology of microdispersed oxidised cellulose (MDOC).

MDOC comprises small, essentially insoluble, particles which associate to form "weak gel" networks at concentrations above ∼4wt%. Association is promoted by guar gum, causing an increase in G' at low levels of addition and a decrease at higher concentrations, due to excessive aggregation of the MDOC particles. For guar gum samples with molecular weights ranging from ∼60 to ∼1800kDa, we found that the concentration required to give maximum G' for 5wt% dispersions of MDOC increased systematically from ∼0.005wt% for the lowest molecular weight to ∼0.3wt% for the highest. We propose that guar gum drives self-association of MDOC to reduce enthalpically-unfavourable (segregative) interactions between the two materials, and that large coils are less effective than smaller ones because a higher proportion of chain sequences are buried in the interior of the coil, where they cannot make segmental contacts with the MDOC particles.

Gelation of high-methoxy pectin by enzymic de-esterification in the presence of calcium ions: a preliminary evaluation.

Cohesive gels have been obtained by de-esterification of 1.0wt% high-methoxy citrus pectin (degree of esterification approximately 68%) in the presence of Ca(2+) cations, using a commercial preparation (NovoShape) of fungal methyl esterase cloned from Aspergillus aculeatus. A convenient rate of network formation (gelation within approximately 30min) was achieved at an enzyme concentration of 0.2 PEU/g pectin. At a Ca(2+)-concentration of 40mM and incubation temperature of 20 degrees C, severe syneresis (>7% of sample mass) was observed, but release of fluid decreased with decreasing concentration of Ca(2+) and increasing temperature of incubation, becoming undetectable for 10mM Ca(2+) at 30 degrees C. Under these conditions, progressive development of solid-like character (storage modulus, G') was observed during 160min of enzymic de-esterification, and the mechanical spectrum recorded at the end of the incubation period had the form typical of a biopolymer gel. On subsequent heating to 70 degrees C, dissociation of the gel network (sigmoidal reduction in G' and G'') was observed. At or above the midpoint temperature of this melting process ( approximately 50 degrees C), there was no indication of gel formation on enzymic de-esterification (at 50 or 60 degrees C). At lower temperatures (20, 30 and 40 degrees C), the rate of gelation (assessed visually) showed no systematic increase as the incubation temperature was increased towards the temperature-optimum of the enzyme ( approximately 50 degrees C). This unexpected behaviour is attributed to competition between faster de-esterification and slower formation of Ca(2+)-induced 'egg-box' junctions.

Tryptophan-mediated denaturation of beta-lactoglobulin A by UV irradiation.

beta-Lactoglobulin A, a genetic variant of one of the main whey proteins, was irradiated at 295 nm for 24 h. After irradiation, 18% of the protein was denatured (determined by reverse-phase chromatography). The fluorescence spectrum of the irradiated protein was red-shifted compared to that of the native protein, indicating a change in protein folding. Sulfhydryl groups, which are buried in native beta-lactoglobulin, were exposed following irradiation and became available for quantification using the Ellman assay. The quantity of exposed sulfhydryls increased, but the number of total sulfhydryl groups decreased. Gel permeation chromatography showed that some protein aggregation occurred during irradiation. Fourier transform infrared (FTIR) spectroscopy of irradiated beta-lactoglobulin revealed changes in the secondary structure, comparable to that of early events during heat-induced denaturation. There was evidence for some photo-oxidation of tryptophan.

Influence of pectin fine structure on the mechanical properties of calcium-pectin and acid-pectin gels.

The in vitro and in vivo functionality of the anionic plant polysaccharide pectin depends not only on the amount of ion-binding groups attached to the polymer but also on the distribution of such groups along the backbone. It has been proposed recently that information regarding this intramolecular distribution can be quantified by defining a degree of blockiness (DB or DB(abs)), and the usefulness of such measures in discriminating qualitatively between pectins originating from different sources has been demonstrated. Despite this, the value of these parameters in predicting the pseudoequilibrium elastic modulus of gels remains untested. This study seeks to address this problem through the sourcing and in-house modification of a variety of pectins in order to produce a library of distinct representative fine structures. These were subsequently characterized in terms of their relevant properties, including the determination of the proposed DB and DB(abs), and the formation of gels of these samples was monitored using small deformation mechanical spectroscopy. In addition to ionotropic calcium gels the effect of the fine structure on acid gelation was also studied.

Determination of exposed sulfhydryl groups in heated beta-lactoglobulin A using IAEDANS and mass spectrometry.

This paper takes a new approach to determining which sulfhydryl groups are exposed during the heat denaturation of bovine beta-lactoglobulin A. The sulfhydryl groups exposed after heating were blocked with 5-((((2-iodoacetyl)amino)ethyl)amino)naphthalene-1-sulfonic acid (IAEDANS). The results show that IAEDANS is a suitable blocking agent, and its absorbance at 336 nm enabled the quantification of exposed sulfhydryl groups in a mixture of protein species by gel permeation chromatography. Combined with the specific fragmentation of bound IAEDANS by matrix-assisted laser desorption ionization (MALDI) MS/MS in negative ionization mode, this facilitated the identification of peptides that contained blocked cysteines after enzymatic digestion of the protein. During MALDI MS/MS of the peptides, in positive ionization mode, the IAEDANS molecule remained bound to the cysteines, making it possible to identify exactly which cysteine had been exposed after heating. In beta-lactoglobulin A it was found that cysteine 66 and cysteine 160 were predominantly exposed regardless of the length of exposure to heat.