Arsenic and fluoride removal from contaminated drinking water with Haix-Fe-Zr and Haix-Zr resin beads.

The objective of the study was to carry-out batch tests to examine the effectiveness of Haix-Fe-Zr and Haix-Zr resin beads in the removal of As(III), As(V) and F- from groundwater with a similar geochemistry to a site where a community-based drinking water plant has been installed in West Bengal, India. The groundwater was spiked separately with ∼200 µg/L As(III) and As(V) and 5 mg/L F-. Haix-Zr resin beads were more effective than Haix-Fe-Zr resin beads in removing As(III) and As(V). Haix-Zr resin beads showed higher removal of As(V) compared to As(III). Haix-Zr resin beads removed As(V) below the WHO (10 µg/L) drinking water standards at 8.79 µg/L after 4 h of shaking, while As(III) was reduced to 7.72 µg/L after 8 h of shaking. Haix-Fe-Zr resin beads were more effective in removing F- from the spiked groundwater compared to Haix-Zr resin beads. Concentrations of F- decreased from 6.27 mg/L to 1.26 mg/L, which is below the WHO drinking water standards (1.5 mg/L) for F-, after 15 min of shaking with Haix-Fe-Zr resin beads. After 20 min of shaking in groundwater treated with Haix-Zr resin beads, F- concentrations decreased from 6.27 mg/L to 1.43 mg/L. In the removal of As(III), As(V), and F- from the groundwater, Haix-Fe-Zr and Haix-Zr resin beads fit the parabolic diffusion equation (PDE) suggesting that adsorption of these contaminants was consistent with inter-particle diffusion.

Remediation of Arsenic Contaminated Soil Using Phosphate and Colloidal Gas Aphron Suspensions Produced from Sapindus mukorossi.

Phosphate and colloidal gas aphrons (CGAs) generated from saponin extracted from Sapindus mukorossi fruit, were evaluated for washing low levels of arsenic from an iron rich soil. Phosphate is one of the most commonly dispersed chemicals that increases arsenic mobility in soil due to their structural similarities, making it an important factor in arsenic removal process. Column washing experiments were performed with CGAs in down flow and up flow modes on soil of pH 5 and 6. Soapnut CGAs, when paired with phosphate removed up to 95 % arsenic while soapnut CGAs alone could only remove up to 70 % arsenic. The presence of phosphate improved efficiency of soapnut solution by up to 35 %. SEM image of washed soil revealed minor corrosion of soil surface while using phosphate with soapnut. Therefore, the addition of phosphates would have positive impact on soil washing using soapnut saponin.

Enhanced removal of lead from contaminated soil by polyol-based deep eutectic solvents and saponin.

Deep eutectic solvents (DESs) are a class of green solvents analogous to ionic liquids, but less costly and easier to prepare. The objective of this study is to remove lead (Pb) from a contaminated soil by using polyol based DESs mixed with a natural surfactant saponin for the first time. The DESs used in this study were prepared by mixing a quaternary ammonium salt choline chloride with polyols e.g. glycerol and ethylene glycol. A natural surfactant saponin obtained from soapnut fruit pericarp, was mixed with DESs to boost their efficiency. The DESs on their own did not perform satisfactory due to higher pH; however, they improved the performance of soapnut by up to 100%. Pb removal from contaminated soil using mixture of 40% DES-Gly and 1% saponin and mixture of 10% DES-Gly and 2% saponin were above 72% XRD and SEM studies did not detect any major corrosion in the soil texture. The environmental friendliness of both DESs and saponin and their affordable costs merit thorough investigation of their potential as soil washing agents.

Application of colloidal gas aphron suspensions produced from Sapindus mukorossi for arsenic removal from contaminated soil.

Colloidal gas aphron dispersions (CGAs) can be described as a system of microbubbles suspended homogenously in a liquid matrix. This work examines the performance of CGAs in comparison to surfactant solutions for washing low levels of arsenic from an iron rich soil. Sodium Dodecyl Sulfate (SDS) and saponin, a biodegradable surfactant, obtained from Sapindus mukorossi or soapnut fruit were used for generating CGAs and solutions for soil washing. Column washing experiments were performed in down-flow and up flow modes at a soil pH of 5 and 6 using varying concentration of SDS and soapnut solutions as well as CGAs. Soapnut CGAs removed more than 70% arsenic while SDS CGAs removed up to 55% arsenic from the soil columns in the soil pH range of 5-6. CGAs and solutions showed comparable performances in all the cases. CGAs were more economical since it contains 35% of air by volume, thereby requiring less surfactant. Micellar solubilization and low pH of soapnut facilitated arsenic desorption from soil column. FT-IR analysis of effluent suggested that soapnut solution did not interact chemically with arsenic thereby facilitating the recovery of soapnut solution by precipitating the arsenic. Damage to soil was minimal arsenic confirmed by metal dissolution from soil surface and SEM micrograph.

A comparative study of biopolymers and alum in the separation and recovery of pulp fibres from paper mill effluent by flocculation.

Recovery of cellulose fibres from paper mill effluent has been studied using common polysaccharides or biopolymers such as Guar gum, Xanthan gum and Locust bean gum as flocculent. Guar gum is commonly used in sizing paper and routinely used in paper making. The results have been compared with the performance of alum, which is a common coagulant and a key ingredient of the paper industry. Guar gum recovered about 3.86mg/L of fibre and was most effective among the biopolymers. Settling velocity distribution curves demonstrated that Guar gum was able to settle the fibres faster than the other biopolymers; however, alum displayed the highest particle removal rate than all the biopolymers at any of the settling velocities. Alum, Guar gum, Xanthan gum and Locust bean gum removed 97.46%, 94.68%, 92.39% and 92.46% turbidity of raw effluent at a settling velocity of 0.5cm/min, respectively. The conditions for obtaining the lowest sludge volume index such as pH, dose and mixing speed were optimised for guar gum which was the most effective among the biopolymers. Response surface methodology was used to design all experiments, and an optimum operational setting was proposed. The test results indicate similar performance of alum and Guar gum in terms of floc settling velocities and sludge volume index. Since Guar gum is a plant derived natural substance, it is environmentally benign and offers a green treatment option to the paper mills for pulp recycling.

Comparison of a plant based natural surfactant with SDS for washing of As(V) from Fe rich soil.

This study explores the possible application of a biodegradable plant based surfactant, obtained from Sapindus mukorossi, for washing low levels of arsenic (As) from an iron (Fe) rich soil. Natural association of As(V) with Fe(III) makes the process difficult. Soapnut solution was compared to anionic surfactant sodium dodecyl sulfate (SDS) in down-flow and a newly introduced suction mode for soil column washing. It was observed that soapnut attained up to 86% efficiency with respect to SDS in removing As. Full factorial design of experiment revealed a very good fit of data. The suction mode generated up to 83 kPa pressure inside column whilst down-flow mode generated a much higher pressure of 214 kPa, thus making the suction mode more efficient. Micellar solubilisation was found to be responsible for As desorption from the soil and it followed 1st order kinetics. Desorption rate coefficient of suction mode was found to be in the range of 0.005 to 0.01, much higher than down-flow mode values. Analysis of the FT-IR data suggested that the soapnut solution did not interact chemically with As, offering an option for reusing the surfactant. Soapnut can be considered as a soil washing agent for removing As even from soil with high Fe content.

Degradation dynamics of the insecticide: clothianidin (Dantop 50 % WDG) in a tea field ecosystem.

The fate of clothianidin [(E)-1-(2-chloro-1, 3-thiazol-5-ylmethyl)-3-methyl-2-nitroguanidine] applied to tea plant was studied at two location in West Bengal, India. The insecticide was applied in Tea field at two doses @30 and 60 g.a.i./ha during June-July 2009. Solid-phase extraction and liquid-liquid extraction was employed for the determination of this insecticide in tea samples. Clothianidin residues were analyzed and estimated quantitatively by HPLC at λ(max) 250 nm. The observed half life values of made tea and green tea leaf ranges from 3.71 to 4.07 days and 4.07 to 4.49 days respectively.

Remediation technologies for heavy metal contaminated groundwater.

The contamination of groundwater by heavy metal, originating either from natural soil sources or from anthropogenic sources is a matter of utmost concern to the public health. Remediation of contaminated groundwater is of highest priority since billions of people all over the world use it for drinking purpose. In this paper, thirty five approaches for groundwater treatment have been reviewed and classified under three large categories viz chemical, biochemical/biological/biosorption and physico-chemical treatment processes. Comparison tables have been provided at the end of each process for a better understanding of each category. Selection of a suitable technology for contamination remediation at a particular site is one of the most challenging job due to extremely complex soil chemistry and aquifer characteristics and no thumb-rule can be suggested regarding this issue. In the past decade, iron based technologies, microbial remediation, biological sulphate reduction and various adsorbents played versatile and efficient remediation roles. Keeping the sustainability issues and environmental ethics in mind, the technologies encompassing natural chemistry, bioremediation and biosorption are recommended to be adopted in appropriate cases. In many places, two or more techniques can work synergistically for better results. Processes such as chelate extraction and chemical soil washings are advisable only for recovery of valuable metals in highly contaminated industrial sites depending on economical feasibility.

Dissipation study of difenoconazole in/on chili fruit and soil in India.

One field experiment was conducted with Difenoconazole (25% EC) on chili crop during December 2009 to January 2010 at two different locations of West Bengal and Maharashtra. The main objective was to understand the residue and persistence behaviour of fungicide difenoconazole in chili fruit and soil samples. Difenoconazole was applied in chili field at 50 mL and 100 mL/100 liter of water. Its residue was analyzed by using LC-MS/MS and it dissipated in chili fruit and soil following first order kinetics. The half life values of difenoconazole were found in the range 2.15-2.32 days and 4.68-8.09 days for chili fruit and soil, respectively.