RESUMO
Studies on the haemodynamics of human circulation are clinically and scientifically important. In order to investigate the effect of deformation and aggregation of red blood cells (RBCs) in blood flow, a computational technique has been developed by coupling the interaction between the fluid and the deformable RBCs. Parallelization was carried out for the coupled code and a high speedup was achieved based on a spatial decomposition. In order to verify the code's capability of simulating RBC deformation and transport, simulations were carried out for a spherical capsule in a microchannel and multiple RBC transport in a Poiseuille flow. RBC transport in a confined tube was also carried out to simulate the peristaltic effects of microvessels. Relatively large-scale simulations were carried out of the motion of 49,512 RBCs in shear flows, which yielded a hematocrit of 45%. The large-scale feature of the simulation has enabled a macroscale verification and investigation of the overall characteristics of RBC aggregations to be carried out. The results are in excellent agreement with experimental studies and, more specifically, both the experimental and simulation results show uniform RBC distributions under high shear rates (60-100/s) whereas large aggregations were observed under a lower shear rate of 10/s.
RESUMO
This article describes the effects of ambulatory accelerations on the stability of a magnetically suspended impeller for use in implantable blood pumps. A magnetic suspension system is developed to control the radial position of a magnetic impeller using coils in the pump casing. The magnitude and periodicity of ambulatory accelerations at the torso are measured. A test rig is then designed to apply appropriate accelerations to the suspension system. Accelerations from 0 to 1 g are applied to the suspended impeller with ambulatory periodicity while the radial position of the impeller and power consumption of the suspension system are monitored. The test is carried out with the impeller suspended in air, water, and a glycerol solution to simulate the viscosity of blood. A model is developed to investigate the effects of the radial magnetic suspension system and fluid damping during ambulatory accelerations. The suspension system reduces the average displacement of the impeller suspended in aqueous solutions within its casing to 100 µm with a power consumption of below 2 W during higher magnitude ambulatory accelerations (RMS magnitude 0.3 g). The damping effect of the fluid is also examined and it is shown that buoyancy, rather than drag, is the primary cause of the damping at the low displacement oscillations that occur during the application of ambulatory accelerations to such a suspension system.
Assuntos
Coração Auxiliar , Magnetismo/instrumentação , Aceleração , Viscosidade Sanguínea , Simulação por Computador , Humanos , Modelos Cardiovasculares , Desenho de PróteseRESUMO
This paper numerically investigates particle saltation in a turbulent channel flow having a rough bed consisting of two to three layers of densely packed spheres. The Shields function is 0.065 which is just above the sediment entrainment threshold to give a bed-load regime. The applied methodology is a combination of three technologies, i.e., the direct numerical simulation of turbulent flow; the combined finite-discrete element modeling of the deformation, movement, and collision of the particles; and the immersed boundary method for the fluid-solid interaction. It is shown that the presence of entrained particles significantly modifies the flow profiles of velocity, turbulent intensities, and shear stresses in the vicinity of a rough bed. The quasi-streamwise-aligned streaky structures are not observed in the near-wall region and the particles scatter on the rough bed owing to their large size. However, in the outer flow region, the turbulent coherent structures recover due to the weakening rough-bed effects and particle interferences. First- and second-order statistical features of particle translational and angular velocities, together with sediment concentration and volumetric flux density profiles, are presented. Several key parameters of the particle saltation trajectory are calculated and agree closely with published experimental data. Time histories of the hydrodynamic forces exerted upon a typical saltating particle, together with those of the particle's coordinates and velocities, are presented. A strong correlation is shown between the abruptly decreasing streamwise velocity and increasing vertical velocity at collision which indicates that the continuous saltation of large-grain-size particles is controlled by collision parameters such as particle incident angle, local bed packing arrangement, and particle density, etc.
Assuntos
Coloides/química , Sedimentos Geológicos/química , Modelos Químicos , Reologia/métodos , Movimentos da Água , Água/química , Simulação por Computador , Hidrodinâmica , Movimento (Física)RESUMO
Aggregation of highly deformable red blood cells (RBCs) significantly affects the blood flow in the human circulatory system. To investigate the effect of deformation and aggregation of RBCs in blood flow, a mathematical model has been established by coupling the interaction between the fluid and the deformable solids. The model includes a three-dimensional finite volume method solver for incompressible viscous flows, the combined finite-discrete element method for computing the deformation of the RBCs, a JKR model-Johnson, Kendall and Roberts (1964-1971) (Johnson et al., 1971) to take account of the adhesion forces between different RBCs and an iterative direct-forcing immersed boundary method to couple the fluid-solid interactions. The flow of 49,512 RBCs at 45% concentration under the influence of aggregating forces was examined, improving the existing knowledge on simulating flow and structural characteristics of blood at a large scale: previous studies on the particular issue were restricted to simulating the flow of 13,000 aggregative ellipsoidal particles at a 10% concentration. The results are in excellent agreement with experimental studies. More specifically, both the experimental and the simulation results show uniform RBC distributions under high shear rates (60-100/s) whereas large aggregation structures were observed under a lower shear rate of 10/s. The statistical analysis of the simulation data also shows that the shear rate has significant influence on both the flow velocity profiles and the frequency distribution of the RBC orientation angles.