Breast cancer extent and survival among diabetic women in a Finnish nationwide cohort study.

Breast cancer (BC) and diabetes mellitus (DM) are major health problems. We examined the association between DM and BC stage at diagnosis and subsequent survival in a Finnish cohort of female BC patients. All BC cases (N = 73,170) diagnosed in 1995-2013 with dates and causes of death were identified from the Finnish Cancer Registry. Participation in organized mammography screening was obtained from Mass Inspection Registry. Information on DM diagnoses and background conditions recorded during 1995-2013 were obtained from national Care Register for Health Care and merged to data on medication use from the national Prescription Register. Logistic regression with adjustment for mammography screening and age at BC diagnosis was used to evaluate the risk of advanced stage BC at diagnosis. Cox regression was used to evaluate overall and BC survival. Analyses were adjusted for age, background conditions and mammography screening. Survival analyses were further adjusted for tumor extent, histology and primary treatment. Of the cohort 11,676 (16.0%) had DM. Screening participation did not differ by diabetes. Compared to non-diabetic women, diabetics had more often locally advanced (odds ratio, OR 1.26; 95% CI 1.18-1.35) or metastatic BC (OR 1.59; 95% CI 1.44-1.75) at diagnosis. During a median follow-up of 5.8 years after BC diagnosis 10,900 (14.9%) women died of BC. Risk of BC death was higher among diabetic compared to non-diabetic women (HR 1.36; 95% CI 1.27-1.46). Risk of BC death increased with duration of DM. This supports DM as a risk factor for fatal BC.

Immobilisation of TiO2 for combined photocatalytic-biological azo dye degradation.

The biodegradability of the azo dye Remazol Red RR (100 mg/l) was evaluated using unadapted activated sludge and the experiment confirmed the recalcitrance of the dye. Using a combination of photocatalysis and an aerobic biological step, the biodegradability was improved significantly and complete removal of both colour and COD were achieved. Furthermore, TiO2 was successfully immobilised on borosilicate glass slides by calcination, which facilitates reuse of the catalyst. The catalytic activity of the immobilised TiO2 was close to that of suspended TiO2. A reduced activity was however observed when the TiO2 slides were used repeatedly. When comparing NaOH, calcination and UV irradiation for regeneration of the TiO2 slides, immersion in NaOH was shown to be the most efficient method.

A study of two-stage anaerobic digestion of solid potato waste using reactors under mesophilic and thermophilic conditions.

A two-stage anaerobic digestion process operated under mesophilic and thermophilic conditions was investigated for the treatment of solid potato waste to determine optimal methane yield, efficiency of operation and process stability. A solid-bed reactor was used for hydrolysis/acidification stage while an upflow anaerobic sludge blanket (UASB) reactor was used in the second stage, for methanogenesis. Three sets of conditions were investigated: (1) mesophilic + mesophilic, (II) mesophilic + thermophilic and (III) thermophilic + thermophilic in the hydrolysis/acidification and methanogenesis reactors, respectively. The methane yield was higher under mesophilic conditions (0.49 l CH4 g COD(-1)degraded) than thermophilic conditions (0.41 l CH4 g COD(-1)degraded) with reference to the methanogenic reactors. (COD)--chemical oxygen demand. However, the digestion period was shorter in systems II and III than in system I. Also, in system III the UASB reactor (thermophilic conditions) could handle a higher organic loading rate (OLR) (36 g COD 1(-1)d(-1)) than in system I (11 g COD 1(-1)d(-1)) (mesophilic conditions) with stable operation. Higher OLRs in the methanogenic reactors resulted in reactor failure due to increasing total volatile fatty acid levels. In all systems, the concentration of propionate was one of the highest, higher than acetic acid, among the volatile fatty acids in the effluent. The results show the feasibility of using a two-stage system to treat solid potato waste under both mesophilic and thermophilic conditions. If the aim is to treat solid potato waste completely within a short period of time thermophilic conditions are to be preferred, but to obtain higher methane yield mesophilic conditions are preferable and therefore there is a need to balance methane yield and complete digestion period when dealing with large quantities of solid potato waste.

Influence of temperature on process efficiency and microbial community response during the biological removal of chlorophenols in a packed-bed bioreactor.

Two reactors, initially operated at 14 and 23+/-1 degrees C (RA and RB, respectively), were inoculated with a bacterial consortium enriched and acclimatized to the respective temperatures over 4 months. The biofilms, formed in the reactors, were studied using scanning electron microscopy, cultivation of the biofilm microflora, and physiological analysis of the isolates. Two bacteria able to mineralize chlorophenols under a large range of temperature (10-30 degrees C) were isolated from the biofilm communities of reactors RA and RB and characterized as Alcaligenaceae bacterium R14C4 and Cupriavidus basilensis R25C6, respectively. When temperature was decreased by 10 degrees C, the chlorophenols removal capacity was reduced from 51.6 to 22.8 mg l(-1) h(-1) in bioreactor RA (from 14 to 4 degrees C) and from 59.3 to 34.7 mg l(-1) h(-1) in bioreactor RB (from 23+/-1 to 14 degrees C). Fluorescence in situ hybridization (FISH) of the biofilm communities showed that, in all temperatures tested, the beta-proteobacteria were the major bacterial community (35-47%) followed by the gamma-proteobacteria (12.0-6.5%). When the temperature was decreased by 10 degrees C, the proportions of gamma-proteobacteria and Pseudomonas species increased significantly in both microbial communities.

Influence of recirculation flow rate on the performance of anaerobic packed-bed bioreactors treating potato-waste leachate.

The performance of anaerobic, packed-bed bioreactors treating leachate from potato waste was evaluated in terms of organic loading rate (OLR) as well as the recirculation flow rate. Two 1 litre bioreactors, filled with porous glass beads as biofilm carriers and with continuous recirculation flow rates of 10 ml min(-1) and 20 ml min(-1) respectively, were used in the experiment. The OLR applied to each bioreactor was increased stepwise from 4 to 12 kg chemical oxygen demand (COD) m(-3)d(-1) by increasing feed flow rate. The methane yields decreased with increasing OLR in both bioreactors. The methane yield for the bioreactor with the lower recirculation flow rate ranged between 0.10 and 0.14 m3 CH4 kg COD(-1) removed, while for the other bioreactor it was 0.14-0.20 m3 CH4 kg COD(-1) removed. Both bioreactors demonstrated stable COD removal which was around 95% for the bioreactor with lower flow of recirculation while for the other it was 92%, over a range of OLRs of 4-8 kg COD m(-3)d(-1). The bioreactor with the lower recirculation flow rate showed operational stability when a high OLR, namely 12 kg COD m(-3)d(-1), was applied, while the other one became overloaded. There was an accumulation of volatile fatty acids which gave a corresponding drop in pH because the system had a low buffering capacity and this thus ultimately led to process failure. This study demonstrated the suitability of a packed bed bioreactor operated at lower recirculation flow rate for treating leachate from potato waste.

Impact of food industrial waste on anaerobic co-digestion of sewage sludge and pig manure.

The performance of an anaerobic digestion process is much dependent on the type and the composition of the material to be digested. The effects on the degradation process of co-digesting different types of waste were examined in two laboratory-scale studies. In the first investigation, sewage sludge was co-digested with industrial waste from potato processing. The co-digestion resulted in a low buffered system and when the fraction of starch-rich waste was increased, the result was a more sensitive process, with process overload occurring at a lower organic loading rate (OLR). In the second investigation, pig manure, slaughterhouse waste, vegetable waste and various kinds of industrial waste were digested. This resulted in a highly buffered system as the manure contributed to high amounts of ammonia. However, it is important to note that ammonia might be toxic to the micro-organisms. Although the conversion of volatile fatty acids was incomplete the processes worked well with high gas yields, 0.8-1.0 m3 kg(-1) VS.

Evaluation of new methods for the monitoring of alkalinity, dissolved hydrogen and the microbial community in anaerobic digestion.

New methods for spectrophotometric alkalinity measurement, dissolved hydrogen monitoring and for obtaining a fingerprint of the microbial community were evaluated as tools for process monitoring in anaerobic digestion. The anaerobic digestion process was operated at organic loading rates of 1.5, 3.0 and 4.5 g volatile solids l(-1)d(-1) and subjected to pulse loads of carbohydrate, lipid, protein and a mixed sludge substrate. The spectrophotometric alkalinity monitoring method showed good agreement with traditional titrimetric alkalinity monitoring and has the advantage of being easy to modify to on-line monitoring applications. The on-line monitoring of dissolved hydrogen gave valuable information about approaching process overload and can be a good complement to the conventional monitoring of volatile fatty acids. Changing process conditions were also reflected in the microbial fingerprint that could be achieved by partitioning in two-phase systems. The investigated methods showed potential for application in increasing our understanding of the anaerobic digestion process as well as for being applicable for monitoring in the complex environment of full-scale anaerobic digestion processes.

Evaluation of parameters for monitoring an anaerobic co-digestion process.

The system investigated in this study is an anaerobic digester at a municipal wastewater treatment plant operating on sludge from the wastewater treatment, co-digested with carbohydrate-rich food-processing waste. The digester is run below maximum capacity to prevent overload. Process monitoring at present is not extensive, even for the measurement of on-line gas production rate and off-line pH. Much could be gained if a better program for monitoring and control was developed, so that the full capacity of the system could be utilised without the risk of overload. The only limit presently set for correct process operation is that the pH should be above 6.8. In the present investigation, the pH was compared with alkalinity, gas production rate, gas composition and the concentration of volatile fatty acids (VFA). Changes in organic load were monitored in the full-scale anaerobic digester and in laboratory-scale models of the plant. Gas-phase parameters showed a slow response to changes in load. The VFA concentrations were superior for indicating overload of the microbial system, but alkalinity and pH also proved to be good monitoring parameters. The possibility of using pH as a process indicator is, however, strongly dependent on the buffering capacity. In this study, a minor change in the amount of carbohydrates in the substrate had drastic effects on the buffering effect of the system.

Production of asymmetric hybrids between Solanum tuberosum and irradiated S. brevidens.

Asymmetric somatic hybrids were obtained by fusion of Solanum tuberosum (PDH40) protoplasts with 300- or 500-Gy irradiated protoplasts of S. brevidens. These radiation doses were sufficient to prevent the growth of the S. brevidens protoplasts. Putative hybrids were selected on the basis of phenotype from regenerated shoots and identified with a S. brevidens-specific probe. From these, 31 asymmetric hybrids were confirmed by morphological characteristics, isoenzyme patterns and RFLP analysis. The morphology of the asymmetric hybrids was intermediate between that of S. tuberosum and symmetric hybrids of both species (obtained without irradiation treatment). Chromosome counts from 17 asymmetric hybrids showed that the chromosome number of the hybrids ranged from 31 to 64. The asymmetric hybrids probably had one or two genome complements (i.e. either 24 or 48 chromosomes) from S. tuberosum and 7-22 chromosomes from S. brevidens. There was no clear correlation between the radiation dose and the degree of elimination of the S. brevidens genome.