Ultrasound-assisted extraction and concentration of phenolic compounds from jabuticaba sabará (Plinia peruviana (Poir.) Govaerts) peel by nanofiltration membrane.

Jabuticaba peel, rich in antioxidants, offering health benefits. In this study, the extraction of phenolic compounds from jabuticaba peel using ultrasound-assisted (UA) and their subsequent concentration by nanofiltration (NF) employing a polyamide 200 Da membrane was evaluated. The UA extractions were conducted using the Central Composite Rotatable Design (CCRD) 22 methodology, with independent variables extraction time (11.55 to 138 min) and temperature (16.87 to 53.3 °C), and fixed variables mass to ethanol solution concentration at pH 1.0 (1:25 g/mL), granulometry (1 mm), and ultrasonic power (52.8 W). The maximum concentrations obtained were 700.94 mg CE/100 g for anthocyanins, 945.21 mg QE/100 g for flavonoids, 133.19 mg GAE/g for phenols, and an antioxidant activity IC50 of 24.36 µg/mL. Key phenolic compounds identified included cyanidin-3-glucoside, delphinidin-3-glucoside, and various acids like syringic and gallic. NF successfully concentrated these compounds, enhancing their yield by up to 45%. UA and NF integrate for sustainable extraction.

Kinetic and stoichiometric parameters in the fed-batch bioreactor production of poly(3-hydroxybutyrate) by Bacillus megaterium using different carbon sources.

This study investigates the effects of different strategies on poly(3-hydroxybutyrate)-P(3HB) production in a fed-batch bioreactor by Bacillus megaterium using candy industry effluent (CIE), sucrose, and rice parboiled water (RPW) as carbon sources. In biosynthesis, kinetic and stoichiometric parameters of substrate conversion into products and/or cells, productivity, instantaneous, and specific conversion rates were evaluated. The maximum concentration of P(3HB) was 4.00 g.L-1 (77% of the total dry mass) in 42 h of cultivation in minimal medium/RPW added with a carbon source based on CIE, demonstrating that the fed-batch provided an increase of approximately 22% in the polymer concentration and 32% in the overall productivity in relation to medium based on commercial sucrose. Fed-batch cultivation also had the advantage of avoiding the extra time required for inoculum preparation and sterilization of the bioreactor during the batch, which thereby increased the overall industrial importance of the process. Effluents from the candy, confectionery, and/or rice parboiling industries can be used as alternative substrates for P(3HB) production at a low cost.

Influence of redox potential on the accumulation of poly(3-hydroxybutyrate) by Bacillus megaterium.

The main goal of the present study was to evaluate the oxidation-reduction potential (ORP) on the production of poly(3-hydroxybutyrate) (P(3HB)) by Bacillus megaterium. Each microorganism has an optimal ORP range, and changes to the culture medium's ORP may redistribute the cell's metabolic flux, as such, the measurement and control of the ORP profile allows one to, in a way, manipulate the microbial metabolism, affecting the expression of certain enzymes and allowing for better control over the fermentative process. The ORP tests were carried out in a fermentation vessel coupled with an ORP probe, containing 1 L of mineral medium added with agroindustry byproducts (60% v/v of confectionery wastewater, and 40% v/v of rice parboiling water). The system's temperature was kept at 30 °C, with an agitation speed of 500 rpm. The vessel's airflow rate was controlled via a solenoid pump based on the ORP probe's data. Different ORP values were evaluated to verify their impact on biomass and polymer production. Cultures using OPR levels of 0 mV displayed the highest amounts of total biomass (5.00 g L-1) when compared to - 20 mV and - 40 mV (2.90 g L-1 and 0.53 g L-1, respectively). Similar results were also found for P(3HB)-to-biomass ratio, with polymer concentration being reduced when using ORP levels below 0 mV and with a maximum amount of polymer-to-biomass ratio of 69.87% after 48 h of culture. Furthermore, it was possible to observe that the culture's pH can also affect total biomass and polymer concentration, albeit to a lesser extent. Thus, when considering the data found during this study, it is possible to observe that ORP values can greatly impact B. megaterium cell's metabolism. Furthermore, the measurement and control of ORP levels may be an invaluable asset when trying to maximize polymer production under different culture conditions.

Effect of Extraction Time on the Yield, Chemical Composition, and Antibacterial Activity of Hop Essential Oil Against Lactic Acid Bacteria (Lactobacillus brevis and Lactobacillus casei) Beer Spoilage.

Hop essential oil (EO) generates interest for its antioxidant and antimicrobial properties, in addition to the volatile compounds that are responsible for the hop aroma in beer. Thus, the objective of this study was to evaluate the chemical composition, EO yield, and antibacterial activity of hop essential oil from hops of the Chinook variety against lactic acid bacteria (Lactobacillus brevis and Lactobacillus casei) at different times of extraction. EO extraction was performed by hydrodistillation at different times. By analyzing the chemical composition by gas chromatography and mass spectrometry, the minimum inhibitory concentration (MIC) and the minimum bactericidal concentration (MBC) were determined. The major compounds of hop EO were α-humulene, ß-myrcene, and ß-caryophyllene, and the extraction yields were 0.67, 0.78, and 0.85% mass of EO per mass of hops pelletized hops (m/m), for extractions of 90, 180, and 300 min, respectively. The EO obtained in 90 min was efficient against L. casei at 2.5 mg/mL (MIC) and 5.0 mg/mL (MBC), and the 300 min one against L. brevis at 2.5 mg/mL (MIC) and 25 mg/mL (MBC). The antibacterial activity was affected by the chemical makeup of the oil, revealing that the hop EO extracted in 300 min was the most efficient among the other extraction times.