The mechanisms of oxygen reduction and evolution reactions in nonaqueous lithium-oxygen batteries.

A fundamental understanding of the mechanisms of both the oxygen reduction reaction (ORR) and the oxygen evolution reaction (OER) in nonaqueous lithium-oxygen (Li-O2) batteries is essential for the further development of these batteries. In this work, we systematically investigate the mechanisms of the ORR/OER reactions in nonaqueous Li-O2 batteries by using electron paramagnetic resonance (EPR) spectroscopy, using 5,5-dimethyl-pyrroline N-oxide as a spin trap. The study provides direct verification of the formation of the superoxide radical anion (O2(˙-)) as an intermediate in the ORR during the discharge process, while no O2(˙-) was detected in the OER during the charge process. These findings provide insight into, and an understanding of, the fundamental reaction mechanisms involving oxygen and guide the further development of this field.

Formation of interfacial layer and long-term cyclability of Li-O2 batteries.

The long-term operation of Li-O2 batteries under full discharge/charge conditions is investigated in a glyme-based electrolyte. The formation of stable interfacial layer on the electrode surface during the initial cycling stabilizes reaction products at subsequent cycling stages as demonstrated by quantitative analyses of the discharge products and the gases released during charging. There is a quick switch from the predominant formation of Li2O2 to the predominant formation of side products during the first few cycles. However, after the formation of the stable interfacial layer, the yield of Li2O2 in the reaction products is stabilized at about 33-40%. Extended cycling under full discharge/charge conditions is achievable upon selection of appropriate electrode materials (carbon source and catalyst) and cycling protocol. Further investigation on the interfacial layer, which in situ forms on air electrode, may increase the long-term yield of Li2O2 during the cycling and enable highly reversible Li-O2 batteries required for practical applications.

In-situ electrochemical transmission electron microscopy for battery research.

The recent development of in-situ liquid stages for (scanning) transmission electron microscopes now makes it possible for us to study the details of electrochemical processes under operando conditions. As electrochemical processes are complex, care must be taken to calibrate the system before any in-situ/operando observations. In addition, as the electron beam can cause effects that look similar to electrochemical processes at the electrolyte/electrode interface, an understanding of the role of the electron beam in modifying the operando observations must also be understood. In this paper we describe the design, assembly, and operation of an in-situ electrochemical cell, paying particular attention to the method for controlling and quantifying the experimental parameters. The use of this system is then demonstrated for the lithiation/delithiation of silicon nanowires.