RESUMO
Simulation and analysis of solar cells based on the heterojunction of zinc oxide doped with aluminum (AZO) and cadmium telluride (CdTe) with the structure (Al/AZO/CdTe/NiO/Ni) using the Simulator of the capacitance of solar cells - 1 dimension (SCAPS-1D) has been presented in this paper. AZO is used as a window layer and Nickel oxide (NiO) has been introduced as a hole transport layer (HTL). Through the software, the effect of thickness, absorber (CdTe), and window (AZO) layers carrier concentration, operating temperature, and resistances (series and shunt) have been studied. Simulation results show that the solar cell performance can be greatly improved by adjusting the layer's thickness and carrier concentration, obtaining optimal values of 10 nm and 10 18 c m - 3 for the AZO layer, while for the CdTe layer they were 2 µm and 10 15 c m - 3 . The optimum series and shunt resistances are in the range of 1-3 Ω c m 2 and 1800-2200 Ω c m 2 respectively. A maximum power conversion efficiency (PCE) of 14.2% is achieved with an open circuit voltage (Voc) of 0.74 V, short circuit current density (Jsc) of 26.15 m A / c m 2 and a fill factor (FF) of 72.83%, this shows AZO potential to be considered as an interesting material to replace CdS window layer.
RESUMO
We studied the influences of the thickness of the porous silicon layer and the conductivity type on the porous silicon sensors response when exposed to ethanol vapor. The response was determined at room temperature (27 ∘C) in darkness using a horizontal aluminum electrode pattern. The results indicated that the intensity of the response can be directly or inversely proportional to the thickness of the porous layer depending on the conductivity type of the semiconductor material. The response of the porous sensors was similar to the metal oxide sensors. The results can be used to appropriately select the conductivity of semiconductor materials and the thickness of the porous layer for the target gas.
