Competitive adsorption between beta-casein or beta-lactoglobulin and model milk membrane lipids at oil-water interfaces.

This study investigated the competitive adsorption between milk proteins and model milk membrane lipids at the oil-water interface and its dependence on the state of the lipid dispersion and the formation of emulsions. Both protein and membrane lipid surface load were determined using a serum depletion technique. The membrane lipid mixture used was a model milk membrane lipid system, containing dioleoylphosphatidylcholine, dioleoylphosphatidylethanolamine, milk sphingomyelin, dioleoylphosphatidylserine, and soybean phosphatidylinositol. The model composition mimics the lipid composition of natural milk fat globule membranes. The interactions were studied for two proteins, beta-lactoglobulin and beta-casein. The mixing order was varied to allow for differentiation between equilibrium structures and nonequilibrium structures. The results showed more than monolayer adsorption for most combinations. Proteins dominated at the oil-water interface in the protein-emulsified emulsion even after 48 h of exposure to a vesicular dispersion of membrane lipids. The membrane lipids dominated the oil-water interface in the case of the membrane lipid emulsified emulsion even after equilibration with a protein solution. Protein displacement with time was observed only for emulsions in which both membrane lipids and beta-casein were included during the emulsification. This study shows that kinetics controls the structures rather than the thermodynamic equilibrium, possibly resulting in structures more complex than an adsorbed monolayer. Thus, it can be expected that procedures such as the mixing order during emulsion preparation are of crucial importance to the emulsification performance.

Complexation of whey proteins with carrageenan.

The formation of electrostatic complexes of whey protein (WP) and a nongelling carrageenan (CG) was investigated as a function of pH, ionic strength, temperature, and protein-to-polysaccharide (Pr:Ps) ratio. On lowering the pH, the formation of soluble WP/CG complexes was initiated at pH(c) and insoluble complexes at pH(phi), below which precipitation occurred. The values of the transition pH varied as a function of the ionic strength. It was shown that at [NaCl] = 45 mM, the value of pH(phi) was the highest, showing that the presence of monovalent ions was favorable to the formation of complexes by screening the residual negative charges of the CG. When CaCl(2) was added to the mixtures, complexes of WP/CG were formed up to pH 8 via calcium bridging. The electrostatic nature of the primary interaction was confirmed from the slight effect of temperature on the pH(phi). Increasing the Pr:Ps ratio led to an increase of the pH(phi) until a ratio of 30:1 (w/w), at which saturation of the CG chain seemed to be reached. The behavior of WP/CG complexes was investigated at a low Pr:Ps ratio, when the biopolymers were mixed directly at low pH. It resulted in an increase of the pH of the mixture, as compared to the initial pH of the separate WP and CG solutions. The pH increase was accompanied by a decrease in conductivity. The trapping of protons inside the complex probably resulted from a residual negative charge on the CG. If NaCl was present in the mixture, the complex took up the Na(+) ions instead of the H(+) ions.