Nanostructuring few-layer graphene films with swift heavy ions for electronic application: tuning of electronic and transport properties.

The morphology and electronic properties of single and few-layer graphene films nanostructured by the impact of heavy high-energy ions have been studied. It is found that ion irradiation leads to the formation of nano-sized pores, or antidots, with sizes ranging from 20 to 60 nm, in the upper one or two layers. The sizes of the pores proved to be roughly independent of the energy of the ions, whereas the areal density of the pores increased with the ion dose. With increasing ion energy (>70 MeV), a profound reduction in the concentration of structural defects (by a factor of 2-5), relatively high mobility values of charge carriers (700-1200 cm2 V-1 s-1) and a transport band gap of about 50 meV were observed in the nanostructured films. The experimental data were rationalized through atomistic simulations of ion impact onto few-layer graphene structures with a thickness matching the experimental samples. We showed that even a single Xe atom with energy in the experimental range produces a considerable amount of damage in the graphene lattice, whereas high dose ion irradiation allows one to propose a high probability of consecutive impacts of several ions onto an area already amorphized by the previous ions, which increases the average radius of the pore to match the experimental results. We also found that the formation of "welded" sheets due to interlayer covalent bonds at the edges and, hence, defect-free antidot arrays is likely at high ion energies (above 70 MeV).

Dielectric functions, chemical and atomic compositions of the near surface layers of implanted GaAs by In+ ions.

The surfaces of (100) GaAs were irradiated with In+ ions. The implanted samples were isobaric annealed at 800°C and then of dielectric function, the surface atomic concentrations of atoms and also the chemical composition of the near surface layers in these implanted semiconductor samples were obtained. The following investigation methods were used: spectroscopic ellipsometry (SE), Rutherford backscattering spectrometry analyses (RBSA) and X-ray photoelectron spectroscopy (XPS) in the study of the above mentioned quantities, respectively. The change of the shape spectra of the dielectric functions at about 3.0eV phonon energy, diffusion of In+ ions as well as chemical composition changes were observed after ion implantation and the thermal treatment. Due to displacement of Ga ions from GaAs by the In+ ions the new chemical compound InAs was formed. The relative amounts Ga2O3 and As2O3 ratio increase in the native oxide layers with the fluences increase after the thermal treatment of the samples. Additionally, it was noticed that the quantities of InO2 increase with the increasing values of the irradiated ions before thermal treatment.

Light-induced confinement of electrons in stacked distorted graphene layers - a (TD-)DFT study.

Recently observed white-light emission from graphene ceramics cannot be explained by black body radiation theory because of a relatively low temperature of the sample. Furthermore the intensity of the emission stays at the same level even at temperatures as low as 10 K, indicating the purely electronic nature of the observed emission. In this work a model of light emission from locally interacting stacked graphene layers after intense continuous wave laser excitation is proposed. After a light-induced sp2 to sp3 change of the hybridization sp2-nanodomains surrounded by sp3 carbon atoms could be created and the electrons can be confined. Using DFT and TD-DFT methods followed by a molecular-like approach we examine the electronic structure and the optical properties of graphene (sp2,sp3)-clusters. We show the quantized and well separated energy levels of electrons from the domain's interior and the possibility of emission in the NIR/VIS/UV range.

Two blinking mechanisms in highly confined AgInS2 and AgInS2/ZnS quantum dots evaluated by single particle spectroscopy.

Ternary AgInS2 quantum dots (QDs) have been found as promising cadmium-free, red-shifted, and tunable luminescent bio-probes with efficient Stokes and anti-Stokes excitations and luminescence lifetimes (ca. 100 ns) convenient for time resolved techniques like fluorescence life-time imaging. Although the spectral properties of the AgInS2 QDs are encouraging, the complex recombination kinetics in the QDs being still far from understood, limits their full utility. In this paper we report on a model describing the recombination pathways responsible for large deviations from the first-order decay law observed commonly in the ternary chalcogenides. The presented results were evaluated by means of individual AgInS2 QD spectroscopy aided by first principles calculations including the electronic structure and structural reconstruction of the QDs. Special attention was devoted to study the impact of the surface charge state on the excited state relaxation and effect of its passivation by Zn(2+) ion alloying. Two different blinking mechanisms related to defect-assisted charge imbalance in the QD responsible for fast non-radiative relaxation of the excited states as well as surface recharging of the QD were found as the major causes of deviations from the first-order decay law. Careful optimization of the AgInS2 QDs would help to fabricate new red-shifted and tunable fluorescent bio-probes characterized by low-toxicity, high quantum yield, long luminescence lifetime, and time stability, leading to many novel in vitro and in vivo applications based on fluorescence lifetime imaging (FLIM) and time-gated detection.

Brief communication: dental development and enamel thickness in the Lakonis Neanderthal molar.

Developmental and structural affinities between modern human and Neanderthal dental remains continue to be a subject of debate as well as their utility for informing assessments of life history and taxonomy. Excavation of the Middle Paleolithic cave site Lakonis in southern Greece has yielded a lower third molar (LKH 1). Here, we detail the crown development and enamel thickness of the distal cusps of the LKH 1 specimen, which has been classified as a Neanderthal based on the presence of an anterior fovea and mid-trigonid crest. Crown formation was determined using standard histological techniques, and enamel thickness was measured from a virtual plane of section. Developmental differences include thinner cuspal enamel and a lower periodicity than modern humans. Crown formation in the LKH 1 hypoconid is estimated to be 2.6-2.7 years, which is shorter than modern human times. The LKH 1 hypoconid also shows a more rapid overall crown extension rate than modern humans. Relative enamel thickness was approximately half that of a modern human sample mean; enamel on the distal cusps of modern human third molars is extremely thick in absolute and relative terms. These findings are consistent with recent studies that demonstrate differences in crown development, tissue proportions, and enamel thickness between Neanderthals and modern humans. Although overlap in some developmental variables may be found, the results of this and other studies suggest that Neanderthal molars formed in shorter periods of time than modern humans, due in part to thinner enamel and faster crown extension rates.

Three-dimensional molar enamel distribution and thickness in Australopithecus and Paranthropus.

Thick molar enamel is among the few diagnostic characters of hominins which are measurable in fossil specimens. Despite a long history of study and characterization of Paranthropus molars as relatively 'hyper-thick', only a few tooth fragments and controlled planes of section (designed to be proxies of whole-crown thickness) have been measured. Here, we measure molar enamel thickness in Australopithecus africanus and Paranthropus robustus using accurate microtomographic methods, recording the whole-crown distribution of enamel. Both taxa have relatively thick enamel, but are thinner than previously characterized based on two-dimensional measurements. Three-dimensional measurements show that P. robustus enamel is not hyper-thick, and A. africanus enamel is relatively thinner than that of recent humans. Interspecific differences in the whole-crown distribution of enamel thickness influence cross-sectional measurements such that enamel thickness is exaggerated in two-dimensional sections of A. africanus and P. robustus molars. As such, two-dimensional enamel thickness measurements in australopiths are not reliable proxies for the three-dimensional data they are meant to represent. The three-dimensional distribution of enamel thickness shows different patterns among species, and is more useful for the interpretation of functional adaptations than single summary measures of enamel thickness.

Molar enamel thickness and dentine horn height in Gigantopithecus blacki.

Absolutely thick molar enamel is consistent with large body size estimates and dietary inferences about Gigantopithecus blacki, which focus on tough or fibrous vegetation. In this study, 10 G. blacki molars demonstrating various stages of attrition were imaged using high-resolution microtomography. Three-dimensional average enamel thickness and relative enamel thickness measurements were recorded on the least worn molars within the sample (n = 2). Seven molars were also virtually sectioned through the mesial cusps and two-dimensional enamel thickness and dentine horn height measurements were recorded. Gigantopithecus has the thickest enamel of any fossil or extant primate in terms of absolute thickness. Relative (size-scaled) measures of enamel thickness, however, support a thick characterization (i.e., not "hyper-thick"); G. blacki relative enamel thickness overlaps slightly with Pongo and completely with Homo. Gigantopithecus blacki dentine horns are relatively short, similar to (but shorter than) those of Pongo, which in turn are shorter than those of humans and African apes. Gigantopithecus blacki molar enamel (and to a lesser extent, that of Pongo pygmaeus) is distributed relatively evenly across the occlusal surface compared with the more complex distribution of enamel thickness in Homo sapiens. The combination of evenly distributed occlusal enamel and relatively short dentine horns in G. blacki results in a flat and low-cusped occlusal surface suitable to grinding tough or fibrous food objects. This suite of molar morphologies is also found to varying degrees in Pongo and Sivapithecus, but not in African apes and humans, and may be diagnostic of subfamily Ponginae.

Molar development in common chimpanzees (Pan troglodytes).

Numerous studies have reported on enamel and dentine development in hominoid molars, although little is known about intraspecific incremental feature variation. Furthermore, a recent histological study suggested that there is little or no time between age at chimpanzee crown completion and age at molar eruption, which is unlikely given that root growth is necessary for tooth eruption. The study presented here redefines growth standards for chimpanzee molar teeth and examines variation in incremental features. The periodicity of Retzius lines in a relatively large sample was found to be 6 or 7 days. The number of Retzius lines and cuspal enamel thickness both vary within a cusp type, among cusps, and among molars, resulting in marked variation in formation time. Daily secretion rate is consistent within analogous cuspal zones (inner, middle, and outer enamel) within and among cusp types and among molar types. Significantly increasing trends are found from inner to outer cuspal enamel (3 to 5 microns/day). Cuspal initiation and completion sequences also vary, although sequences for mandibular molar cusps are more consistent. Cusp-specific formation time ranges from approximately 2 to 3 years, increasing from M1 to M2, and often decreasing from M2 to M3. These times are intermediate between radiographic studies and a previous histological study, although both formation time within cusps and overlap between molars vary considerably. Cusp-specific (coronal) extension rates range from approximately 4 to 9 microns/day, and root extension rates in the first 5 mm of roots range from 3 to 9 microns/day. These rates are greater in M1 than in M2 or M3, and they are greater in mandibular molars than in respective maxillary molars. This significant enlargement of comparative data on nonhuman primate incremental development demonstrates that developmental variation among cusp and molar types should be considered during interpretations and comparisons of small samples of fossil hominins and hominoids.

Modern human molar enamel thickness and enamel-dentine junction shape.

This study examines cross-sections of molar crowns in a diverse modern human sample to quantify variation in enamel thickness and enamel-dentine junction (EDJ) shape. Histological sections were generated from molars sectioned buccolingually across mesial cusps. Enamel cap area, dentine area, EDJ length, and bi-cervical diameter were measured on micrographs using a digitizing tablet. Nine landmarks along the EDJ were defined, and X and Y coordinates were digitized in order to quantify EDJ shape. Upper molars show greater values for the components of enamel thickness, leading to significantly greater average enamel thickness than in lower molars. Average enamel thickness increased significantly from M1 to M3 in both molar rows, due to significantly increasing enamel cap area in upper molars, and decreasing dentine area in lower molars. Differences in EDJ shape were found among maxillary molars in combined and individual populations. Sex differences were also found; males showed significantly greater dentine area, EDJ length, and bi-cervical diameters in certain tooth types, which resulted in females having significantly thicker average enamel. Differences in enamel thickness and EDJ shape within molars were also found among populations, although few consistent trends were evident. This study demonstrates that enamel thickness and EDJ shape vary among molars, between sexes, and among populations; these factors must be considered in the categorization and comparison of ape and human molars, particularly when isolated teeth or fossil taxa are included. Human relative enamel thickness encompasses most values reported for fossil apes and humans, suggesting limited taxonomic value when considered alone.

[Total cementless hip replacement complicated by the damage of the femoral artery]. / Postepowanie w calkowitej, bezcementowej alloplastyce stawu biodrowego powiklanej uszkodzeniem tetnicy udowej.

The paper presents the mode of treatment in two patients with injury of the femoral artery which resulted during total cementless hip replacement. The first patient underwent a total hip replacement procedure because of degenerative changes secondary to purulent inflammation during infancy. During the procedure the femoral artery was damaged and subsequently sutured. The second patient was underwent a total hip replacement procedure because of degenerative changes secondary to congenital dislocation of the hip. Two months after implantation of a Biocontact prosthesis with a self-threading acetabular component, a false aneurysm was diagnosed by ultrasonographic examination. The aneurysm was excised and a vascular prosthesis was implanted. This mode of treatment saved both patients, while preserving the hip prosthesis. The complication rate was 0.3%.