Migration of noble gas tracers at the site of an underground nuclear explosion at the Nevada National Security Site.

As part of an underground gas migration study, two radioactive noble gases (37Ar and 127Xe) and two stable tracer gases (SF6 and PFDMCH) were injected into a historic nuclear explosion test chimney and allowed to migrate naturally. The purpose of this experiment was to provide a bounding case (natural transport) for the flow of radioactive noble gases following an underground nuclear explosion. To accomplish this, soil gas samples were collected from a series of boreholes and a range of depths from the shallow subsurface (3 m) to deeper levels (~160 m) over a period of eleven months. These samples have provided insights into the development and evolution of the subsurface plume and constrained the relative migration rates of the radioactive and stable gas species in the case when the driving pressure from the cavity is low. Analysis of the samples concluded that the stable tracer SF6 was consistently enriched in the subsurface samples relative to the radiotracer 127Xe, but the ratios of SF6 and 37Ar remained similar throughout the samples.

Measurements of Argon-39 at the U20az underground nuclear explosion site.

Pacific Northwest National Laboratory reports on the detection of 39Ar at the location of an underground nuclear explosion on the Nevada Nuclear Security Site. The presence of 39Ar was not anticipated at the outset of the experimental campaign but results from this work demonstrated that it is present, along with 37Ar and 85Kr in the subsurface at the site of an underground nuclear explosion. Our analysis showed that by using state-of-the-art technology optimized for radioargon measurements, it was difficult to distinguish 39Ar from the fission product 85Kr. Proportional counters are currently used for high-sensitivity measurement of 37Ar and 39Ar. Physical and chemical separation processes are used to separate argon from air or soil gas, yielding pure argon with contaminant gases reduced to the parts-per-million level or below. However, even with purification at these levels, the beta decay signature of 85Kr can be mistaken for that of 39Ar, and the presence of either isotope increases the measurement background level for the measurement of 37Ar. Measured values for the 39Ar measured at the site ranged from 36,000 milli- Becquerel/standard-cubic-meter-of-air (mBq/SCM) for shallow bore holes to 997,000 mBq/SCM from the rubble chimney from the underground nuclear explosion.

Virtual animation of victim-specific 3D models obtained from CT scans for forensic reconstructions: Living and dead subjects.

Post-mortem CT scanning (PMCT) has been introduced at several forensic medical institutions many years ago and has proved to be a useful tool. 3D models of bones, skin, internal organs and bullet paths can rapidly be generated using post-processing software. These 3D models reflect the individual physiognomics and can be used to create whole-body 3D virtual animations. In such way, virtual reconstructions of the probable ante-mortem postures of victims can be constructed and contribute to understand the sequence of events. This procedure is demonstrated in two victims of gunshot injuries. Case #1 was a man showing three perforating gunshot wounds, who died due to the injuries of the incident. Whole-body PMCT was performed and 3D reconstructions of bones, relevant internal organs and bullet paths were generated. Using 3ds Max software and a human anatomy 3D model, a virtual animated body was built and probable ante-mortem postures visualized. Case #2 was a man presenting three perforating gunshot wounds, who survived the incident: one in the left arm and two in the thorax. Only CT scans of the thorax, abdomen and the injured arm were provided by the hospital. Therefore, a whole-body 3D model reflecting the anatomical proportions of the patient was made combining the actual bones of the victim with those obtained from the human anatomy 3D model. The resulted 3D model was used for the animation process. Several probable postures were also visualized in this case. It has be shown that in Case #1 the lesions and the bullet path were not consistent with an upright standing position; instead, the victim was slightly bent forward, i.e. he was sitting or running when he was shot. In Case #2, one of the bullets could have passed through the arm and continued into the thorax. In conclusion, specialized 3D modelling and animation techniques allow for the reconstruction of ante-mortem postures based on both PMCT and clinical CT.

Valproate is an effective, well-tolerated drug for treatment of status epilepticus/serial attacks in adults.

OBJECTIVE: Status epilepticus (SE) and serial attacks (SA) represent neurological emergencies, and mortality rate for SE/SA is high, ranging from 3% to 25%, depending on cause and co-morbidity. As SE/SA become more refractory to treatment over time, rapid, appropriate treatment is extremely important. Here, we report a prospective registration of the effect of intravenous (IV) valproate (VPA) on SE/SA in a group of Norwegian patients. PATIENTS AND METHODS: Forty-one adult patients (18 males, 23 females) were included in the study. All had previously been unsuccessfully treated with diazepam. For 19, the main SE/SA seizure type was generalized tonic-clonic, while 16 had complex-partial seizures. Six had seizures that were difficult to classify. The treatment protocol recommended 25 mg/kg of VPA loading dose over 30 min, followed by continuous infusion of 100 mg/h for at least 24 h, then per oral administration. If seizures persisted after the loading dose, general anaesthesia (barbiturates/propofol/midazolam) was administered. RESULTS: No serious side effects were reported. In 76% of the cases (31 of 41), SE/SA stopped and anaesthesia was not required. Of the patients treated within 3 h, only 5% needed anaesthesia, whereas of those treated after 3-24 h, 38% needed anaesthesia. Of those who waited for more than 24 h before treatment, 60% required anaesthesia. Furthermore, 60% of the patients who needed anaesthesia were given loading doses below 2100 mg. CONCLUSIONS: VPA seems to be a safe, effective treatment of SE/SA, but efficacy is dependent on time lapse between symptoms and VPA treatment, and administration of a sufficiently high loading dose.

Mount st. Helens ash from the 18 may 1980 eruption: chemical, physical, mineralogical, and biological properties.

Samples of ash from the 18 May 1980 eruption of Mount St. Helens were collected from several locations in eastern Washington and Montana. The ash was subjected to a variety of analyses to determine its chemical, physical, mineralogical, and biological characteristics. Chemically, the ash samples were of dacitic composition. Particle size data showed bimodal distributions and differed considerably with location. However, all samples contained comparable amounts of particles less than 3.5 micrometers in diameter (respirable fraction). Mineralogically, the samples ranged from almost totally glassy to almost totally crystalline. Crystalline samples were dominated by plagioclase feldspar (andesine) and orthopyroxene (hypersthene), with smaller amounts of titanomagnetite and hornblende. All but one of the samples contained from less than 1 percent to 3 percent free crystalline silica (quartz, trydimite, or cristobalite) in both the bulk samples and 1 to 2 percent in the fractions smaller than 3.5 micrometers. The long-lived natural radionuclide content of the ash was comparable to that of crustal material; however, relatively large concentrations of short-lived radon daughters were present and polonium-210 content was inversely correlated with particle size. In vitro biological tests showed the ash to be nontoxic to alveolar macrophages, which are an important part of the lungs' natural clearance mechanism. On the basis of a substantial body of data that has shown a correlation between macrophage cytotoxicity and fibrogenicity of minerals, the ash is not predicted to be highly fibrogenic.

Field experience with ambient-level flame-photometric sulphur detectors.

Carbon dioxide exhaled by the operators produces increased levels of this gas inside the trailers used for housing monitoring equipment for use in the field. These levels can be high enough to produce serious calibration errors in flame photometric detectors used for measuring ambient concentrations of gaseous sulphur products. Quantitative measurement of the carbon dioxide interference in the sulphur emission is reported, as well as a method of estimating the extent of quenching agent pollution.

On the solubility of zinc in the gamma-phase of the silver-mercury system.

By measuring lattice constants of a number of Ag-Hg-Zn alloys with gamma-phase structure, it has been shown that apart from a possible two-phase field there exists a continuous solid solution between gamma (Ag-Hg) and gamma (Ag-Zn). A correlation between the Zn-content in the gamma 1 phase in set dental silver amalgam and the Zn-content in the corresponding alloy has been determined.