Conceptual design of a heavy ion beam probe for the QUEST spherical tokamak.

A heavy ion beam probe (HIBP) has been designed for the QUEST spherical tokamak to measure plasma turbulence and the profiles of electric potential profiles. Using a cesium ion beam with an energy of several 10 keV, the observable region covers most of the upper half of the plasma. Although the probe beam is deflected by the poloidal magnetic field produced by plasma current and poloidal coil currents, it can be detected under plasma current up to 150 kA by modifying the trajectories with two electrostatic sweepers. According to the numerical estimation of the intensity of the detected beam, sufficient signal intensity for measuring plasma turbulence can be obtained over almost the measurable area when the electron density is up to 1 × 1019 m-3, which is larger than the cut-off density of electron cyclotron heating in QUEST. The performance of the designed HIBP is sufficient to explore the mechanisms of heat and particle transport in magnetically confined plasmas, including the influence of plasma wall interactions, which is a goal of the QUEST project.

Adaptive Capon beamforming for lensless electron cyclotron emission imaging with high spatial resolution.

Electron cyclotron emission (ECE) imaging diagnostics incorporating a lensless approach have been developed for measurements involving active spatial selectivity and direction-of-arrival estimation. The Capon method for adaptive-array analysis was proposed to improve the spatial resolution of the two-dimensional ECE imaging technique. Broadband noise source emissions were used to simulate the ECE to verify the practical effectiveness of the Capon method in the ECE imaging. Multiple noise source emission positions were properly estimated with a high spatial resolution using the Capon method.

Dynamical programming based turbulence velocimetry for fast visible imaging of tokamak plasma.

An orthogonal dynamic programming (ODP) based particle image velocimetry (PIV) technique is developed to measure the time resolved flow field of the fluctuating structures at the plasma edge and scrape off layer (SOL) of tokamaks. This non-intrusive technique can provide two dimensional velocity fields at high spatial and temporal resolution from a fast framing image sequence and hence can provide better insights into plasma flow as compared to conventional probe measurements. Applicability of the technique is tested with simulated image pairs. Finally, it is applied to tangential fast visible images of QUEST plasma to estimate the SOL flow in inboard poloidal null-natural divertor configuration. This technique is also applied to investigate the intricate features of the core of the run-away dominated phase following the injection of a large amount of neutrals in the target Ohmic plasma. Development of the ODP-PIV code and its applicability on actual plasma images is reported.

A prototype diagnostics system to detect ultraviolet emission for plasma turbulence.

A system to detect ultraviolet emissions from plasma is developed for multi-point measurement, the target of which is the imaging of turbulence with a high temporal resolution. A fluorescent glass, which converts ultraviolet emissions to visible light with a wavelength of approximately 540 nm, is utilized in the system. Following the conversion, the fluorescent light is transferred with fibre optics, and is converted to electric signals in a location that is sufficiently distant from an electrically noisy environment around the plasma device. This paper describes a prototype system of this diagnostic method and discusses the spectral analysis obtained using a low-aspect-ratio reversed field pinch RELAX.

Thermal imaging of plasma with a phased array antenna in QUEST.

A thermal imaging system to measure plasma Electron Bernstein Emission (EBE) emanating from the mode conversion region in overdense plasma is discussed. Unlike conventional ECE/EBE imaging, this diagnostics does not employ any active mechanical scanning mirrors or focusing optics to scan for the emission cones in plasma. Instead, a standard 3 × 3 waveguide array antenna is used as a passive receiver to collect emission from plasma and imaging reconstruction is done by accurate measurements of phase and intensity of these signals by heterodyne detection technique. A broadband noise source simulating the EBE, is installed near the expected mode conversion region and its position is successfully reconstructed using phase array technique which is done in post processing.

Tangential soft-x ray imaging for three-dimensional structural studies in a reversed field pinch.

Tangential soft-x ray (SXR) imaging diagnostic has been developed and three-dimensional (3D) structure of the internal magnetic surface has been deduced by comparing the experimental and calculated two-dimensional SXR images in a reversed field pinch. The SXR imaging system, consisting of a MCP, a fluorescent plate, and an intensified charge coupled device camera, has been installed in REversed field pinch of Low-Aspect-ratio eXperiment (RELAX) machine. Major characteristics of an experimental SXR image could be reproduced by numerical calculations of the image using a single island model, suggesting a helical hot core in RELAX. The SXR imaging system could be useful for 3D structural studies when tangential and vertical simultaneous imaging systems would be installed, with appropriate numerical modeling of 3D structure of the magnetic surfaces.