Comparison of seasonal phenol and p-cresol emissions from ground-level area sources in a dairy operation in central Texas.

Although there are more than 200 odor-causing volatile organic compounds (VOCs), phenol and p-cresol are two prominent odor-causing VOCs found downwind from concentrated animal feeding operations (CAFOs). The VOC emissions from cattle and dairy production are difficult to quantify accurately because of their low concentrations, spatial variability, and limitations of available instruments. To quantify VOCs, a protocol following US. Environmental Protection Agency (EPA) Method TO-14A has been established based on the isolation flux chamber method and a portable gas chromatograph (GC) coupled with a purge-and-trap system. The general objective of this research was to quantify phenol and p-cresol emission rates (ERs) from different ground-level area sources (GLASs) in a free-stall dairy during summer and winter seasons using this protocol. Two-week-long sampling campaigns were conducted in a dairy operation in central Texas. Twenty-nine air samples were collected during winter and 37 samples were collected during summer from six specifically delineated GLASs (barn, loafing pen, lagoon, settling basin, silage pile, and walkway) at the free-stall dairy. Thirteen VOCs were identified during the sampling period and the GC was calibrated for phenol and p-cresol, the primary odorous VOCs identified. The overall calculated ERs for phenol and p-cresol were 2656 +/- 728 and 763 +/- 212 mg hd(-1) day(-1), respectively, during winter. Overall phenol and p-cresol ERs were calculated to be 1183 +/- 361 and 551 +/- 214 mg hd(-1) day(-1), respectively, during summer. In general, overall phenol and p-cresol ERs during winter were about 2.3 and 1.4 times, respectively, higher than those during summer.

Effect of ozonation on particulate matter in broiler houses.

The effects of ozonation on particulate matter were studied on a commercial broiler farm. The farm consisted of 4 identical tunnel-ventilated houses (12.8×152.4 m): 2 houses were treated with O3 (maximum concentration 0.1 ppm) and the other 2 served as control units. The particle size distributions of total suspended particulate (TSP) samples from both control and treated houses were found to have very similar profiles with no statistical difference. The TSP concentrations were significantly higher in treated houses as compared with those in control houses, and the mean of the differences was 5.50 mg/m3. In both treated and control houses, there were substantial vertical TSP concentration gradients and the concentrations decreased with height. At broiler chicken height (0.28 m), TSP concentrations were 13±3 mg/m3 in control houses and 17±2 mg/m3 in treated houses. At human breathing height (1.55 m), TSP concentrations were 8±4 mg/m3 in control houses and 7±2 mg/m3 in treated houses. Particle phase NH4+ concentrations were higher in treated houses (ranging from 0.59 to 42.01 mg/m3 with mean=17.49 mg/m3) than in control houses (ranging from 0.34 to 13.55 mg/m3 with mean=4.42 mg/m3). The TSP samples from locations in the vicinity of the farm showed higher concentrations downwind than that upwind, but there were no significant differences observed among different ambient locations for TSP NH4+ concentrations. The results from this study did not show that direct application of ozonation technique has beneficial effects for particulate matter control in broiler houses.

Dust emissions in cattle feedlots.

Dust emissions were measured at three Texas cattle feedlots on 15 occasions in 1987 to determine concentrations of total suspended particulate matter (TSP) and dust with 10 microns or less aerodynamic particle size (PM-10). Net feedlot dust concentrations (downwind minus upwind) ranged from 15.7 to 1,700.1 micrograms per m3 and averaged 412.4 +/- 271.2 micrograms per m3, which is about 37 per cent less than was determined in feedlot dust research in California approximately 17 years earlier. Upwind concentrations averaged 22 per cent of the downwind concentrations. Feedlot dust concentrations were generally highest in early evening and lowest in early morning. Using the Wedding and Andersen-321A PM-10 samplers, the PM-10 dust concentrations were 19 and 40 per cent, respectively, of mean TSP concentrations in direct comparisons. There was good correlation between PM-10 and TSP concentrations. Although dust concentrations decreased with increasing moisture, the correlation coefficients were relatively low. Odor intensity appeared to increase with decreasing net dust concentrations, perhaps due to moisture influences. Mean particle sizes of feedlot dust were 8.5 to 12.2 microns on a particle volume basis and 2.5 to 3.4 microns on a population basis. Respirable dust (below 2 microns) represented only 2.0 to 4.4 per cent of total dust on a particle volume basis. Under conditions of these experiments, the feedlots often exceeded both state and federal (U.S. Environmental Protection Agency) standards for TSP concentrations and for PM-10 concentrations measured using the Andersen-321A sampler. However, feedlots were below the new U.S. Environmental Protection Agency standards when the Wedding PM-10 sampler was used for measuring dust emissions.

Cotton dust concentrations and particle size distributions associated with genotypes.

The problem of byssinosis has plagued cotton textile mills for hundreds of years, and it is still a problem today. With the regulations on airborne raw cotton dust set by OSHA and the ACGIH, research regarding the measurement of cotton dust in lint fiber is a necessity. A procedure known as the mass concentration particle size distribution (MCPSD) technique, developed at Texas A&M University, was used to measure the characteristics of cotton dust as affected by harvesting method and genotype. Cotton genotypes from three harvest seasons were analyzed by using a Coulter Counter, Model TAII, to obtain the mass concentrations and particle size distributions of dust present in the lint fiber. The genotypes were subjected to both hand harvesting and conventional spindle harvesting for comparison purposes. Results from the dust concentration analyses of particles less than 100 micron, 16 micron, and 8 micron in diameter, respectively, are presented. Also, a proposed procedure to obtain large quantities of "cotton dust" from gin trash material is discussed.

Physical properties of five grain dust types.

Physical properties of grain dust derived from five grain types (soybean, rice, corn, wheat, and sorghum) were measured and reported. The grain dusts were obtained from dust collection systems of terminal grain handling facilities and were assumed to be representative of grain dust generated during the handling process. The physical properties reported were as follows: particle size distributions and surface area measurements using a Coulter Counter Model TAII; percent dust fractions less than 100 micron of whole dust; bulk density; particle density; and ash content.