Alkali-activated geopolymers based on calcined phosphate sludges and metakaolin.

The extraction of phosphorite ore in Tunisia has resulted in the discharge of substantial amounts of phosphatic sludge into the region's water system. To mitigate this environmental issue and prevent heavy metal leaching, a geopolymerization process was employed using two types of Tunisian calcined phosphate sludges (Cal-PS1 and Cal-PS2) as substitutes for alkali-activated metakaolin. This study aimed to investigate and compare the physical and mechanical properties of the resulting geopolymers. The optimal substitution ratio of metakaolin with calcined phosphate sludge was determined to be 1.5, equivalent to 20 wt.% of calcined phosphate sludge. Compressive strength tests conducted after 28 days of curing revealed values of 37 MPa for Cal-PS1 specimens and 28 MPa for Cal-PS2 geopolymers while compressive strength of geopolymers soaked in water for 28 days showed a decrease with the addition of phosphate sludges. The specific surface areas of Cal-PS1 geopolymers ranged from 16.3 to 16.9 m2/g and from 17.62 to 18.73 m2/g for Cal-PS2 specimens exhibiting a mesoporous structure. The elasticity modulus of the geopolymers was found to increase with the increase of the apparent density of geopolymers and with the sludges content but it tended to be lower than the Portland cement elasticity modulus. Leaching test was conducted to evaluate the potential environmental applications of the geopolymers. This test demonstrated effective containment of heavy metals within the geopolymers' network, except for low levels of arsenic.

Investigation of polycyclic aromatic hydrocarbon content in fly ash and bottom ash of biomass incineration plants in relation to the operating temperature and unburned carbon content.

PURPOSE: The use of biomass fuels in incineration power plants is increasing worldwide. The produced ashes may pose a serious threat to the environment due to the presence of polycyclic aromatic hydrocarbons (PAHs), because some PAHs are potent carcinogens, mutagens and teratogens. The objective of this study was to investigate the content of total and individual PAHs in fly and bottom ash derived from incineration of phytomass and dendromass, because the data on PAH content in biomass ashes is limited. Various operating temperatures of incineration were examined and the relationship between total PAH content and unburned carbon in ashes was also considered. METHODS: The analysis of PAHs was carried out in fly and bottom ash samples collected from various biomass incineration plants. PAH determination was performed using gas chromatography coupled with mass spectrometry. The correlations between the low, medium and high molecular weight PAHs and each other in ashes were conducted. The relationship between PAH content and unburned carbon, determined as a loss on ignition (L.O.I.) in biomass ashes, was performed using regression analysis. RESULTS AND DISCUSSION: The PAH content in biomass ashes varied from 41.1±1.8 to 53,800.9±13,818.4ng/g dw. This variation may be explained by the differences in boiler operating conditions and biomass fuel composition. The correlation coefficients for PAHs in ash ranged from 0.8025 to 0.9790. The regression models were designed and the coefficients of determination varied from 0.908 to 0.980. CONCLUSIONS: The PAH content in ash varied widely with fuel type and the effect of operating temperature on PAH content in ash was evident. Fly ashes contained higher amounts of PAHs than bottom ashes. The low molecular weight PAHs prevailed in tested ashes. The exponential relationship between the PAH content and L.O.I. for fly ashes and the linear for bottom ashes was observed.