Palmar plating of distal radius fractures : 3-year follow-up with titanium and PEEK plates give similar outcomes.

A variety of different plate designs and materials are available to treat distal radius fractures. This study evaluates clinical results with a carbon fibre- reinforced (CFR)-polyether ether ketone (PEEK) plate in comparison to a standard titanium plate. Thirty-one distal radius fractures were included in this randomised controlled trial. Five fractures were classified as type A, 6 as type B and 20 as type C, in accordance with the AO classification. Patients were randomly allocated into two groups : 15 patients for titanium palmar plating (TPP) and 16 patients for PEEK palmar plating (PPP). Follow-up examinations were set at 2 weeks, 6 weeks, 3 months, 6 months and 3 years postop. In terms of wrist range of motion, radiological evaluation (alignment and fracture healing), DASH score (Disabilities of Arm, Shoulder and Hand), and VAS (visual analogue scale), no statistically significant differences were detected between the two groups, at all follow-up intervals. PEEK palmar plating and titanium plates give equivalent clinical and radiological outcomes up to 3 years follow-up.

Prediction of Meniscal and Ligamentous Injuries in Lateral Tibial Plateau Fractures Based on Measurements of Lateral Plateau Widening on Multidetector Computed Tomography Scans.

BACKGROUND: The influence of increasing lateral plateau widening on the frequency of meniscal and ligamentous lesions in lateral tibial plateau fractures has been examined in very few studies using plain radiographs. Because the amount of this parameter cannot be measured accurately on plain radiographs, the purpose of this survey was to look for a possible correlation between the extent of lateral plateau widening, as measured on multidetector CT (MDCT) scans, and different soft-tissue injuries determined from magnetic resonance imaging (MRI). MATERIALS AND METHODS: 55 patients with a lateral tibial plateau fracture were included in this retrospective case series. Patient age averaged 52.6 years (SD = 18.0). The degree of lateral plateau widening was measured on CT images. MRIs were screened for meniscal and ligamentous injuries. RESULTS: We found a significant effect of increasing lateral plateau widening on the incidence of lateral meniscus lesions (P = 0.021), lateral collateral ligament tears (P = 0.047), and the overall quantity of meniscal and ligamentous lesions (P = 0.001). DISCUSSION: MRIs are not widely used as a diagnostic tool in lateral plateau fractures of the tibia. Reasons might be the costs and the fact that it is a time-consuming examination. The results of this study may help to estimate the probability of specific soft-tissue lesions in lateral tibial plateau fractures based on measurements of lateral plateau widening on MDCT scans, and they may guide the decision for additional MRI and/or arthroscopically assisted repair.

Accuracy analysis of a novel electromagnetic navigation procedure versus a standard minimally invasive method for arthroscopically assisted acromioclavicular joint reconstructions.

PURPOSE: The aim of this cadaveric study was to evaluate the accuracy, feasibility, and operation time of a novel electromagnetic navigation system (ENS) and procedure for transclavicular-transcoracoid tunnel placement compared with a standard minimally invasive (SMI) reconstruction method for minimally invasive arthroscopically assisted anatomic acromioclavicular joint reconstruction. METHODS: Ten arthroscopically assisted electromagnetic-navigated transclavicular-transcoracoid drilling procedures and 10 SMI procedures were performed on 10 human cadavers using 2 TightRope reconstructions (Arthrex, Naples, FL) for each site. Postoperative computed tomography scans were acquired to determine tunnel placement accuracy. Optimal coracoid tunnel placement was defined according to the anatomic insertions of the trapezoid and conoid ligaments with the oblong button placed in a center-base position at the coracoid undersurface without cortical breach or fracture. Both reconstruction procedures were performed without fluoroscopy. RESULTS: Successful tunnel placement was accomplished in 98.8% using the ENS method and in 83.8% using the SMI procedure (P = .087). The mean overall operation time was 28.5 ± 6.6 minutes for the ENS method and 35.2 ± 3.9 minutes for the SMI method (P = .012). The ENS procedure required no directional readjustments or restarts. Drill misguidance with subsequent cortical breach occurred twice in the SMI group. In both groups no fractures were documented. CONCLUSIONS: In this descriptive laboratory study, both the ENS and the SMI techniques achieved the desired anatomic reconstruction. Compared with the SMI method, the ENS procedure showed higher accuracy, required a shorter operation time, and was associated with no complications. CLINICAL RELEVANCE: Length of surgery, drilling accuracy, and reduction of radiation exposure in acromioclavicular joint reconstruction procedures affect the safety of both patients and surgeons.

Computer-assisted surgery and intraoperative three-dimensional imaging for screw placement in different pelvic regions.

BACKGROUND: The purpose of this study was to assess the feasibility and accuracy of computer-assisted surgery (CAS) for screw placement in different pelvic regions using intraoperative three-dimensional (3D) imaging and to evaluate the influence of surgeons' experience with such a system on procedure time, radiation time, radiation dose, and misplacement rate. METHODS: Experimental study in a human cadaveric model (n=5) for percutaneous screw placement in the anterior column of the acetabulum, the posterior pelvic ring (S1, S2), and the superior pubic ramus via 3D fluoroscopic navigated procedure. Accuracy of screw placement was assessed by 3D image intensifier, including the reconstruction of multiplanar images and by computer tomography (CT) scan. Influence of surgeons' experience was assessed by direct comparison of a low- and high-volume surgeon using the same technical setting. RESULTS: In 100% of all procedures, intraoperative Iso-C3D image analysis was sufficient to confirm a correct screw placement. The postoperative CT scan revealed no further screw misplacement. However, for a correct supraacetabular screw placement, the intraoperative 3D scan was essential. In this group, the 3D scan showed screw misplacement in three cases. Procedure time for all indications and screw failure rate were significantly lower for the higher experienced surgeon. CONCLUSION: The 3D fluoroscopic navigated procedure in pelvic surgery seems to be a useful tool for all surgeons and especially for less experienced ones. Furthermore, the intraoperative reconstruction of multiplanar 3D images allows a secure control of implant positioning.